

ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid dam- aging the cooling unit, especially at the rear near the heat exchanger. The ma- terials used on this appliance marked by the symbol are recyclable.
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insula- tion materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli-

1 Drawer (for storing frozen food and freezing fresh produce) 2 Drawer (for storing frozen food and freezing fresh produce) 3 Drawer (only for storage)

3. The Pilot light will light up and a sound is on only for 2 sec. indicating that the appliance is powered. 4. The Alarm light will blink and the sound signal alarm will get on, indicating that the temperature inside the appliance is too high. 5. Push the Fast Freeze switch and the sound signal alarm will get off. 6. Push the Fast Freeze switch once again and the Fast Freeze light will light up. The freezer will start to operate.
4 Fast Freeze switch Acoustic alarm reset switch 5 Alarm light
Switching on 1. Insert the plug into the wall socket. 2. Turn the Temperature regulator clock- wise to a medium setting.
Environment Protection

Switching off 1. To turn off the appliance, turn the Tem- perature regulator to the "O" position and a sound is on only for 2 sec. 2. The pilot light will switch off.
Fast Freeze function You can activate the Fast Freeze function by pressing the Fast Freeze switch. The Fast Freeze light will light up. It is possible to deactivate the function at any time by pressing Fast Freeze switch. The Fast Freeze light will switch off.
Excessive temperature alarm If the temperature inside the freezer has ris- en to a point where the safe storage of fro- zen food is no longer ensured (for example due to an power failure) the Alarm light will blink and an acoustic alarm will sound. 1. Switch off the warning tone by pressing the Fast Freeze switch. The Fast Freeze light illuminates. The Alarm light blinks until the required temperature has been reached again. 2. The Fast Freeze switch can be released as soon as the Alarm light is off. The Fast Freeze light goes out.
A medium setting is generally the most suitable.
When the freezer is first switched on, the Alarm light blinks until the tempera- ture has dropped to a safe level for the storage of frozen food.
Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accesso- ries with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly.
Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh food activate the Fast Freeze function at least 24 hours before placing the food to be frozen in the freezer compartment. Place the fresh food to be frozen in the two top compartments. The maximum amount of food that can be frozen in 24 hours is specified on the rating plate, a label located on the inside of the appliance.
The freezing process lasts 24 hours: during this period do not add other food to be fro- zen. After 24 hours, when the freezing process is completed, return to the required temper- ature (see "Temperature regulation").
Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings.

Thawing Deep-frozen or frozen food, prior to being used, can be thawed at room temperature. Small pieces may even be cooked still fro- zen, directly from the freezer: in this case, cooking will take longer.
This appliance contains hydrocarbons in its cooling unit; maintenance and re- charging must therefore only be carried out by authorized technicians.
Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0,5 liter of water)
Once a year remove the ventilation grill at the base of the appliance and clean the air

channels with a vacuum cleaner. This oper- ation will improve the performance of the appliance and save electricity consumption.
To remove the frost, follow the instructions below: 1. Turn the Temperature regulator to the "0" setting and disconnect the mains plug from the mains socket. 2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. 3. Leave the door open. 4. Remove the three large drawers. 5. When defrosting is completed, remove the water that has collected in the small bottom drawer and dry the interior thor- oughly. Insert the plug into the wall socket and turn the thermostat control to a medium setting. After let the appliance run for at least two hours in the "Fast Freeze" mode, replace the previously removed food into the com- partments.
Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply.
Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer rea- ches a thickness of about 3-5 mm.
Cleaning the air channels
Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. disconnect the appliance from electrici- ty supply 2. remove all food 3. defrost and clean the appliance and all accessories
Only a qualified electrician or compe- tent person must do the troubleshoot- ing that is not in this manual.

Problem Possible cause Solution
The appliance does not operate. The Pilot light does not flash.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the mains socket correctly.
Connect the mains plug to the mains socket correctly.
The appliance has no power. There is no voltage in the mains socket.
Connect a different electrical ap- pliance to the mains socket. Contact a qualified electrician.
The Pilot light flashes. The appliance is not working properly.
Contact a qualified electrician.
The Alarm light flashes. The temperature in the freezer is too high.
Refer to "Excessive Temperature Alarm"
The acoustic alarm sounds
The temperature in the freezer is too high.
Refer to "Excessive Temperature Alarm"
The door is left open. Close the door.
The compressor oper- ates continually.
The temperature is not set cor- rectly.
Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too frequently.
Do not keep the door open longer than necessary.
The product temperature is too high.
Let the product temperature de- crease to room temperature be- fore storage.
The room temperature is too high.
Decrease the room temperature.
The Fast Freeze function is switched on.
Refer to "Fast Freeze function".
The temperature in the freezer is too low.
The temperature regulator is not set correctly.
Set a higher temperature.
The Fast Freeze function is switched on.
Refer to" Fast Freeze function".
The temperature in the freezer is too high.
The temperature regulator is not set correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high.
Let the product temperature de- crease to room temperature be- fore storage.
Many products are stored at the same time.
Store less products at the same time.
Products are too near to each other.
Store products so that there is cold air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".

Problem Possible cause Solution
The temperature regulator is not set correctly.
Set a higher temperature.
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation".
Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power sup- ply socket is not earthed, connect the appli- ance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not ob- served. This appliance complies with the E.E.C. Di- rectives.
Positioning This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for optimum performance install this appli- ance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appli- ance:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rising Time 29 h
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead

product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information
about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
Problèmes fréquents, causes probables et solutions.
| Problème | Cause possible | Solution | |
|---|---|---|---|
| The appliance does not operate. The Pilot light does not flash. | The appliance is switched off. | Switch on the appliance. | p.7 |
| The appliance does not operate. The Pilot light does not flash. | The mains plug is not connected to the mains socket correctly. | Connect the mains plug to the mains socket correctly. | p.7 |
| The appliance does not operate. The Pilot light does not flash. | The appliance has no power. There is no voltage in the mains socket. | Connect a different electrical ap- pliance to the mains socket. Contact a qualified electrician. | p.7 |
| The Pilot light flashes. | The appliance is not working properly. | Contact a qualified electrician. | p.7 |
| The Alarm light flashes. | The temperature in the freezer is too high. | Refer to "Excessive Temperature Alarm" | p.7 |
| The acoustic alarm sounds | The temperature in the freezer is too high. | Refer to "Excessive Temperature Alarm" | p.7 |
| The acoustic alarm sounds | The door is left open. | Close the door. | p.7 |
| The compressor oper- ates continually. | The temperature is not set cor- rectly. | Set a higher temperature. | p.7 |
| The compressor oper- ates continually. | The door is not closed correctly. | Refer to "Closing the door". | p.7 |
| The compressor oper- ates continually. | The door has been opened too frequently. | Do not keep the door open longer than necessary. | p.7 |
| The compressor oper- ates continually. | The product temperature is too high. | Let the product temperature de- crease to room temperature be- fore storage. | p.7 |
| The compressor oper- ates continually. | The room temperature is too high. | Decrease the room temperature. | p.7 |
| The compressor oper- ates continually. | The Fast Freeze function is switched on. | Refer to "Fast Freeze function". | p.7 |
| The temperature in the freezer is too low. | The temperature regulator is not set correctly. | Set a higher temperature. | p.7 |
| The temperature in the freezer is too low. | The Fast Freeze function is switched on. | Refer to" Fast Freeze function". | p.7 |
| The temperature in the freezer is too high. | The temperature regulator is not set correctly. | Set a lower temperature. | p.7 |
| The temperature in the freezer is too high. | The door is not closed correctly. | Refer to "Closing the door". | p.7 |
| The temperature in the freezer is too high. | The product temperature is too high. | Let the product temperature de- crease to room temperature be- fore storage. | p.7 |
| The temperature in the freezer is too high. | Many products are stored at the same time. | Store less products at the same time. | p.7 |
| The temperature in the freezer is too high. | Products are too near to each other. | Store products so that there is cold air circulation. | p.7 |
| There is too much frost. | Food is not wrapped correctly. | Wrap the food correctly. | p.7 |
| There is too much frost. | The door is not closed correctly. | Refer to "Closing the door". | p.7 |
| The temperature regulator is not set correctly. | Set a higher temperature. | p.8 |
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.