



1 2 3 4 5
1 Power indicator light 2 Temperature regulator 3 FastFreeze light
4 FastFreeze switch and alarm reset switch 5 Alarm light
Connect the appliance to the main power supply.
If the temperature inside the appliance is too high, the Alarm light will blink and the sound signal alarm will turn on. 2. Push the FastFreeze switch and the sound signal alarm will get off. 3. Push the FastFreeze switch once again and the FastFreeze light will light up. The appliance will start to operate.
Turn the Temperature regulator to the "O" position and a sound is on only for 2 seconds . The power indicator light will switch off.
The temperature is regulated automatically.

When the freezer is first switched on, the Alarm light blinks until the temperature has dropped to a safe level for the storage of frozen food.
You can activate FastFreeze function by pressing the FastFreeze switch. The FastFreeze light will light up.
It is possible to deactivate the function at any time by pressing FastFreeze switch. The FastFreeze light will switch off.
If the temperature inside the freezer has risen to a point where the safe storage of frozen food is no longer ensured (for example due to an power failure), the Alarm light will blink and an acoustic alarm will sound.
Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly.
When the freezing process is completed, return to the required temperature (see "FastFreeze Function").
Storage of frozen food
The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.
When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours with the FastFreeze function turned on.
To freeze fresh food activate the FastFreeze function and place the food to be frozen in the freezer compartment.
If large quantities of food are to be stored, remove all drawers from appliance and place food on glass shelf to obtain the best performance.
Place the fresh food to be frozen in the two top compartments.
The maximum amount of food that can be frozen in 24 hours is specified on the rating plate, a label located on the inside of the appliance.
The freezing process lasts 24 hours: during this period do not add other food to be frozen.

The symbols show different types of frozen goods.
In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical data chart under "Rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling).
The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and treating before freezing.
This appliance is equipped with one or more trays for the production of ice-cubes.
Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation.
Do not use metallic instruments to remove the trays from the freezer.
Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer.
HINTS AND TIPS
Normal operating sounds
Hints for freezing
The following sounds are normal during operation:
To help you make the most of the freezing process, here are some important hints:

To obtain the best performance from this appliance, you should:
The equipment has to be cleaned regularly:
This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
The accessories and parts of the appliance are not suitable for washing in a dishwasher.

In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete. 4. When defrosting is completed, dry the interior thoroughly and keep the scraper for future use. 5. Switch on the appliance. After three hours reload the previously removed food into the freezer compartment.
About 12 hours prior to defrosting, set a lower temperature, in order to build up sufficient chill reserve for the interruption in operation.
A certain amount of frost will always form on the freezer shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm.
When the appliance is not in use for long periods, take the following precautions:
What to do if...
Problem Possible cause Solution
The appliance does not oper- ate.
The appliance is switched off. Switch on the appliance.

Problem Possible cause Solution
The mains plug is not con- nected to the mains socket correctly.
Connect the mains plug to the mains socket correctly.
There is no voltage in the mains socket.
Connect a different electrical appliance to the mains sock- et. Contact a qualified electri- cian.
The appliance is noisy. The appliance is not suppor- ted properly.
Check if the appliance stands stable.
Audible or visual alarm is on. The cabinet has been recent- ly switched on or the temper- ature is still too high.
Refer to "Door Open Alarm"or "High Temperature Alarm".
The temperature in the appli- ance is too high.
Refer to "Door Open Alarm"or "High Temperature Alarm".
Power indicator light is flash- ing.
An error has occurred in measuring the temperature.
Contact a qualified electrician or contact the nearest Au- thorized Service Centre.
The appliance is not working properly.
Contact a qualified electrician or contact the nearest Au- thorized Service Centre.
The temperature in the appli- ance is too high.
Contact a qualified electrician or contact the nearest Au- thorized Service Centre.
The compressor operates continually.
Temperature is set incorrect- ly.
Refer to "Operation" chapter.
Many food products to be frozen were put in at the same time.
Wait some hours and then check the temperature again.
The room temperature is too high.
Refer to climate class chart on the rating plate.
Food products placed in the appliance were too warm.
Allow food products to cool to room temperature before storing.
The door is not closed cor- rectly.
Refer to "Closing the door".
There is too much frost and ice.
The door is not closed cor- rectly or the gasket is de- formed/dirty.
Refer to "Closing the door".

Problem Possible cause Solution
The water drainage plug is not correctly positioned.
Position the water drainage plug in the correct way.
Food products are not wrap- ped properly.
Wrap the food products bet- ter.
Temperature is set incorrect- ly.
Refer to "Operation" chapter.
The compressor does not start immediately after press- ing the , or after changing the temperature.
This is normal, no error has occurred.
The compressor starts after a period of time.
The temperature in the appli- ance is too low/too high.
The temperature regulator is not set correctly.
Set a higher/lower tempera- ture.
The door is not closed cor- rectly.
Refer to "Closing the door".
The food products' tempera- ture is too high.
Let the food products tem- perature decrease to room temperature before storage.
Many food products are stor- ed at the same time.
Store less food products at the same time.
The thickness of the frost is greater than 4-5 mm.
Defrost the appliance.
The door has been opened often.
Open the door only if neces- sary.
There is no cold air circula- tion in the appliance.
Make sure that there is cold air circulation in the appli- ance.
If the advice does not lead to the desired result, call the nearest Authorized Service Centre.
Refer to the assembly instructions for the installation.

To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlight etc. Make sure that air can circulate freely around the back of the cabinet.
5 cm min. 200 cm2
This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance:
min. 200 cm2
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre.
The airflow behind the appliance must be sufficient.
Dimensions of the recess
Cli- mate class · Ambient temperature · Height mm 880

Rising time Hours 20
Voltage Volts 230 - 240
The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label.
dispose appliances marked with the symbol
Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not
with the household waste. Return the product to your local recycling facility or contact your municipal office.
Width mm 560 · Depth mm 550 · Frequency Hz 50
Problèmes fréquents, causes probables et solutions.
| Problème | Cause possible | Solution | |
|---|---|---|---|
| The appliance does not oper- ate. | The appliance is switched off. | Switch on the appliance. | p.8 |
| The mains plug is not con- nected to the mains socket correctly. | Connect the mains plug to the mains socket correctly. | p.9 | |
| There is no voltage in the mains socket. | Connect a different electrical appliance to the mains sock- et. Contact a qualified electri- cian. | p.9 | |
| The appliance is noisy. | The appliance is not suppor- ted properly. | Check if the appliance stands stable. | p.9 |
| Audible or visual alarm is on. | The cabinet has been recent- ly switched on or the temper- ature is still too high. | Refer to "Door Open Alarm"or "High Temperature Alarm". | p.9 |
| Audible or visual alarm is on. | The temperature in the appli- ance is too high. | Refer to "Door Open Alarm"or "High Temperature Alarm". | p.9 |
| Power indicator light is flash- ing. | An error has occurred in measuring the temperature. | Contact a qualified electrician or contact the nearest Au- thorized Service Centre. | p.9 |
| Power indicator light is flash- ing. | The appliance is not working properly. | Contact a qualified electrician or contact the nearest Au- thorized Service Centre. | p.9 |
| Power indicator light is flash- ing. | The temperature in the appli- ance is too high. | Contact a qualified electrician or contact the nearest Au- thorized Service Centre. | p.9 |
| The compressor operates continually. | Temperature is set incorrect- ly. | Refer to "Operation" chapter. | p.9 |
| The compressor operates continually. | Many food products to be frozen were put in at the same time. | Wait some hours and then check the temperature again. | p.9 |
| The compressor operates continually. | The room temperature is too high. | Refer to climate class chart on the rating plate. | p.9 |
| The compressor operates continually. | Food products placed in the appliance were too warm. | Allow food products to cool to room temperature before storing. | p.9 |
| The compressor operates continually. | The door is not closed cor- rectly. | Refer to "Closing the door". | p.9 |
| There is too much frost and ice. | The door is not closed cor- rectly or the gasket is de- formed/dirty. | Refer to "Closing the door". | p.9 |
| The water drainage plug is not correctly positioned. | Position the water drainage plug in the correct way. | p.10 | |
| Food products are not wrap- ped properly. | Wrap the food products bet- ter. | p.10 | |
| Temperature is set incorrect- ly. | Refer to "Operation" chapter. | p.10 | |
| The compressor does not start immediately after press- ing the , or after changing the temperature. | This is normal, no error has occurred. | The compressor starts after a period of time. | p.10 |
| The temperature in the appli- ance is too low/too high. | The temperature regulator is not set correctly. | Set a higher/lower tempera- ture. | p.10 |
| The temperature in the appli- ance is too low/too high. | The door is not closed cor- rectly. | Refer to "Closing the door". | p.10 |
| The temperature in the appli- ance is too low/too high. | The food products' tempera- ture is too high. | Let the food products tem- perature decrease to room temperature before storage. | p.10 |
| The temperature in the appli- ance is too low/too high. | Many food products are stor- ed at the same time. | Store less food products at the same time. | p.10 |
| The temperature in the appli- ance is too low/too high. | The thickness of the frost is greater than 4-5 mm. | Defrost the appliance. | p.10 |
| The temperature in the appli- ance is too low/too high. | The door has been opened often. | Open the door only if neces- sary. | p.10 |
| The temperature in the appli- ance is too low/too high. | There is no cold air circula- tion in the appliance. | Make sure that there is cold air circulation in the appli- ance. | p.10 |
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.