Manuel d'utilisation / d'entretien du produit T96695IH du fabricant AEG
Aller à la page of 28
LAVATHERM 96695IH EN User Manual.
CONTENTS 1. SAFETY INFORMATION................................................................................................. 3 2. SAFETY INSTRUCTIONS................................................................................................ 5 3.
1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. • Obey the maximum load volume of 9kg (refer to the “Programme chart” chapter). • Do not use the appliance if industrial chemicals have been used for cleaning.
1.2 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability. • This appliance can be used by children aged from 8 years and above and persons with reduced .
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • Do not touch the mains cable or the mains plug with wet hands. • Only for UK and Ireland. The appliance has a 13 amp mains plug. If it is necessary to change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse.
3. PRODUCT DESCRIPTION 1 2 7 3 4 5 6 9 10 1 1 12 8 1 Water container 2 Control panel 3 Internal light 4 Appliance door 5 Filter 6 The button to open the heat exchanger door 7 Airflow slots 8 Adjustabl.
4. ACCESSORIES 4.1 Stacking kit Accessory name: SKP11, STA8, STA9 Available from your authorized vendor. Stacking kit can be used only with the washing machines specified in the leaflet. See the leaflet attached. Read carefully the instructions supplied with the accessory.
It is available from your authorized vendor (can be attached to some types of the tumble dryers). Do the check with the vendor or on the web site if the accessory is compatible with your appliance.
For accurate selection touch the centre point of the area between the vertical marks. Do not wear gloves when you touch the panel to set the function. Make sure the panel is always clean and dry.
Symbol on the display Symbol description , - anti-crease phase duration: default, interval (30min. - 120min.) - - - - laundry was spun at: 800 — 1800 rpm default Symbol on the display Symbol descrip.
Programmes Load 1) Properties / Fabric mark Jeans 9 kg Leisure clothing such as jeans, sweat-shirts of different material thicknesses (e.g. at the neck, cuffs and seams). / Bed Linen 3 kg To dry bed linen such as: single and double sheet, pillowcase, bed- spread.
Programmes Load 1) Properties / Fabric mark Wool 4) 1 kg To dry the cloths made of wool . The cloths be- come soft and cosy. We recommend to remove the cloths immediately after the programme end. To increase or to decrease the level of the remaining moisture of the laundry you can use the function Dry Plus.
Options Programmes 1) Dry Plus Anti- crease Spun at RPM Time Drying Extra Silent Extra Quick Mixed Synthetics; Extra Dry Synthetics; Cupboard Dry Synthetics; Iron Dry Easy Iron Active Wear Sports Silk/Lingerie Wool 2) 1) Together with the programme you can set 1 or more options.
- the selection to get the laundry lightly dried. - the selection to get the laundry more dried. 7.2 Anti-crease Extends anti-crease phase (30 minutes) at the end of the drying cycle to 90 minutes. This option prevents laundry from creases. Laundry can be removed during the anti-crease phase.
8.2 Clock The first time you turn on the dryer the default time comes into the view on the display. You can confirm or change it. To set the different time: 1. Turn the programme dial to set new hour. 2. Touch the Start/Pause field. The hour is memorised.
• if the Start/Pause field was not touched in the time of 5 minutes. • after 5 minutes from the programme end. Push the On/Off button to turn on the appliance. If the appliance is on, some indications come in to the view on the display. 9.5 Setting a programme Use the programme dial to set the programme.
S e n s i D r y Memory 1 Memory 2 Extra Silent Start/Pause Delay Start Time Dry Buzzer Spun at RPM Dry Plus Anti- crease If the configuration is saved you see the message on the display. To use your own configuration: 3. Turn on the appliance. 4. Touch the Memory 1 or Memory 2 field.
S e n s i D r y Memory 1 Memory 2 Extra Silent Start/Pause Delay Start Time Dry Buzzer Spun at RPM Dry Plus Anti- crease One of the symbols goes into the view on the display: - the maximum dry laundry - the more dry laundry - the standard dry laundry 5.
11. CARE AND CLEANING 11.1 Cleaning the filter At the end of each cycle the symbol Filter is on the display and you must clean the filter. The filter collects the fluff. The fluff occurs while the cloths are dried in the tumble dryer. 1. Open the door.
2. Move the plastic connection out and drain the water into a basin or equivalent receptacle. 3. Move plastic connection in and install water container.
6. If necessary, remove the fluff from the heat exchanger and its compartment. You can use wet cloth and/or a vacuum cleaner with the brush. 7. Close the heat exchanger cover. 8. Lock the blockage until it snaps. 9. Put the filter back. 11.4 Cleaning the drum WARNING! Disconnect the appliance before you clean it.
12. TROUBLESHOOTING Problem 1) Possible cause Remedy The tumble dry- er does not op- erate. The tumble dryer is not connected to mains supply. Connect in at mains socket. Check fuse in fuse box (domestic installa- tion). The loading door is opened. Close the loading door.
Problem 1) Possible cause Remedy Abnormally elapsing time on the display. The time to end is calculated on the basis of the volume and damp- ness of the laundry. The automatic procedure — this is not the appliance malfunction. Programme in- active. The water container is full.
Necessary fuse 13 A Total power 900 W Energy efficiency class A++ Energy consumption 1) 2,28 kWh Annual energy consumption 2) 259 kWh Left—on mode power absorption 0,50 W Off mode power absorption 0.
> 85 0 mm 60 0 mm 60 0 mm 15. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances.
ENGLISH 27.
www.aeg.com/shop 136931100-A-112014.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté AEG T96695IH c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du AEG T96695IH - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation AEG T96695IH, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le AEG T96695IH va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le AEG T96695IH, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du AEG T96695IH.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le AEG T96695IH. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei AEG T96695IH ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
