FR
Notice d'utilisation officielle

Pest Tech Supersonic Flash Repeller

15 pages·164 KB·Jardin et extérieur·PDF·ENITJA
Pest Tech Supersonic Flash Repeller
Table des matières 5 sections Supersonic Flash Repeller manual · ENGLISH - DEUTSCH - NEDERLANDS - FRANÇAIS · Humane solutions for Pest Control · ENGLISH ENGLISH · … AfficherMasquer
Page 1 of the Pest Tech Supersonic Flash Repeller user manual — ENGLISH - DEUTSCH - NEDERLANDS - FRANÇAIS
Page 1 · cliquer pour agrandir
Page 1

Supersonic Flash Repeller manual

ENGLISH - DEUTSCH - NEDERLANDS - FRANÇAIS

Humane solutions for Pest Control

Page 2 of the Pest Tech Supersonic Flash Repeller user manual — ENGLISH ENGLISH
Page 2 · cliquer pour agrandir
Page 2

ENGLISH ENGLISH

Supersonic Flash Repeller with smart mode

Please read and understand these instructions and keep this manual for future reference. This item uses solar power to recharge the battery making sure it is always working. The Passive Infrared sensor (PIR) detects motion and triggers either or both the ultrasonic speaker emitting ultrasonic waves and/or sonic waves. You can also choose to activate the strong LED light flashes, depending on the mode you set. The (ultra)sonic waves and/or light flashes will chase unwanted animals. Sonic button

Dear customer Congratulations on buying our Supersonic Flash Repeller, which will get rid of all kinds of pests in a humane and effective way. Because we want to provide our customers with the best products, we would like to know your opinion on this device. So we and other customers can benefit from your information. Thank you for your trust in us!

Scan Me Step 1: Take your smart phone Step 2: Open your camera app Step 3: Point your camera at the QR code and open the link Step 4: Write your review

Show 7 more labels / short text on this page
Solar panel · off-on · Off-On button · Smart Mode · Frequency button · Sonic UltraSonic · Battery
Page 3 of the Pest Tech Supersonic Flash Repeller user manual — ENGLISH ENGLISH
Page 3 · cliquer pour agrandir
Page 3

ENGLISH ENGLISH

Button “frequency” (right): You can control and adjust the frequency. By turning the knob clockwise, the frequency will be increased. Button “frequency” positions are as below: 0. Off 1. 13.5KHZ - 19.5KHZ To repeal animals such as mice, rats, dogs, foxes and marters. 2. 19.5KHZ - 24.5KHZ To repeal animals such as cats, raccoons, badgers and skunks. 3. 24.5KHZ - 45.5KHZ To repeal animals such as bats, birds, pigeons and rodents. 4. Alarm and strong flashing lights to repel animals such as raccoons, boars and martens. 5. All functions working: mode 1, mode 2, mode 3, and strong flashing lights.

  • Operation
  • The Repeller uses a strong ultrasonic wave and a sonic wave to frighten animals. As soon as an animal enters the range of the PIR Sensor, the waves are activated. Animals will feel uncomfortable and run away.
  • The Repeller also uses a strong flashing LED-light to chase animals away. When animals enter the range of the PIR Sensor, the LED-light will be activated. The strong lights will scare the unwanted animals.

You can choose to use the three options together or just one or two at a time. If you set the timer, the Repeller will be activated every 30 minutes.

Set up Button “sonic” (left): You can adjust the sonic range. By turning the knob clockwise, you increase the strength of the sound and the range of protection.

Timer setting (smart mode) If you turn on the smart mode, the Repeller will be activated every 30 minutes, independent of animals being within the range of the PIR Sensor.

The settings are as follows: 1. Deer 2. Foxes, raccoons and skunks 3. Dogs, squirrels, opossums and chipmunks 4. and 5. Cats, mice, rats and skunks

To Assemble and Install 1. Remove the cover of the battery compartment and install the 3.7 V 18650 2000 mAh lithium battery. Then close the battery compartment (battery included). 2. Place the unit pointed towards the area you want to protect

Page 4 of the Pest Tech Supersonic Flash Repeller user manual — ENGLISH ENGLISH
Page 4 · cliquer pour agrandir
Page 4

ENGLISH ENGLISH

(for example, in a flowerbed or mounted from a wall) 3. Choose a place where the solar panel can catch the sunlight as long as possible. 4. If you place the unit in the ground, insert the spike carefully (first connect the pole sections). Allow 12 centimetres or more of the spike to stick out of the ground. Please be careful not to damage the units, as this will affect the performance. 5. The device can be inserted into the ground, mounted against a wall or you can place the top part directly on a flat surface.

Battery issue warning 1. If the rechargeable batteries are not used for over a month, the battery must be fully released. It is recommended to charge the batteries 3 to 5 hours before regular use. 2. When rainy or cloudy weather lasts for up to a whole week, the device may stop functioning. It is recommended to then switch off the device and recharge the battery. 3. If the battery will not be used for a long time, please replace the battery in the compartment. Remember that the quality of the batteries will affect the capacity and performance of the device. 4. After use, please take your batteries to the recycling centre for used electrical and electronic devices. Consult your local government for more information.

above the ground line

Technical specifications Infrared sensor angle: 120 degrees.

Caution 1. Some humans can pick up parts of the sonic sounds. We, therefore, advise placing the device as far from human living spaces as possible. Do not install the device in an area where children and babies play and sleep. 2. Do not cover up the PIR sensor. 3. To clean the device, use a damp cloth and mild soap with water. Do not use strong chemicals or abrasive cleaning agents as they may damage the device.

Detection range: 8 metres depending on animal size (the bigger the size, the larger the range).

Power supply: solar power 3.7 V 18650 2000 mAh lithium battery rechargeable with solar power or USB-cable.

A green light indicates the unit is activated.

When you charge the device with the USB-cable, the light will turn from red to blue when the battery is fully charged.

figure 1 · figure 2

Poser une question sur : Pest Tech Supersonic Flash Repeller

Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Aucune question pour l'instant sur le Pest Tech Supersonic Flash Repeller

Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.

Document d'origine

Pest Tech Supersonic Flash Repeller manuel PDF

15 pages·164 KB·Jardin et extérieur·PDF
Cliquez sur une page ci-dessus pour l'ouvrir ici
Page 1 / …
100%
Chargement des pages…