



Service
1 Cooking zone 2 Control panel
120/180 mm 120/180 mm
145 mm


Use the sensor fields to operate the appliance. The displays, indicators and sounds tell which functions operate.

1 ON / OFF To activate and deactivate the hob.
To show for which zone you set the time.
9 / - To increase or decrease the time.
The cooking zone is deactivated.
Display Description

- The cooking zone operates.
STOP+GO function operates.
+ digit There is a malfunction.
A cooking zone is still hot (residual heat).
Lock / The Child Safety Device function operates.
Automatic Switch Off function operates.
Heat setting The hob deacti- vates after
, 1 - 2 6 hours
Touch for 1 second to activate or deactivate the hob.
The function deactivates the hob automatically if:
Touch to increase the heat setting. Touch to decrease the heat setting. Touch and at the same time to deactivate the cooking zone.
You can adjust the surface you cook to the dimension of the cookware.
comes on and the hob deactivates. The relation between the heat setting and the time after which the hob deactivates:
Use sensor field:
To activate the outer ring: touch the sensor field. The indicator comes on.
To deactivate the outer ring: touch the sensor field until the indicator goes out.
Display Description · 5 4 hours

STOP+GO
Count Down Timer You can use this function to set how long the cooking zone should operate for a single cooking session.
This function sets all cooking zones that operate to the lowest heat setting.
When the function operates, you cannot change the heat setting.
First set the cooking zone then set the function. You can set the heat setting before or after you set the function.
The function does not stop the timer functions.
To activate the function: touch . comes on.
To set the cooking zone: touch again and again until the indicator of a necessary cooking zone comes on.
To deactivate the function: touch . The previous heat setting comes on.
To activate the function or change the time: touch or of the timer to set the time (00 - 99 minutes). When the indicator of the cooking zone starts to flash slowly the time counts down.
You can lock the control panel while cooking zones operate. It prevents an accidental change of the heat setting.
To see the remaining time: set the cooking zone with . The indicator of the cooking zone starts to flash quickly. The display shows the remaining time.
Set the heat setting first.
To activate the function: touch . comes on for 4 seconds. The Timer stays on.
To deactivate the function: set the cooking zone with and touch . The remaining time counts back to 00. The indicator of the cooking zone goes out.
To deactivate the function: touch . The previous heat setting comes on.
When you deactivate the hob, you also deactivate this function.
When the time comes to an end, the sound operates and 00 flashes. The cooking zone deactivates.
This function prevents an accidental operation of the hob.
To stop the sound: touch .
Minute Minder You can use this function as a Minute Minder when the hob is activated and the cooking zones do not operate (the heat setting display shows ).
To activate the function: activate the hob with . Do not set the heat setting. Touch for 4 seconds. comes on. Deactivate the hob with .
To deactivate the function: activate the hob with . Do not set the heat setting. Touch for 4 seconds. comes on. Deactivate the hob with .
To activate the function: touch . Touch or of the timer to set the time. When the time comes to an end, the sound operates and 00 flashes.
To stop the sound: touch .
To override the function for only one cooking time: activate the hob with . comes on. Touch for 4 seconds. Set the heat setting in 10 seconds. You can
The function has no effect on the operation of the cooking zones.

operate the hob. When you deactivate the hob with the function operates again.
The data in the table is for guidance only.
The bottom of the cookware must be as thick and flat as possible.
Cookware made of enamelled steel and with aluminium or copper bottoms can cause the colour change on the glass- ceramic surface.
- 1 Keep cooked food warm. as neces- sary
Put a lid on the cookware.
Turn halfway through.
as neces- sary

9 Boil water, cook pasta, sear meat (goulash, pot roast), deep-fry chips.
the dirt can cause damage to the hob. Put the special scraper on the glass surface at an acute angle and move the blade on the surface. • Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob with a moist cloth and some detergent. After cleaning, rub the hob dry with a soft cloth.
What to do if...
Problem Possible cause Remedy
You cannot activate or oper- ate the hob.
The hob is not connected to an electrical supply or it is connected incorrectly.
Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram.
The fuse is released. Make sure that the fuse is the cause of the malfunction. If the fuse releases again and again, contact a qualified electrician.
Activate the hob again and set the heat setting in less than 10 seconds.

Problem Possible cause Remedy
You touched 2 or more sen- sor fields at the same time.
Touch only one sensor field.
STOP+GO function operates. Refer to "Daily use" chapter.
There is water or fat stains on the control panel.
Clean the control panel.
An acoustic signal sounds and the hob deactivates. An acoustic signal sounds when the hob is deactivated.
You put something on one or more sensor fields.
Remove the object from the sensor fields.
The hob deactivates. You put something on the
Remove the object from the sensor field.
sensor field .
Residual heat indicator does not come on.
The zone is not hot because it operated only for a short time.
If the zone operated suffi- ciently long to be hot, speak to an Authorised Service Centre.
You cannot activate the outer ring.
Activate the inner ring first.
It is normal that there is a dark area on the multiple zone.
There is a dark area on the multiple zone.
The sensor fields become hot.
The cookware is too large or you put it too near to the controls.
Put large cookware on the rear zones if possible.
comes on. Automatic Switch Off oper- ates.
Deactivate the hob and acti- vate it again.
comes on. The Child Safety Device or the Lock function operates.
Refer to "Daily use" chapter.
and a number come on. There is an error in the hob. Disconnect the hob from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again.
If comes on again, speak to an Authorised Service Centre.
If you cannot find a solution...
from the rating plate. Give also three digit letter code for the glass ceramic (it is in the corner of the glass surface) and an error message that comes on. Make sure, you operated the hob correctly. If not the
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Give the data

servicing by a service technician or dealer will not be free of charge, also during the warranty period. The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet.
Stick the adhesive labels as indicated below:
MOD.
MOD.
MOD. PROD.NO. SER.NO.
PROD.NO.
PROD.NO.
SER.NO
03 IT
DATA
DATA
MADE IN ITALY
A) Stick it on Guarantee Card and send
C) Stick it on instruction booklet.
this part (if applicable). B) Stick it on Guarantee Card and keep
this part (if applicable).
and work surfaces that align to the standards.
Before the installation
Before you install the hob, write down the information bellow from the rating plate. The rating plate is on the bottom of the hob.
Model PNC Serial number
Only use the built-in hobs after you assemble the hob into correct built-in units

edge of the glass ceramic. Do not extend it. Make sure that the ends of the seal stripe are located in the middle of one side of the hob. 3. Add some mm when you cut the seal stripe to the length.



Modell PAS3000E PNC 949 738 694 01 Typ 58 HED D2 KO 220 - 240 V 50 - 60 Hz Ser.Nr 2.9 kW PROGRESS
Cooking zone Nominal Power (Max heat set-
ting) [W] Cooking zone diameter [mm]
Middle front 1200 145
Middle rear 700 / 1700 120 / 180
For optimal cooking results use cookware not larger than the diameter of the cooking zone.
Type of hob Built-In Hob
Number of cooking zones 2
Heating technology Radiant Heater
Model identification PAS3000E

Diameter of circular cooking zones (Ø)
Middle front Middle rear
14.5 cm 18.0 cm
Energy consumption per cooking zone (EC electric cooking)
Middle front Middle rear
202.3 Wh / kg 177.7 Wh / kg
Energy consumption of the hob (EC electric hob)
190.0 Wh / kg
EN 60350-2 - Household electric cooking appliances - Part 2: Hobs - Methods for measuring performance
You can save energy during everyday cooking if you follow below hints.
Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not
dispose appliances marked with the symbol
with the household waste. Return the product to your local recycling facility or contact your municipal office.
Problèmes fréquents, causes probables et solutions.
| Problème | Cause possible | Solution | |
|---|---|---|---|
| You cannot activate or oper- ate the hob. | The hob is not connected to an electrical supply or it is connected incorrectly. | Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram. | p.9 |
| You cannot activate or oper- ate the hob. | The fuse is released. | Make sure that the fuse is the cause of the malfunction. If the fuse releases again and again, contact a qualified electrician. | p.9 |
| You cannot activate or oper- ate the hob. | Activate the hob again and set the heat setting in less than 10 seconds. | p.9 | |
| You touched 2 or more sen- sor fields at the same time. | Touch only one sensor field. | p.10 | |
| STOP+GO function operates. | Refer to "Daily use" chapter. | p.10 | |
| There is water or fat stains on the control panel. | Clean the control panel. | p.10 | |
| An acoustic signal sounds and the hob deactivates. An acoustic signal sounds when the hob is deactivated. | You put something on one or more sensor fields. | Remove the object from the sensor fields. | p.10 |
| The hob deactivates. | You put something on the sensor field . | Remove the object from the sensor field. | p.10 |
| Residual heat indicator does not come on. | The zone is not hot because it operated only for a short time. | If the zone operated suffi- ciently long to be hot, speak to an Authorised Service Centre. | p.10 |
| You cannot activate the outer ring. | Activate the inner ring first. | p.10 | |
| There is a dark area on the multiple zone. | It is normal that there is a dark area on the multiple zone. | p.10 | |
| The sensor fields become hot. | The cookware is too large or you put it too near to the controls. | Put large cookware on the rear zones if possible. | p.10 |
| comes on. | Automatic Switch Off oper- ates. | Deactivate the hob and acti- vate it again. | p.10 |
| comes on. | The Child Safety Device or the Lock function operates. | Refer to "Daily use" chapter. | p.10 |
| and a number come on. | There is an error in the hob. | Disconnect the hob from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again. If comes on again, speak to an Authorised Service Centre. | p.10 |
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.