

heating elements. Children less than 8 years of age shall be kept away unless continuously supervised.



1 Cooking zone 2 Control knobs
Residual heat
To set or change the heat setting turn the knob to the correct heat setting. To deactivate turn the knob to off position.
Heat set- ting:
Application:
The bottom of the cookware must be as thick and flat as possible.
Cookware made of enamelled steel and with aluminium or copper bottoms can cause the colour change on the glass- ceramic surface.
4 Frying / browning
5 Bringing to the boil

Heat set- ting:
Application:
6 Bringing to the boil / quick frying / deep-frying
What to do if...
Problem Possible cause Remedy
You cannot activate or oper- ate the hob.
The hob is not connected to an electrical supply or it is connected incorrectly.
Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram.
The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.
If you cannot find a solution...
Authorised Service Centre. Give the data from the rating plate. Give also three digit letter code for the glass ceramic (it is in the corner of the glass surface). Make sure, you
If you cannot find a solution to the problem yourself, contact your dealer or an

operated the hob correctly. If not the servicing by a service technician or dealer will not be free of charge, also during the warranty period. The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet.
Stick the adhesive labels as indicated below:
MOD.
MOD.
MOD. PROD.NO. SER.NO.
PROD.NO.
PROD.NO.
SER.NO
03 IT
DATA
DATA
MADE IN ITALY
A. Stick it on Guarantee Card and send
C. Stick it on instruction booklet.
this part (if applicable). B. Stick it on Guarantee Card and keep
this part (if applicable).
Only use the built-in hobs after you assemble the hob into correct built-in units and work surfaces that align to the standards.
Before you install the hob, write down the information bellow from the rating plate. The rating plate is on the bottom of the hob.
Model PNC Serial number

the seal stripe are located in the middle of one side of the hob. 3. Add some mm when you cut the seal stripe to the length. 4. Push the two ends of seal stripe together.




If several 30 cm hobs are to be installed side by side into the same cut out, an assembly kit including a support side bracket and supplementary seals is available at our Authorised Service Centres. The relevant installation instructions are supplied within the kit package.


For optimal cooking results use cookware not larger than the diameter of the cooking zone.

Type of hob Built-In Hob
Number of cooking zones 2
Heating technology Radiant Heater
Diameter of circular cooking zones (Ø)
Middle front Middle rear
14.5 cm 18.0 cm
Energy consumption per cooking zone (EC electric cooking)
Middle front Middle rear
183.8 Wh / kg 182.4 Wh / kg
Energy consumption of the hob (EC electric hob)
183.1 Wh / kg
EN 60350-2 - Household electric cooking appliances - Part 2: Hobs - Methods for measuring performance
You can save energy during everyday cooking if you follow below hints.
Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not
dispose appliances marked with the symbol
with the household waste. Return the product to your local recycling facility or contact your municipal office.
Model identification PAS3100E
Problèmes fréquents, causes probables et solutions.
| Problème | Cause possible | Solution | |
|---|---|---|---|
| You cannot activate or oper- ate the hob. | The hob is not connected to an electrical supply or it is connected incorrectly. | Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram. | p.6 |
| You cannot activate or oper- ate the hob. | The fuse is blown. | Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. | p.6 |
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.