FR
Dimplex logo
Notice d'utilisation officielle

Dimplex Bartok

36 pages·2.8 MB·Cheminée·PDF·ENJA
Dimplex Bartok
Table des matières 14 sections Portastove Range · Important Safety Advice · This instructions can be found at · www.Dimplex.co.uk · … AfficherMasquer
Page 1 of the Dimplex Bartok user manual — R
Page 1 · cliquer pour agrandir
Page 1

R

Dimplex Bartok — R diagram (page 1)
Fig. 1
Dimplex Bartok — R diagram (page 1)
Fig. 2
Dimplex Bartok — R diagram (page 1)
Fig. 3
Dimplex Bartok — R diagram (page 1)
Fig. 4
Dimplex Bartok — R diagram (page 1)
Fig. 5
Dimplex Bartok — R diagram (page 1)
Fig. 6
Dimplex Bartok — R diagram (page 1)
Fig. 7

08/52860/0 (MULTI) Issue 0

The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC

Page 2 of the Dimplex Bartok user manual
Page 2 · cliquer pour agrandir
Page 2
Dimplex Bartok diagram (page 2)
Fig. 8
Page 3 of the Dimplex Bartok user manual
Page 3 · cliquer pour agrandir
Page 3
Dimplex Bartok diagram (page 3)
Fig. 9
Dimplex Bartok diagram (page 3)
Fig. 10
Dimplex Bartok diagram (page 3)
Fig. 11
Page 4 of the Dimplex Bartok user manual — Electrical Connection
Page 4 · cliquer pour agrandir
Page 4

Portastove Range

Important Safety Advice

The appliance must be positioned so that the plug is accessible. Although this appliance complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs. If the supply cord is damaged it must be replaced by the manufacturer or service agent or similarly qualified person in order to avoid a hazard. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. This appliance is not equipped with a device to control the room. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided. CAUTION - Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: If the appliance is damaged, check immediately with the supplier before installation and operation. Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool. Do not use outdoors. This appliance must not be located immediately above or below a fixed socket outlet or connection box. WARNING: The appliance carries the Warning Symbol indicating that it must not be covered or has a Do not cover label. Do not cover or obstruct in any way the heat outlet grille located underneath the appliance Overheating will result if the appliance is accidentally covered. Do not place material or garments on the appliance, or obstruct the air circulation around the appliance, for instance by curtains or furniturn, as this could cause overheating and a fire risk. In the event of a fault unplug the heater. Unplug the appliance when not required for long periods.The supply cord must be placed on the right hand side of the heater away from the heat outlet underneath the appliance. This appliance can be used by children aged form 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experinence and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintaince shall not be made by Children without supervision. Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understanding the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintaince.

This instructions can be found at

www.Dimplex.co.uk

General Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the fire to your supplier. The fire incorporates a flame effect, which can be used with or without heating, so that the comforting effect may be enjoyed at any time of the year. Using the flame effect on its own only requires little electricity. These products are designed to be freestanding and are normally positioned aainst a wall. Before connecting the heater check that the supply voltage is the same as that stated on the heater. Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is related to the operation of the flame effect. This is normal and should not be a cause for concern.

Electrical Connection

Page 5 of the Dimplex Bartok user manual — }
Page 5 · cliquer pour agrandir
Page 5

Controls - see Fig. 2

Remote control - see Fig. 7 The maximum range of use is ~ 10metres/32.8 ft. The buttons on the remote control have the same functions as the switches on the heater. For detailson the funstions please refer to the ‘Controls’ section in this leaflet. Warning: It takes time for the receiver to respond to the transmitter. Do not press the buttons more than once within two seconds for correct operation.

O/I Switch Main ON/OFF Note: This switch must be pressed before the unit will operate with or without heat.

- Switch Flame Effect. Note: This controls the flame effect option. This switch must be pressed before the heater will operate with heat.

Battery Information - see Fig. 7

- Switch Cold Blow Function. Note: This switch must be pressed before the ‘Heat Selection’ switch operates.

1. Slide open the battery cover on the back of the remote control. 2. Install two AAA batteries into the remote control, being careful to insert the battery as indicated in the battery compartment of the handset. 3. Replace the battery cover.

- Switch Heat Selection. Provides 1 kW and 2 kW heat output thermostatically controlled. Press button once for 1kW & twice for 2kW output. if button is pressed a third time the heater reverts to ‘Cold Blow’ mode.

Discard Leaking Batteries

Dispose of batteries in the proper manner according to provincial and local regulations. Any battery may leak electrolyte - if mixed with a different battery type, - if inserted incorrectly, - if all the batteries are not replaced at the same time, - if disposed of in a fire, - if an attempt is made to charge a battery not intended to be recharged.

- Switch Runback Timer. The timer provides 15 individual time settings. Each time the button is pressed the heater is programmed to run for 30 minutes,e.g. 1 press = 0.5hour, 2 presses = 1hour, etc. This means the heater can be programmed to run for between 0.5 and 7.5 hours.

Disposal of Used Batteries.

Batteries may contain hazardous substances which could be endangering to the environment and human health. The symbol marked on the battery and /or packaging indicates that used batteries should not be treated as municipal waste. Instead they should be left at the appropriate collection point for recycling. By ensuring used batteries are disposed of correctly, you will help to prevent potential negative consequences on the environment and human health. The recycling of materials will help to conserve natural resources. For more information please contact your local authority.

Thermostat (T) - see Fig.2 In order to maintain a certian room temperature, set the controller to ‘max’. Operate the heater at full power until the required room temperature ie reached. Turn back the thermostat control knob until the heater turns off with an audiable ‘click’. This temperture will be kept almost constant by the thermostatic control switching ON and OFF automatically. Please note that the appliance can only be switched ON when the thermostat setting is higher than the room temperature.

Flame Control Knob (F) - see Fig.2 By using the flame control knob, the brightness of the flame effect can be adjusted. At min. setting (indicated by the small bulb) the brigthness of the flame effect will be lowest. Clockwise rotation of the knob will increase the intensity of the flame effect.

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance automatically in the event of a fault! Switch off the appliance or disconnect the mains plug from the socket. Remove any obstructions which may have caused the overheating. After a short cooling down phase, the appliance is ready for use again! If the fault should occur again, see your local dealer! WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

LED Indicators - see Fig.6 Red LED’s (Neons) will be visable on the right side of the heater glass window indicating the selected funstion. For Example when 1kW heat is selected, you will wee the ON/ OFF - LED and the 1kW LED illuminated, or for another example, if the run back timer is set to6.5 hours the first, second and the fourth LED of the timer indicators will be illuminated (4 hours + 2 hours = 0.5 hours = 6.5 hours)

Maintenance

2 kW heat 1 kW heat Cold Blow Function

}

4 hours 2 hours

0.5 hour 1 hour Timer Indicators only

On/Off

Page 6 of the Dimplex Bartok user manual — After Sales Service
Page 6 · cliquer pour agrandir
Page 6

Lamp Replacement - see Fig.3, Fig.4 and Fig.5

Recycling

The lamps are located behind the back panel. To gain access to the lamps, the screws indicated in Fig. 3 which secure the back panel, must be removed. Remove and slide out panel as indicated on Fig. 4. Remove the defective lamp by unscrewing it as shown in Fig. 5. Replace with a 60W E14 SES Clear candle lamp. Take care not to over-tighten the lamp. Refit the back panel and secure with the screws.

For electrical products sold within the European Community. At the end of the electrical products useful life it should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice in your country.

After Sales Service

Cleaning

Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge (excluding lamps & subject to availability) provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee. Should you require after sales information or assistance with this product please go to www.dimplex.co.uk where you will find our self help guide by clicking on “After Sales” or ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.) . Spare parts are also available on the website www.dimplex.co.uk Please retain your receipt as proof of purchase.

For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners. To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater.

Sources

Références et liens

Pages mentionnées dans ce manuel — fabricant, assistance et téléchargements.

Poser une question sur : Dimplex Bartok

Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Aucune question pour l'instant sur le Dimplex Bartok

Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.

Document d'origine

Dimplex Bartok manuel PDF

36 pages·2.8 MB·Cheminée·PDF
Cliquez sur une page ci-dessus pour l'ouvrir ici
Page 1 / …
100%
Chargement des pages…