Manuel d'utilisation / d'entretien du produit WDI147 du fabricant Smeg
Aller à la page of 34
WASHER-DRYER INSTRUCTION MANUAL EN.
1 EN Contents 1. Precautions for safety and use 2 2. Installation instructions 5 3. Description of controls 8 4. Using the appliance for washing 9 5. Using the appliance for drying 17 6.
EN 2 READ THE INSTRUCTIONS Attention! You are ad vised to read all the instruct ions in this manual carefully; it w ill inform you about the right conditions for the proper, safe use of your washer-dryer It is very important to keep this instruction manual with the appliance for future reference.
EN 3 The appliance is onl y disconnected from the electricit y supply if the plug ha s been removed from the so cket o r the electrical system ma ster switch has been turned off. The pow er pl ug must be accessible after the appliance ha s been installed.
EN 4 Fabric sof teners, or sim ilar products, should be use d as specified by the f abric softener instru c- tions. The f inal part of a tumble dryer c ycle occurs without heat (cool down c yc.
EN 5 2. INSTA LLATION INSTRUC TIONS Important! The appliance must be installed by a qualified e ngineer i n compliance with the relevant regulations. The washer-dryer is heavy.
EN 6 2.2 POSITION ING AND LEVELLING 1. Place the appliance i n the chosen position. 2. Level the appliance carefully in all di rections with the aid o f a spirit level, adjust ing the height of the feet if necessary. Once do ne, fix the feet i n place with th e locknuts pr o- vided.
EN 7 2.3 CONNEC TING TO THE WATER SUP PLY 1. Check that the water supply p ressure is in the following range: 0,05-0,9MPa . W ith higher pressures, use a pressure reducer. 2. Connect the cold water su pply hos e ( blue screw collar) to the cold water tap with ¾ gas threaded connector, taking care to tighten fi rmly to prevent leaks.
EN 8 3. DESCRIPTION OF CONTR OLS 3.1 CONT ROL PANEL All the appliance's control and monitoring devices are placed together on the front pan el. Programme Selector For switching the was her-dr yer on and off and selecti ng pr o- gramm es. Can be turned in e i- ther direction.
EN 9 4. USING THE APPLIA NCE FOR WASHING 4.1 PREPA RING THE ITEMS F OR WASH ING 1. Subdivide the items for washing by fabric type and colour fastness. 2. Wash white and col oured items separately. New c oloured i tems should be washed separately the fi rst ti me.
EN 10 4.4 LOAD ING THE ITEMS FOR WASHING 1. Open the door an d load the laundry, distributing it e venly over the drum, with items opened out and not bundled together; if possible, large and small items should be w ell mixed. 2. The washing machine c overed by this manual c an be loaded w ith up to 7 kg of l aundry for each wash.
EN 11 4.6 POWDER DE TERGENT DOSES Laundry with normal dirt 1. Choose a programme without prewash. 2. Pour the total amount of detergent shown on the pack into the mai n was h compartment of th e detergent dr awer. Very dirty la undry 1. Choose a programme with prewash.
EN 12 4.10 SWITC HING ON THE A PPLIANCE A ND SELECTIN G THE WASHING PRO GRAMME To switch on the appliance and select the programme, proce ed as follows: 1. Turn the programmes knob in either direction. This sw itches on the washer -dryer. 2. Select the washing programme.
EN 13 4.11 SELECT ING AND CONFIRM ING OPTIONS 1. The Option Selection button can be used to select the follow ing options in sequence (from the top down): Prewash : adds a stage before the main wash, lasting about 20 minutes at a temperature of 3 5°C.
EN 14 4.12 TIME T O END 1. The Time to End key c an be pressed repeatedly to select the time after which the w ashing programme will end. The time to end of cycle function calculates the i nitial dura.
EN 15 4.14 INTE RRUPTING OR CHA NGING THE WASHING PROGRA MME The washing programme in progress can be interrupted at any moment: 1. press the “Start/Pause” but ton for about 3 seconds: the display shows the word PAUS (for 1 se cond) a l- ternating with the time re maining until the end of the cycle (for 1 second ).
EN 16 4.17 OPENING THE APPLIA NCE IN A N EMERGENCY In the event of a power failure, th e door is opened using the mechanical release device activated by means of the l ever in the bottom of the appliance: Turn th e k nob to Off and disconnect the power supply plug from the socket.
EN 17 5. USING THE APPLIA NCE FOR DRYING 5.1 GENERA L During drying cycles, the water tap must be turned on and the drain hose correctly position ed. This appliance can be set to perform wash only, dry only and wash- and -dry programmes.
EN 18 5.2 WAS H- A ND-DRY PROGRA MME Automatic washing and drying can be carried out in the tough fabrics (cotton an d colours) an d synthetic/delicate fabrics programmes. If the wool wash programmes are selected, automatic drying after the w ash c annot be set.
EN 19 5.5 CLEAN PROGRA MM E To k eep the a ppliance operating at peak e fficiency over time, it has a CLEAN programme for regular cleaning of the drying circuit to remove any fluff deposits. 1. After a given n umber of drying cycles, the C LEAN symbol lights up on the display to warn that this pr o- gramme needs to be ru n.
EN 20 6. CLEAN ING AND MA INTENANCE Important – Before carrying out any clea ning or maintenance procedure, the plug must be disconnected from the power supply socket. 6.1 CLEAN ING THE OUT SIDE OF THE A PPLIANCE Regular, thorough cleaning will keep your appliance looking good.
EN 21 3. Extract the drain hose ”A”. W ar ning: if the hose is hot, the water is hot or boiling hot. Place a shallow container on the flo or and remove the plug “B” to drain off the water. Depending o n the a mount of water in the appliance, the contai ner may ha ve to be emptied several times.
EN 22 7. TROUBLESHO OTING This produce complies with the rele vant regulations governing the safety o f electrical equipment. Fo r s afety re a- sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user.
EN 23 11 Appliance does not spin Anti-imbalance safety devic e tripped because laundry no t evenly distri b- uted i n drum. If laundry is still wet at end of cycle, rearrange it in the drum by hand and repeat spin programme only.
PROGRAM GUIDE Programs Temp. (°C) Max. Spin (rpm) Max. washing load (kg) Max. drying load (kg) Prewash Wash Softner Prewash Intensive Easy Ir on Extra rinse Flexi time Drying after wash if selected W.
ISTRUZIONI DI MONTA GGIO DELLE LA VA T RICI INTEGRA BILI IT A SSEMBLY INST RUCT IONS FOR BUILT-IN WA SHING MA CHINES EN MONTA GEA NLE ITUNG FÜR EINBA UB A RE- WA SCHMA SC HINEN DE INSTRU CTIONS DE MO.
4 A SSEMBLY I NST RUCTIONS FOR BUILT-IN WA SHING M A - CHINES IMPORTANT - This machine compli es with current safety regu lations govern- ing electrica l appliances an d, to ensure user safety , it mu.
5 Place the temp late of the inner side o f the p anel an d matc h the height of the base board with the lower edge of the p anel ( fig. 4 ) using the grad uated s cale. Make sure the template is horizon- tally centre d with reference to the vertical li nes mark ed at the ends.
6 impossibl e to touch li ve components and a tool m ust be required to rem ove it. Our comp any declines all liabil ity for failure to observe the above safety requirem ent. Apply ing the baseboard It m ust be po ssible to remove the continu ous kitc hen bas eboard to allow the d rain pum p to be cl eaned if necess ary.
c a . 82 kg 820mm 1 6 m m 5 6 0 m m 5 9 6 m m 1 5 0 m m 5 8 m m 820mm ! ! ! ! 1 9 A B 2.
2 2 3 3 12 12 1 1 11 7 7 1 0 10 8 8 9 9 2 2 1 1 3 3 4 4 6 6 5 5 4 5 4 1 1 2 3 2 3 C C 6 6 5 5 7 7 8 8 C A B - A B - C 9 D D 2 2 1 1 3 3 4 4 A B 3- A 3-B 3.
Ø2mm Ø2mm 13mm 13mm 16. ..21 mm Ø 35mm Ø35mm 13mm 13mm 592...595mm 16 ... 21m m 592...595mm e e e e e e e e Unterkante Lower edge C ôté inférieur Lato inferiore Lado inferior Onderkant.
1 1 2 2 3 3 1 1 2 2 3 3 1 1 ? 7 8 9 2 1 2 4 3 5 6.
9 10 1 1.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Smeg WDI147 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Smeg WDI147 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Smeg WDI147, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Smeg WDI147 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Smeg WDI147, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Smeg WDI147.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Smeg WDI147. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Smeg WDI147 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
