Manuel d'utilisation / d'entretien du produit HGC5X du fabricant Hobart
Aller à la page of 24
701 S. RIDGE AVENUE TROY, OHIO 45374-0001 937 332-3000 www.hobartcorp.com FORM 34312 Rev. E (Apr. 2005) DGC5 & HGC5 SERIES GAS CONVECTION OVENS MODELS DGC5 ML-126614 HGC5 ML-126615 HGC5X ML-126618.
– 2 – IMPOR T ANT FOR Y OUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED.
– 3 – Installation, Operation and Care of DGC5 & HGC5 SERIES GAS CONVECTION O VENS SA VE THESE INSTR UCTIONS FOR FUTURE USE GENERAL Hobart DGC5 & HGC5 S eries Gas Convection Ovens are produced with quality workmanship and material.
– 4 – INST ALLA TION Before installing, verify that the electrical service and type of gas supply (natural or L.P. gases) agree with the specifications on the rating plate, located behind the top trim panel on the front of the oven. If the supply and equipment requirements do not agree, do not proceed with the installation.
– 5 – In Canada: 1 . Local codes. 2 . CSA B149.1 Natural Gas and Propane Installation Code. 3 . STANDARD C22.1 Canadian Electric Code (latest edition). 4 . CSA C22.1 Canadian Electric Code (latest edition). 5 . CSA C22.2 No. 3 Canadian Electric Code (latest edition).
– 6 – Assembling the Legs to the Oven The legs must be installed on the bottom of the oven. Gently position the oven on its side, taking care not to scratch or damage it. Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers (six per leg).
– 7 – LEVELING Ensure that the oven racks are level in the final installed position. If the oven is installed on legs, turn the adjustable feet in or out to level the oven front-to-back and side-to-side. If the oven is installed on casters, loosen set screws and turn casters in or out to level the oven front-to-back and side-to-side.
– 8 – VENT SYSTEM Do not obstruct the flow of flue gases from the flue located on the rear of the oven. It is recommended that the flue gases be ventilated to the outside of the building through a ventilation system installed by qualified personnel.
– 9 – A T A D L A C I R T C E L E s l e d o MH P / z H / V y t i c a p m A t i u c r i C m u m i n i M e c i v e D e v i t c e t o r P m u m i x a M S P M A , 5 C G D , X 5 C G H , 5 C G H X D 5 C.
– 10 – OPERA TION WARNING : THE APPLIANCE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING OR PERFORMING ANY MAINTENANCE. CONTROLS (Models DGC5, HGC5 and HGC5X — Without Cook & Hold).
– 11 – CONTROLS (Models DGC5, HGC5 and HGC5X — With Cook & Hold) OFF 150 150 225 250 275 300 325 350 375 200 400 425 450 250 475 500 F 100 C POWER OFF HEAT ON IGNITION COOK TEMPERA TURE COOL.
– 12 – BEFORE FIRST USE Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating the new surfaces in the chamber. 1 . Using a clean, damp cloth, wipe the inside of the oven including the racks.
– 13 – Cook & Hold (When Equipped) 1 . Turn the oven ON. 2 . Set the oven Cook Temperature to the desired setting. 3. Position the Function switch to C & H. 4. Set the Cook & Hold Time to the desired Cooking time. • The oven will roast the product for the chosen set time and temperature.
– 14 – PROGRAMMABLE CONTROLS (Models HGC5D AND HGC5DX) Always displays [HR:Min] when setting the time. Displays [HR:Min] if the countdown time is more than 1 hour. Displays [Min:Sec] if the countdown time is less than 1 hour. Displays temperature in °F.
– 15 – MANUALLY SETTING THE TEMPERATURE AND COOK TIME To Set the Temperature 1. Press the SET button. Press the TEMPERATURE button; StPt displays to indicate Setpoint. 2. Use the Up and Down arrow keys to increase or decrease the displayed temperature value.
– 16 – Always Set the Temperature Before Setting the Time 1. Open the door; door will display. 2. Place the desired product on any of the five racks. 3. Close the door. The display should return to the set temperature or the GROWING BAR . 4. Press the MENU key once for primary or twice for secondary to select a menu item cook time.
– 17 – SETTING THE OVEN FOR COOK & HOLD 1. Press the COOK & HOLD button to select cook & hold. 2. Set the first stage temperature and the cook time as described in MANUALLY SETTING THE TEMPERATURE AND COOK TIME. Press START/STOP to begin cooking.
– 18 – RACK ARRANGEMENTS All models are supplied with five racks and have a maximum operating capacity of six racks per oven. The 11-position rack supports provide for maximum flexibility and proper rack spacing. The following arrangements are recommended.
– 19 – RECOMMENDED TEMPERATURES AND TIMES FOR ROASTING Meat roasting is most satisfactory at temperatures of 225 to 325°F (107 to 163°C) for beef, lamb, poultry and ham; 325°F (163°C) for fresh pork as recommended by USDA and American Meat Institute.
– 20 – RECOMMENDED TEMPERATURES, TIMES AND NUMBER OF RACKS FOR BAKING TEMP. TIME IN NO. OF PRODUCT °F (°C) MINUTES RACKS Cakes Sheet Cakes 18 x 26 x 1" (45.7 x 66.0 x 2.5 cm) pan Scaled 4 1 / 2 to 6 lb (2 to 2.7 kg)/pan 325-360 (163-182) 20 to 23 5 Scaled 6 to 7 1 / 2 lb (2.
– 21 – TEMP. TIME IN NO. OF PRODUCT °F (°C) MINUTES RACKS Yeast Breads NOTE: Yeast breads should be fully proofed for best results. Rolls — 1 oz 350-400 (177-204) 5 to 10 4 3 1 1 / 2 to 2 1 / 2 oz 350-400 (177-204) 8 to 15 4 3 Loaf Bread — 1 lb (453.
– 22 – TEMP. TIME IN NO. OF PRODUCT °F (°C) MINUTES RACKS Fish Sticks & Portions Frozen Breaded — 1 oz 350-400 (177-204) 6 to 10 4 2 to 3 2 1 / 2 to 3 oz 350-375 (177-191) 8 to 15 4 2 to 3 Chicken Pieces Broiled or Oven Fried 2 to 2 1 / 2 lb (0.
– 23 – CLEANING WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES. Allow the oven to cool before cleaning. Heat Circulation Tube The heat circulation tube, located in the back of oven cavity, should never be blocked.
– 24 – TROUBLESHOOTING m e l b o r Pe s u a C e l b i s s o Pn o i t c A e v i t c e r r o C d e t s e g g u S g n i n w o r b n e v e n U d e k o o c r e v o r o . s e g d e . 1 . 2 . t o h o o t s i n e v O . d e s u s k c a r y n a m o o T . 1 .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Hobart HGC5X c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Hobart HGC5X - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Hobart HGC5X, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Hobart HGC5X va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Hobart HGC5X, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Hobart HGC5X.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Hobart HGC5X. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Hobart HGC5X ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
