Manuel d'utilisation / d'entretien du produit DOCSIS Cable Modem du fabricant Cables to Go
Aller à la page of 33
DOCSIS Cable Modem User Guide Rev . 6.1.
.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem FCC Statement This device complies with Class B Part 15 of the FCC Rules. The device generates, uses and can radiate radio frequency energy a nd, if not installed and used as instructed, may cause harmful interference to radio communication.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Table of Content FCC S TATEMENT ......................................................................................................................... I W ARRANTY ..............................................
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Chapter 1 Introduction This chapter provides an introduction to the DOCSIS 1.0/1.1 equivalent Cable Modem User Guide . In addition, this chapte r provides a general desc ription of the Cable Modem’ s product features.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 1.3 Features DOCSIS 1.0/ DOCSIS 1.1 equivalent Ethernet 10Base-T/100Base-TX(A-MDIX)or USB (optional) Interface for easy i.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem cause fire, electrical shock, or damage to the equipment. • When installing the CABLE MODEM, be sure to observ e the anti-static caution in the installation section of this user ’ s gui de. This will prevent damage to the board and other components.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Chapter 3 Hardware Installation This chapter describes the proper steps fo r connecting your new Cable Modem. Please be sure to follow the steps in the s equence out lined below. Failure to do so could result in improper operation or failure of your Cable Modem.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Figure 2. Connecting the AC Adapter P o w e r Step 3-a: Connect the Cable Modem to an IEEE 802.3 10BaseT / 802.3u 100Base-TX Network using a RJ-45 male-terminated CA T-5 cable as illustrated in Figure 3a. Figure 3a.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Figure 3b. Connecting the USB Cable USB port CAUTION 1: Connecting to More Than one Computer Devices: This cable modem pr ovides you the featur e for Ethernet and USB interfaces to operate on 2 dif ferent computer devices simultaneously .
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Chapter 4 Ethernet Ins tallation Setting Up the Computer to Use an Ethernet Connection The LAN port you are using is auto-negotiating 10/100Mbps (Switch) Ethernet Interface. You can use the Ethernet port to connect to the Internet with an Ethernet network device such as NI C/Hub/Switch through RJ45.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Chapter 5 USB Installation ( OPTIONAL ) Notice : Some serials of Cable Modem may not have USB port. Using the USB port to connect to the Intern et allows you to .
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 4. After windows install the USB driver . Click Finish and W indows will ask for reboot Using USB with the W indows 2000 or Window s X P Operati ng System T o use the USB port with W indows 2000/XP: 1. Connect USB cable from PC to Cable Modem 2.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 5. Insert the Driver CD-ROM driver ….” then “Next” 6. Click “Search for a suitabl e 7. W indows will locate the driver autom atically 10.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 8. After windows install the USB driver . Click Finish and W indows will ask for reboot 11.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Chapter 6 Cable Modem LED Operation There are no user controls on your cable m odem. To operate, sim ply apply power to the unit by inserting the AC Adapter into an AC power outlet. Connecting the AC adapter to an AC protection ci rcuit is always recommended.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Appendix A: Cable Modem Specifications T able 4. RF Downstream Specification PARAMETER VALUE NOTES Center Frequency 91 MHz to 857 MHz +/- 30 kHz Level Range -15 dBmV to +15 dBmV One Channel Symbol Rate 5.056941 Msym/sec (30 Mbps) 5.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem T able 6. Electrical Specification PA R A M E T E R MEASURED V ALUE NOTES Power Adapter output voltage lower limit 1 1.4 VDC Power Adapter output voltage upper limit 12.6 VDC Current consumption 560 mA Normal m ode Normal mode T able 7.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Appendix B: Questions and Answers Section 1: T roubleshooting Modem LED Pr oblems T roubleshooting the modem portion of this Cable Modem begins with observing the front panel lights (also called LEDs - light em itting diodes).
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Question 3: The LAN Light Is Off Answer: If the LAN light is on, the Cable Modem's Et hernet port is connected to the computer correctly . If the modem is having problems transferring data, check the Cable light, as described in the above Cable Light subsec tion, to determ ine the state of the modem.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Section 2: T roubleshooting Netw ork Problems If you have been referred to this section from one of the paragraphs above then there is a possible problem with your cable network. Contact your CA TV ISP to check if the network is functioning correctly .
DOCSIS 1.0/ 1.1 Equivalent Cable Modem NOTE : If you have no TCP/IP pr otocol, pr ess Add, highlight Protocol and pr ess Add. Then next step is to highlight Micr osoft and TCP/IP , and then pr ess OK to complete the adding TCP/IP pr otocol pr ocess. 2.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 5. For W indows 98/Me, On the W indows Desktop, click Start. 6. Select Run. 7. T ype winipcfg.exe and Click OK 8.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 9. Click Renew . If you don’t receive an IP address 10. T ype command and click ok 1 1. T ype ipconfig and press Enter 12.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Using USB with the W indows 2000 or Window s XP Operating System 1. Click Network on Control Panel, make sure USB Cable Modem is installed NOTE : If you have no TCP/IP pr otocol, pr ess Add, highlight Protocol and pr ess Add.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem 5. 6. 7. For W indows 2000, On the W indows Desktop, click Start. Select Run. T ype cmd and Click OK 8. 9. T ype ipconfig and press Enter 10.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Question 10: I could not install USB driver well anyway . Answer: In case you do not install USB driver correctly . Please go to DEVICE MANAGER and if you see an yellow exclamation mark follow by “ External Cable Modem “ , as shown in the picture below this content.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Appendix C: Glossary Bandwidth Amount of data that can be transmitted per tim e. Baseline Privacy Interface The baseline privacy interf ace (BPI) provides cable modem users with data privacy across the cable network by en crypting data traf fic between user's cable modem and CMTS.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem DHCP Protocol used to automatically assign va rious network settings, most notably IP addresses DHCP Client Capabilities The Dynamic Host Configuration Protocol .
DOCSIS 1.0/ 1.1 Equivalent Cable Modem Headend The aggregation point in a CA TV plant where control equipment is located. The CMTS resides here, as does video broadcast and monitoring equipment.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem MAC (Media Access Control) Media Access Control (MAC) is the protoc ol governing access to the network. The MAC device is located between receive a nd transmit paths. Among its functions are the controlling of ranging, the assignment of frequencies, and the allocation of time slots.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem QoS Quality of Service. Often used to indicate a ce rtain service level guaranty . QPSK Quadrature Phase Shift Keying QPSK is a digital frequency modulation tech nique used for sending data over coaxial cable networks.
DOCSIS 1.0/ 1.1 Equivalent Cable Modem USB (Universal Serial Bus) The Universal Serial Bus (USB) replaces m a ny diff erent types of serial and parallel port connectors with one standa rd plug and port combination. 10BaseT An unshielded, twisted pair cable with RJ- 45 connectors used with an Ethernet LAN.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Cables to Go DOCSIS Cable Modem c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Cables to Go DOCSIS Cable Modem - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Cables to Go DOCSIS Cable Modem, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Cables to Go DOCSIS Cable Modem va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Cables to Go DOCSIS Cable Modem, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Cables to Go DOCSIS Cable Modem.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Cables to Go DOCSIS Cable Modem. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Cables to Go DOCSIS Cable Modem ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
