Manuel d'utilisation / d'entretien du produit P2896 du fabricant Bunn
Aller à la page of 22
USE AND CARE OF YOUR My Café ™ T ea & Coffee Pod Brewer P2896 Model MCP COMMERCIAL AND HOUSEHOLD TYPE The Bunn logo is a registered trademark of Bunn-O-Matic Corporation.
2 Hazardous Voltage! Can Cause Fire Or Electrical Shock! Do Not Disassemble The Brewer! There Are No User Serviceable Parts Inside! The only user replacement parts are shown on page 20. Repair Should Be Done By Authorized Service Personnel! (Refer to page 22) T ABLE OF CONTENTS WARNINGS .
3 P2971 # 37267.0000 # 37280.0000 # 37282.0000 # 37281.0000 W A TER ONL Y USER NOTICES Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition.
4 IMPOR T ANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Read all instructions. • Do not touch hot surfaces. Use handles or knobs. • T o protect against electric shock, do not place cord, plug, or brewer in water or liquid.
5 • Use CAUTION when dispensing hot water from the brewer . The water from your BUNN ® Pod brewer is approximately 200°F (93°C). This is approximately 50°F (10°C) hotter than the hot water from your faucet and must be handled with care.
6 FIG 1. Exploded View WA TER RESERVOIR SLIDE LID POD HOLDER RELEASE BUTTON POD HOLDER INSERT POD HOLDER DRIP TRA Y GRA TE DRIP TRA Y POWER SWITCH CONTROL P ANEL VOLUME CONTROL SLIDE LEVER HEA TING IN.
7 DEFINITIONS COMPONENTS • W A TER RESERVOIR - Holds reser ve water for brewing. The reservoir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (Holds 46 oz. (1.7 L) to the maximum line.
8 • POD HOLDER INDICA TOR - This indicator identifies a missing or unlocked pod holder . Before a brew cycle can be started, the pod holder must be inserted and locked into place. • TEA BREW BUTTON - Depress this button to brew a serving of tea or coffee.
9 INITIAL BREWER SET -UP 1. Remove the lid and water reservoir . (CAUTION: Do not place the brewer in a sink or other water source.) 8. Place a mug or bowl that will hold at least 14 fl. oz. (414 ml) onto the drip tray grate. 4. Replace the reservoir and lid and close the slide lid.
10 BREWING DELICIOUS COFFEE OR TEA 1. Open the slide lid. (CAUTION: Do not place brewer in sink or other water source.) 2. Fill the reservoir above the minimum line, up to the maximum line with fresh cold water . 3. Close the slide lid. 4. Adjust the volume control lever to the desired volume.
11 HOT W A TER The same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder . CAUTION: The water from your BUNN ® Pod brewer is approximately 200°F (93°C). This is hotter than the hot water from your faucet and must be handled with care.
12 W A TER QUALITY I nstall a water conditioner if your water contains excessive amounts of sediment, taste, or odors. GOLDEN CUP ST ANDARD Y ou might find it interesting that the Specialty Coffee Association of America (SCAA), has established standards for the perfect cup of coffee, or Golden Cup Standard.
13 ROUTINE CLEANING Before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder , drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse.
14 7) Place the empty cup or bowl back onto the drip tray grate and press the COFFEE BREW BUTTON to begin a brew cycle. 8) When the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank. 9) Clean the pod holder with a mild detergent and rinse thoroughly .
15 INSPECTING THE SPRA YHEAD SEAL When disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. CAUTION: The seal confines the hot liquid to the pod holder .
16 TROUBLESHOOTING SITUA TION EXPLANA TION Nothing happens when the COFFEE BUTTON or TEA BUTTON is pressed. This is the first time you have used your brewer . The Initial Brewer Set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle.
17 SITUA TION EXPLANA TION The REFILL WATER INDICATOR has come on. The POD HOLDER INDICATOR has come on. The water shuts off and comes back on again when brewing. The WATER RESERVOIR has run low on water. Slide the lid open and pour additional water into the reservoir, or remove the reservoir and fill it at a sink, or other water source.
18 TROUBLESHOOTING (Cont.) SITUA TION EXPLANA TION The Pod Holder will not come out of the brewer . Water is appearing on the counter around the base of the brewer . Water leaks out around the sprayhead. The pod in the POD HOLDER may have swelled to a point where the holder does not slide out easily .
19 SITUA TION EXPLANA TION The BUNN ® (POD HOLDER RELEASE BUTTON) indicator is not on all of the time. The HEA TING INDICA TOR comes on when the COFFEE or TEA button is pressed.
20 BUNN ® REPLACEMENT P AR TS SLIDING LID Dishwasher Safe. POD HOLDER Dishwasher safe. WA TER RESERVOIR Holds 46 oz. (1.7 L) of fresh water for quick brewing. Dishwasher safe. DRIP TRA Y AND GRA TE Dishwasher safe. Catches up to 6 oz. (177 ml) of liquid.
21 LIMITED W ARRANTY Bunn-O-Matic Corporation (“Bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this Pod Brewer that the Pod Brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purchase of the Pod Brewer .
22 AUTHORIZED SERVICE For Service Information Contact: Bunn-O-Matic Corporation 1-800-870-0894 T o receive full assistance, please have Serial Number ready when calling for ser vice. (Located on the bottom of your brewer) Service Center Locations: Visit our web site at www .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Bunn P2896 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Bunn P2896 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Bunn P2896, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Bunn P2896 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Bunn P2896, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Bunn P2896.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Bunn P2896. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Bunn P2896 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
