
SETUP GUIDE | GUIDE D’INSTALLATION



ESPAÑOL 13
PORTUGUÊS 18
Informations importantes concernant la sécurité, la mise en conformité et la garantie

1 Remove the battery cover by pressing the top of the cover and pulling it downwards
2 Remove the receiver
3 Insert the battery
4 Close the battery cover
5 Make sure the mouse is turned on via the switch on the bottom of the mouse


6 Recommended: Insert receiver into the receiver extension cable Insert extension cable into your USB port Alternatively, insert receiver directly into your USB port
7 Download the G HUB software

– To make your mouse lighter, a lithium AA battery

(not included) can be used
– Keep the mouse and receiver 2 m+ away from wireless
routers or other 2 4GHz wireless devices to minimize environmental noise
– G304 / G305 has a wireless range of up to 10 meters
To ensure optimal performance in noisy wireless environments, it is recommended to keep the receiver within 20 cm of the mouse


1 Left (Button 1) 2 Right (Button 2) 3 Wheel click (Button 3) 4 Forward (Button 4) 5 Back (Button 5) 6 DPI cycle (Button 6) 7 On/Off switch (bottom of mouse, not programmable)


DPI Yellow: step 1 - 400 DPI White: step 2 - 800 DPI (default) Orange: step 3 - 1600 DPI Magenta: step 4 - 3200 DPI Blue: step 5 - 6400 DPI (Step 5 can be activated via software only)
– Activating endurance mode will degrade tracking performance
but improve battery life
You can customize the onboard profile settings using the G HUB These settings include button programming, report rate, performance/endurance modes and tracking behavior G304 / G305 allows up to 5 DPI settings
By default, G304 / G305 has the following settings:
©2020 Logitech Logitech, Logitech G, Logi and their respective logos are trademarks or registered trademarks of Logitech Europe S A and/or its affiliates in the U S and other countries All other trademarks are the property of their respective owners Logitech assumes no responsibility for any errors that may appear in this manual Information contained herein is subject to change without notice

1 Retirer le couvercle du compartiment à piles en appuyant sur le dessus du couvercle et en le tirant vers le bas
2 Retirer le récepteur
3 Insérer la batterie
4 Refermer le compartiment à piles
5 Vérifier que la souris soit sous tension à l'aide du commutateur situé sous la souris


6 Recommandé: Insérez le récepteur dans la rallonge du récepteur Connectez la rallonge à votre port USB Sinon, connecter le récepteur directement à votre port USB
7 Télécharger le logiciel G HUB
Pages mentionnées dans ce manuel — fabricant, assistance et téléchargements.
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.