
enTable of Contents enInstruction for Use Safety and warning information
Before you switch ON the appliance Please read the operating and installation instructions carefully! They contain important information on how to install, use and maintain the appliance. The manufacturer is not liable if you fail to comply with the instructions and warnings. Retain all documents for subsequent use or for the next owner.
Technical safety The tubes of the refrigeration circuit convey a small quantity of an environmentally friendly but flammable refrigerant (R600a). It does not damage the ozone layer and does not increase the greenhouse effect. If refrigerant escapes, it may injure your eyes or ignite.

Repairs may be performed by the manufacturer, customer service or a similarly qualified person only. Only original parts supplied by the manufacturer may be used. The manufacturer guarantees that only these parts satisfy the safety requirements. Do not use multiple sockets, extension leads or adapters.
edged implements to remove frost or layers of ice. You could damage the refrigerant tubes. Leaking refrigerant may cause eye injuries or ignite.
and vulnerable people at risk: At risk are children, people who have limited physical, mental or sensory abilities, as well as people who have inadequate knowledge concerning safe operation of the appliance. Ensure that children and vulnerable people have understood the hazards. A person responsible for safety must supervise or instruct children and vulnerable people who are using the appliance. Only children from 8 years and above may use the appliance. Supervise children who are cleaning and maintaining the appliance. Never allow children to play with the appliance.
appliance with a steam cleaner! The steam may penetrate electrical parts and cause a short-circuit. Risk of electric shock!
pull the mains plug out or switch off the fuse. Do not pull out the mains plug by tugging on the power cord.
contain flammable propellants (e.g. spray cans) or explosive substances in the appliance. Explosion hazard!

General regulations The appliance is suitable for refrigerating food. This appliance is intended for use in the home and the home environment. The appliance is suppressed according to EU Directive 2004/108/EC. The refrigeration circuit has been checked for leaks. This product complies with the relevant safety regulations for electrical appliances (EN 60335-2-24). This appliance is intended for use up to a maximum height of 2000 metres above sea level.
tightly closed and standing up.
door seal free of oil and grease. Otherwise, parts and door seal will become porous.
Children in the household
packaging and its parts. Danger of suffocation from folding cartons and plastic film!

The packaging protects your appliance from damage during transit. All utilised materials are environmentally safe and recyclable. Please help us by disposing of the packaging in an environmentally friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal.
Refrigerators contain refrigerant and gases in the insulation. Refrigerant and gases must be disposed of professionally. Ensure that tubing of the refrigerant circuit is not damaged prior to proper disposal.
After unpacking all parts, check for any damage in transit. If you have any complaints, please contact the dealer from whom you purchased the appliance or our customer service. The delivery consists of the following parts:
Old appliances are not worthless rubbish! Valuable raw materials can be reclaimed by recycling old appliances.
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.
Redundant appliances 1. Pull out the mains plug. 2. Cut off the power cord and discard with the mains plug.
consumption and noises

Installation location
Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. g. a cooker, radiator, etc. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source:
The appliance is designed for a specific climate class. Depending on the climate class, the appliance can be operated at the following temperatures. The climate class can be found on the rating plate. Fig. ,
Climate class Permitted ambient temperature SN +10 °C to 32 °C N +16 °C to 32 °C ST +16 °C to 38 °C T +16 °C to 43 °C
An attachment under certain worktops, e.g. stone, glass or stainless steel, is frequently not possible. You can order accessories from customer service for installation on the side walls.
Fig. !/6 The refrigeration unit is ventilated only via the ventilation grille in the base. Never cover the ventilation grille or place anything in front of it. Otherwise the refrigeration unit must work harder, increasing the power consumption.

Getting to know your appliance
After installing the appliance, wait at least 1 hour until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance (see chapter “Cleaning the appliance”).

Please fold out the illustrated last page. These operating instructions refer to several models. The features of the models may vary. The diagrams may differ. Fig. !
The socket must be near the appliance and also freely accessible following installation of the appliance. m Warning
1 Light switch 2 Temperature controller/light 3 Glass shelf in the refrigerator compartment 4 Pull-out container 5 Vegetable container 6 Ventilation opening 7 Shelf for butter and cheese 8 Egg rack 9 Shelf for large bottles
Risk of electric shock If the length of the mains cable is inadequate, never use multiple sockets or extension leads. Instead, please contact Customer Service for alternatives.
The appliance complies with protection class I. Connect the appliance to 220–240 V/50 Hz alternating current via a correctly installed socket with protective conductor. The socket must be protected by a 10 A to 16 A fuse. For appliances operated in non- European countries, check whether the indicated voltage and current type match the values of your electricity supply. This information can be found on the rating plate, Fig. ,.

Setting the temperature
Turn temperature controller, Fig. "/A, from position “0”. The appliance begins to cool. Light is switched on when the door is open.
Turn temperature controller, Fig. "/A, to the required setting. When the controller is at a medium setting, the temperature drops to approx. +4 °C in the coldest zone. Fig. # Higher settings lower the temperature in the refrigerator compartment.
The refrigerator compartment temperature rises:
We recommend:
above +4 °C.
storage of food (energy-saving mode).
of food.
ily, when the door is frequently opened or large quantities are placed in the refrigerator compartment.
The temperature in the refrigerator compartment may rise temporarily if large amounts of food or a lot of drinks are placed inside. Therefore the temperature controller should be set to a higher setting for approx. 7 hours.
Information on the usable capacity can be found inside your appliance on the rating plate. Fig. ,
frequently, · the refrigerator compartment,

Interior fittings
You can reposition the shelves inside the appliance and the door shelves as required:
The refrigerator compartment is the ideal storage location for ready meals, cakes and pastries, preserved food, condensed milk, hard cheese, fruit and vegetables sensitive to cold.
lower and swivel out to the side. Fig. $
shelf. Fig. %
Wrap or cover food before placing in the appliance. This will retain the aroma, colour and freshness of the food. In addition, flavours will not be transferred between foods and the plastic parts will not become discoloured.
Pull-out container
Fig. ' The pull-out container is especially suitable for the storage of foods which contain meat. It can be taken out for loading, unloading and cleaning.
Note the chill zones in the refrigerator compartment
Fig. ( The vegetable container can be taken out for loading, unloading and cleaning.
The air circulation in the refrigerator compartment creates different chill zones:
container. Fig. #
of the door.
(not all models)

Sticker “OK”
If you do not use the appliance for a prolonged period: 1. Switch off the appliance. 2. Pull out mains plug or switch off fuse. 3. Clean the appliance. 4. Leave the appliance door open.
(not all models) The sticker “OK” lets you check whether the refrigerator compartment achieves the safe temperature ranges of +4 °C or colder recommended for food. If the sticker does not indicate “OK”, gradually reduce the temperature.
While the refrigerating unit is running, beads of condensation or hoarfrost form at the back of the refrigerator compartment. This is quite normal. It is not necessary to wipe off the condensation or frost. The rear panel defrosts automatically. The condensation runs into the condensation channel, Fig. ). and is conveyed to the refrigerating unit where it evaporates.
Turn temperature controller, Fig. "/A, to position “0”. Refrigeration unit and light switch off.
Correct setting

Cleaning the appliance m Caution
All variable parts of the appliance can be taken out for cleaning.
Take out glass shelves Fig. $ Lift the glass shelves, pull forwards, lower and swivel out to the side.
cleaning agents or solvents.
sponges. The metallic surfaces could corrode.
Taking out pull-out container Fig. ' Lift the container and pull out.
in the dishwasher. The parts may become deformed!
Condensation channel Fig. ) To clean the condensation channel, take out the pull-out container. Fig. !/4 Regularly clean the condensation channel and drainage hole with a cotton bud or similar implement to ensure that the condensation can drain.
Proceed as follows: 1. Before cleaning: Switch off the appliance. 2. Pull out the mains plug or switch off the fuse! 3. Take out the food and store in a cool location. 4. Wait until the layer of frost has thawed. 5. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing-up liquid. The rinsing water must not run into the light. 6. Wipe the door seal with clear water only and then wipe dry thoroughly. 7. Rinsing water must not run through the drainage hole into the evaporation area. 8. After cleaning reconnect and switch the appliance back on. 9. Put the food back into the appliance.
Taking out vegetable container with cover Fig. ( Lift vegetable container and take out forwards.
Take out shelves in the door Fig. & Lift shelves upwards and take out.
Ventilation opening Fig. * The ventilation grille in the base can be removed for cleaning. To do this, depress the clips in the ventilation openings and simultaneously remove the ventilation grille forwards.

Operating noises
ventilated room! The appliance should not be installed in direct sunlight or near a heat source (e.g. radiator, cooker). If required, use an insulating plate.
Droning Motors are running (e.g. refrigerating units, fan).
Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing.
down before placing in the appliance.
Clicking Motor, switches or solenoid valves are switching on/off.
compartment and use the low temperature of the frozen food to cool refrigerated food.
The appliance is not level Please align the appliance with a spirit level. Use the height-adjustable feet or place packing underneath them.
possible.
not affect the energy rating of the appliance.
The appliance is not free-standing Please move the appliance away from adjacent units or appliances.
Containers or storage areas wobble or stick Please check the removable parts and re-insert them correctly if required.
Bottles or receptacles are touching each other Move the bottles or receptacles slightly away from each other.

Before you call customer service: Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee!
Fault Possible cause Remedial action
The light does not work. The bulb is defective. Replace bulb. Fig. +/B
Light switch is jammed. Check whether the light switch can move. Fig. +/A
Floor of the refrigerator compartment is wet.
The condensation channels or drainage hole are blocked.
Clean the condensation channels and the drainage hole. See chapter Cleaning the appliance. Fig. )
The temperature in the refrigerator compartment is too cold.
Temperature controller has been set too high.
Set temperature controller lower.
The refrigerating unit is switching on more frequently and for longer.
Appliance opened frequently.
Do not open the appliance unnecessarily.
The ventilation openings have been covered.
Remove obstacles.
Appliance has no refrigeration capacity.
The temperature controller is in position “0”.
Turn the temperature controller from position “0”. Fig. "/A
Check whether the power is on, check the fuses.
switched off.
been inserted properly.

Your local customer service can be found in the telephone directory or in the customer-service index. Please provide customer service with the appliance product number (E-Nr.) and production number (FD-Nr.). This information can be found on the rating plate. Fig. , To prevent unnecessary call-outs, please assist customer service by quoting the product and production numbers. This will save you additional costs.
Contact information for all countries can be found on the enclosed customer service list.
Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.
Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.