Manuel d'utilisation / d'entretien du produit 1000 Series du fabricant Weber
Aller à la page of 36
W E B E R W E B E R W ARNING: Do not try to light this appliance without reading "Lighting" instructions section of this manual. THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONL Y . NO TICE TO INST ALLER: These instructions must be left with the o wner and the owner should keep them for future use.
D ANGER Failure to f ollow the Danger s, W arnings and Cautions contained in this Owner’ s Manual may result in serious bodil y injury or death, or in a fire or an explosion causing dama g e to property . W ARNINGS Do not store a spare or disconnected LP tank under or near this barbecue .
3 Weber-Stephen Products Co. (W eber) hereby warrants to the ORIGINAL PURCHASER of this Weber Gas Barbecue that it will be free of defects in material and workmanship from the date of purchase as foll.
© 1997 Weber . Weber , , Genesis, Flavorizer and Crossover are registered U.S. trademarks; Perma-Mount, Gas Catcher , FlameCheck, Steam-N-Chips, Spider Stopper , and W arm-Up are U.S. trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266.
5 Contents WARNINGS ................................................................ 2 W arranty & Patents .................................................. 3-4 General Instructions .................................................... 6 Assembly .
6 General Instructions Y our Weber Gas Barbecue is a portable outdoor cooking appliance. With the Weber Gas Barbecue you can grill, barbecue, roast and bake with results that are difficult to duplicate with indoor kitchen appliances. The closed lid and Flavorizer Bars produce that "outdoor" flavor in the food.
7 Step 1 Check package contents Cooking box (assembly) Lid (assembly) LP tank LP tank filler adapter Bottom tray T wo cooking grates Control panel Assembl y T ools needed Screwdriver Hammer 7/16 inch open-end or an adjustable wrench Pliers Block of wood Supplies needed Y our LP tank is shipped empty for safety .
Left frame Right frame Wheel frame Caster frame T wo frame connectors Work table Swing table assembly Support rod Axle Accessory rack W arming rack W arm-Up Basket Five long Flavorizer Bars Eight shor.
T wo plastic buttons (actual size) 1/4-20 keps nut T wo 1/4-20 wing nuts (actual size) Fourteen 1/4 inch nylon washers T wo hair pin cotters T wo wheel hubcaps Check contents of hardware packs Three b.
10 Figure 1 Step 2 Assemble wheels Y ou will need: axle, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood. Place one end of the axle on the block of wood (or other protected surface). T ap on one hubcap. Put one wheel on the axle, WEBER side toward the hubcap.
11 Figure 3 Step 4 Continue frame assembly Y ou will need: caster frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3.
12 Figure 6 Step 7 Add front panel Y ou will need: front panel and two plastic buttons. T urn frame assembly right side up. Align the panel with the holes in the frame and insert the plastic buttons through the front panel and frame.
13 Y our Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment: a) Do the valves fit into the ends of the burners? Figure 9 (a).
14 Frame brace Manifold bracket Figure 10 Step 9 Install manifold bracket Y ou will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace.
15 Step 11 Add fuel scale assembly Y ou will need: fuel scale assembly , two 1/4-20 wing nuts and two nylon washers. Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame.
16 Step 13 Set LP fuel scale Y ou will need: LP tank (empty). Note - F or accuracy , the fuel scale must be set with an empty tank. We utilize various LP tank manufacturers. Some of the tanks we receive have differing top collar assemblies. (The top collar is the metal protective ring around the valve.
17 Figure 16 Step 15 Check that all burner valves are off Y ou will need: one burner control knob. V alves are shipped in the OFF position, but you should check to be sure. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off, proceed to the next step.
18 Step 17 Check for gas leaks W ARNING: Y ou should check f or gas leaks every time you disconnect and reconnect a gas fitting. Note - All f actor y made connections hav e been thoroughly check ed f or gas leaks. The burners hav e been flame tested.
19 Figure 24 Figure 23 Figure 25 Bottom tray Finger grip on front edge of bottom tray Finger grip Front side of catch pan holder Step 18 Install Flavorizer Bars and Cooking Grates Y ou will need: five long Flavorizer Bars, eight short Flavorizer Bars and two cooking grates.
20 Step 20 Install Lid Y ou will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins.
21 Slot in frame (view from below) Insert one end of the hinge rod into the hole in the frame. Figure 29 (a). Insert the other end into the hole in the swing table end bracket. Figure 29 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube.
22 Step 23 Complete accessory installation Y ou will need: W arm- Up B asket, warming rack, work table, accessory rack, three tubing plugs, thermometer and a hammer . Insert one end of the Weber W arm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid.
23 Lighting Summary lighting instructions are on the control panel. 6 8 5 2 7 4 3 1 Figure 1 Crosso ver Ignition System W ARNING: The burner contr ol knobs must be in the OFF position before turning on the LP tank v alve.
24 Manual Lighting 4) Turn the tank on by turning the tank valve counterclockwise. 5) Strike a match and put the flame into the matchlight hole in the front of the cooking box. W ARNING: Do not lean over open barbecue. Keep your face and bod y at least one foot a way fr om the matchlight hole when lighting the barbecue.
25 Cooking W ARNING: Do not move the W eber Gas Barbecue when operating or hot. Y ou can adjust the FRONT , CENTER and BACK burners as desired. The control settings High (H), Medium (M), Low (L), or Off (O) are described in your W eber cookbook. The cookbook uses these notations to describe the settings of the FRONT , CENTER, and BACK burners.
26 Scale setting wing nut T ank lock wing nut T ank valve Collar (a) (b) Figure 3 Refilling the LP tank We recommend that you refill before the scale indicator reaches "E".
27 c) Connect the hose to the tank. Route the hose so it does not interfere with the scale indicator rod. Slide back the collar of the quick disconnect on the tank valve. Figure 5 (a). Push the male fitting of the regulator into the quick disconnect, and maintain pressure.
28 28 Safe handling tips f or LP Gas ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder , LP gas is a liquid. As the pressure is released the liquid readily vaporizes and becomes gas.
29 c) V alves to manifold connections. Figure 8 (c). d) The hose to regulator connection. Figure 8 (d). W ARNING: If there is a leak at connection (b), (c) or (d), turn OFF the gas . DO NO T OPERA TE THE B ARBECUE. Contact W eber-Stephen Customer Service .
30 General Maintenance W eber Spider Stopper Guards Y our Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section of the burner tubes. This blocks the normal gas flow , and can cause the gas to flow back out of the air shutter .
31 View from behind cooking box Wing nuts Figure 15 Guide screw Figure 16 Crossover tube Figure 17 Figure 14 d) Unlatch the Spider Stopper Guards and remove. Figure 14. e) Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box.
32 i) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the V enturi fins. There should be no gaps in the seams or in the fit around the burners and valves.
Prob lem Burners b urn with a yellow or orange flame, in conjunction with the smell of gas. Burners do not light. -or - Burners ha ve a small flickering flame in the HIGH position. -or - Barbecue temperature only reaches 250˚ to 300˚ degrees in the HIGH position.
34 W E B E R W E B E R ® ® ® ® ® ® ® ® 1 2 3 6 7 8 10 9 13-14 21 22 15 27 29 30 31 33 63 55 65 60 53 51 50 49 48 47 45 44 43 42 41 40 39 61-62 54 52 28 23 37 38 46 11 12 16 17 20 18 5 4 26 25 .
35 1 Lid (assembly) 2 Lid handle 3 W arm-Up Basket 4 W arming rack 5 Short Flavorizer bars (8) 6 Long Flavorizer bars (5) 7 Cooking grates (2) 8 Work table 9 T ubing plugs (5) 10 1/4-20 x 2 inch bolts.
A F INAL W ORD OF T HANKS hank you for choosing a W eber Barbecue. Our family her e at W eber has worked hard to produce the highest quality products for your satisfaction.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Weber 1000 Series c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Weber 1000 Series - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Weber 1000 Series, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Weber 1000 Series va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Weber 1000 Series, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Weber 1000 Series.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Weber 1000 Series. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Weber 1000 Series ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.