Manuel d'utilisation / d'entretien du produit HOTBLAST 1200G du fabricant United States Stove
Aller à la page of 28
1 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Model 1200G SOLID FUEL W ARM AIR FURNA CE Owners Manual C O M P A N Y U N I T E D S T A T E S S T O V E C S S U WARNOCK HERSEY R *FOR P ARALLEL INST ALLA TION WITH AN EXISTING FORCED AIR, GAS OR OIL FIRED FURNA CE (U .
2 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• T OOLS AND MA TERIALS NEEDED TOOLS Pencil 6 Foot Folding Rule or Tape Tin Snips Drill, Hand or Electric Drill Bit (For Sheet Metal Screws) 1/8" Dia.
3 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• CA UTION Your Furnace has the following labels. Read and obey all labels. REFER TO MARKINGS ON THE APPLIANCE FOR ADDITIONAL INFORMATION.
4 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Read these rules and the instructions carefully. Failure to follow them will cause a hazard that could result in death, serious bodily injury, and/or property damage. Check your local codes. This installation must comply with their rulings.
5 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Your Supplemental Furnace is designed to be a supplemental or central heating source for your home. This solid fuel furnace may be installed in conjunct.
6 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• MODEL 1200G DIMENSIONS FIG. 1.
7 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• 1. 2. 3. 4. FIG. 3 The furnace should be located in the same room as the central system and as close as possible, but no closer than 9". There should be no wall between the furnace and the warm air outlet duct that is connected directly to the warm air outlet plenum of the central furnace.
8 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• LISTED FACTORY BUILT CHIMNEY Carefully follow chimney manufacturer's instructions. Use only a Listed Residential Type or Building Heating Appliance Chimney. If your chimney starts at the ceiling (Fig.
9 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• RULES FOR CONNECT OR PIPE INST ALLA TION FIG. 6 The crimped end of the chimney connector fits inside the furnace flue collar. Install additional chimney connector and elbow with the CRIMPED END TOWARD THE FURNACE.
10 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• ASSEMBL Y OF FURNA CE Your furnace requires the following items to be assembled or installed by the service person: Feed Door Handle Feed Door Latch As.
11 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• BLO WER & COMPONENT ASSEMBL Y - FIG. 10 JUNCTION BOX MOUNTING BRACKET 1. Attach the Honeywell Limit Control to the bracket as shown below, using (2) of the #12 x 3/4" Tek Screws provided in the parts bag.
12 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• MODEL 1200Q WIRING DIAGRAM - FIG. 11 LIMIT CONTROL BLACK WHITE WHITE BLACK WHITE BLACK GREEN 2 x 4 JUNCTION BOX BLOWER TO HOUSE SUPPL Y NOTE: GROUND HOUSE SUPPLY TO INSIDE OF JUNCTION BOX.
13 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Installation Please see all methods of Installation in Appendix at the rear of this booklet. This is a furnace, not a free standing stove. You must direct heated air from 12" outlet away from the furnace, or it will not function properly.
14 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• POWER FAILURE INSTRUCTIONS: Operation after loss of power Remove filter if provided. Do not expect to keep home at normal temperatures. Do not load fuel abov e bottom of feed door . Set Fuel door and Ash door spin draft maxim um closed per the factory installed stops.
15 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• CENTRAL INST ALLA TION (U.S. & CANAD A) ADD-ON INST ALLA TION (U .S. ONL Y).
16 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• AL TERNA TIVE P ARALLEL INST ALLA TION WIRING DIA GRAM - FIG. 14 TO GAS/OIL/ELECTRIC TRANSFORMER HOTBLAST COMBINATION CONTROL LIMIT FAN JUMPER IN H H P.
17 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Your Hotblast Furnace is for burning wood only. WOOD BURNING: (1)use Hardwood, 18" to 26", split and air dried (seasoned) for six months. (2) set thermostat to "HIGH" before opening feed door.
18 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• Do not expect a furnace to draw. It is the chimney that creates the draft. Smoke spillage into the house or exces- sive build-up of water or creosote in the chimney would keep it from functioning properly.
19 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• MODEL 1200G - P AR TS.
20 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• KEY NO. DESCRIPTION QTY. PART NO. 1 FIREBOX WELDMENT 1 69121 2 CABINET SIDE 2 24568 3 CABINET TOP W ELDMENT 1 69151 4 FIRE BRICK 16 89066 5 GRATE 4 402.
21 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INST ALLA TION A NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION..
22 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INST ALLA TION B NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION..
23 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INST ALLA TION C NOTE: ANTI-BACKDRAFT FLAPPERS OR BAFFLE ARE REQUIRED FOR THIS INSTALLATION..
24 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION D (U.S. ONLY) INSTALLATION E (U. S. ONLY).
25 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• APPENDIX INSTALLATION F INSTALLATION G.
26 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• NOTES.
27 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• List of Problems Possible Cause Solutions 1. Smoking when feed door is open. 2. Furnace does not heat. 3. Blower does not run. 4. No air from registers - fan running. 5. Air from registers is not hot. 6.
28 •DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• THIS MANU AL WILL HELP Y OU OBT AIN EFFICIENT , DEPEND ABLE SER VICE FROM Y OUR HO TBLAST FURNACE, AND ENABLE Y OU T O ORDER REP AIR P AR TS CORRECTL Y . KEEP THIS MANU AL IN A SAFE PLA CE FOR FUTURE REFERENCE.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté United States Stove HOTBLAST 1200G c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du United States Stove HOTBLAST 1200G - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation United States Stove HOTBLAST 1200G, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le United States Stove HOTBLAST 1200G va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le United States Stove HOTBLAST 1200G, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du United States Stove HOTBLAST 1200G.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le United States Stove HOTBLAST 1200G. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei United States Stove HOTBLAST 1200G ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
