Manuel d'utilisation / d'entretien du produit 45xx Series du fabricant Ultra Start
Aller à la page of 16
-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
Page 2 This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
2WAY R EMOTE ST ARTER/ ALARM OWNER ’S GUIDE Page 3 R emote Star t - A u t o m a t i c T r a n s m i s s i o n 1. Press and release button #3. 2. The park light s will flash and the siren will chirp one time. 3. The vehicle will then remote start. The p ark light s will flash four times then remain on while the vehicle is running.
Page 4 Idle Mode 1. While the vehicle is running with key , press button #3 . 2. The park light s will turn on and the siren will chirp once. 3. T urn the ignition key off and the vehicle will continue to run. 4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition.
Manual transmission remote st arters must be set into Reservation Mode before the remote st arter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is inst alled.
Page 6 1. Press and hold button #2 and the doors will unlock, continue holding button #2, the trunk release will activate. The trunk release will be confirmed by one park light flash and one siren chirp. Note: The trunk release output will not activate when the ignition key is in the “On” position.
Page 7 Car Finder is a feature that can be used to find your vehicle in a crowded parking lot. 1. Press and release button #4 twice within 3 seconds. 2. The park light s will flash and the siren will chirp five times to draw attention to the location of the vehicle.
Page 8 Auxiliary Output 1 (Optional) Sir en On/Of f Auxiliary Output 2 (Optional) Auxiliary Output are optional output s from the system. These output s Can be used to activate such things as power window roll-up/ down modules or to open and close a power sun roof.
Page 9 Cold S tart Mode will st art the vehicle at a user selectable st art interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in T imer Mode or to st art at 0,-5,-15 or -25 Celsius in T emperature Mode (L T Models Only) for a maximum 12 start s.
Page 10 KEY ICON- This icon will begin to flash when the remote st arter button is first pressed. Af ter the vehicle has st arted this icon will stay on solid. SIREN ICON- This icon indicates that the alarm has been triggered. The remote will st art to beep and the siren icon will come on solid at the same time as the icon for the violated zone.
Page 1 1 TIMER ICON- When this icon is displayed in the left program column if confirms that the T imer Mode has been programmed ON. When this icon is turned on in remote program mode the Cold S t art feature will be activated. Cold S t art will default to the last time or temperature setting.
Page 12 1 2 3 4 1 2 3 4 1st 2nd This feature can be used if the vehicle is p arked in an area with above average noise or vibrations. (Airport s, construction zone...) T o T emporally Byp ass The Shock Press the button #1 to arm the alarm then press button #3 within three seconds.
Page 13 1) Press and hold buttons #1 and #4 until the minute portion of the clock begins to flash. 2) T o set the minute, press button #3 to increase and button #2 to decrease the minute. 3) T o set the hour , press button #1 and the hour portion of the clock will begin to flash.
Page 14 A TTENTION: T O A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place the system into Service Mode.
Page 15 Being that the installer does not always see when the system shut s down or fails to start, Diagnostic Memory will store in memory up to four shut down codes. This information can then be accessed to determine the source of the shut down. T o Enter Diagnostic Mode: St ep 1 - T urn the ignition on then off.
Limited Lif etime W ar r anty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Ultra Start 45xx Series c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Ultra Start 45xx Series - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Ultra Start 45xx Series, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Ultra Start 45xx Series va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Ultra Start 45xx Series, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Ultra Start 45xx Series.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Ultra Start 45xx Series. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Ultra Start 45xx Series ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
