Manuel d'utilisation / d'entretien du produit TBC-2251 du fabricant Tanaka
Aller à la page of 20
Owner’ Owner’ Owner’ Owner’ Owner’ s Man s Man s Man s Man s Man ual ual ual ual ual Model Numbers: TBC-2211, TBC-2251,TBC-230/B TBC-2211, TBC-2251,TBC-230/B TBC-2211, TBC-2251,TBC-230/B TBC.
www.tanaka-usa.com 1 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Before using this unit: • Read the operator’s manual carefully. • Check that the cutt ing equipment is correctly assembled and adjusted. • Start the unit and check the carburetor adjustment.
www.tanaka-usa.com 2 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Blade thrust may occur when the spinning blade contacts a solid object in the critical area. A dangerous reacti on may occur causing the entire unit and operator to be thrust violently.
www.tanaka-usa.com 3 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 1. What is What? Since this manual covers several models, there m a y be some difference between pictures and your unit. Use the instructions that apply to your unit.
www.tanaka-usa.com 4 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 2. Warnings and safety instructions. Operator Safety • Always wear a safet y face shield or goggles . • Always wear heavy, long pant s, boo ts and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot.
www.tanaka-usa.com 5 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 3. Assembly procedures Drive shaft to engine (Fig. 1 -1) Loosen tube locking bolt (1) about ten turns so that the bo lt tip will not obstruct drive sh aft tube to be inserted.
www.tanaka-usa.com 6 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Throttle wire/stop cord Remove the air cleaner cover. (Fig. 1-4) Connect stop cords. (Fig. 1 -5) Set outer receiver (1) (if so provided) into wire guide and put throttle wire through the outer receiver.
www.tanaka-usa.com 7 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B When using a trimmer head (2) with a two piece type blade guard, attach the guard extension to the blade guard. (Fig. 1-9) Then loca te the guard above the gear case.
www.tanaka-usa.com 8 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 4. Operating procedures Fuel (Fig. 2-1) WARNING! The trimmer is equipped with a two-stroke engine. Always run t he engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel.
www.tanaka-usa.com 9 custsvc@tanaka-i sm.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B CAUTION! Before starting, make sure the cutting attachment is not touching anything. Starting (Fig. 2-2, 2B) 1. Set ignition switch (1) to the ON position. (Fig.
www.tanaka-usa.com 10 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Cutting (Fig. 2-4, 4B, 4C, 4D) • When cutting, operate engine at ov er 6500 rpm. Extended use at a slow speeds may wear the clutch prematurely. • Cut grass from right to left.
www.tanaka-usa.com 11 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 5. Maintenance MAINTENANCE, REPLA CEMENT, OR REPAIR OF THE EMISSION CONT ROL DEVICES AND SYSTEMS MAY BE PERF ORMED BY ANY NONROAD ENGINE REPAIR ESTABLISHMEN T OR INDIVIDUAL.
www.tanaka-usa.com 12 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B NOTE! If element is hard due to excessive dirt buildu p , re p lace it. Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly and rinse element in warm water with detergent.
www.tanaka-usa.com 13 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Flexible drive shaft (Fig. 3-5) Flexible drive shaft should be rem oved and lubricated with a good quality lithium grease every 20 hours.
www.tanaka-usa.com 14 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Maintenance schedule Below you will find some genera l maintenance instructions. For further information please contact your Tanaka service dealer. Daily maintenance • Clean the exterior of th e unit.
www.tanaka-usa.com 15 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 6. Optional Installation of free disk set (optional) (Fig. 4-1, 1 B) 1) Disassemble free disk (7) from the free disk set by loosening three bolts (8). 2) Place blade (3) as shown in drawing.
www.tanaka-usa.com 16 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B 7. Specifications NOTE: Sound levels are calculated as the time-weighte d energy total under v arious working conditions with the following time distribution: ½ idling, ½ racing.
www.tanaka-usa.com 17 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Declaration of conformity D6claration de conformit6 Dichiarazione di conformita Konformitiitserkliirung Declaraci6n de conformidad Konformitetsdeklaration Tanaka Kogyo Co.
www.tanaka-usa.com 18 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B IMPORTANT NOTICE THIS INFORMATION IS FOR TH E US AND CANADIAN MARKETS ONLY. • To reduce the risk of injury from loss of control, never use a metal blade on a curved shaft gr ass trimmer.
www.tanaka-usa.com 19 custsvc@tanaka-ism.com Owner’s Manual TBC-2211,TBC-2251,TBC-230/B Cutting Attachments for Tanaka Trimmers and Brushcutters 1) Fixed line commercial cutting heads offer excellent dur ability and light weight. Great for commercial use.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Tanaka TBC-2251 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Tanaka TBC-2251 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Tanaka TBC-2251, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Tanaka TBC-2251 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Tanaka TBC-2251, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Tanaka TBC-2251.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Tanaka TBC-2251. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Tanaka TBC-2251 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.