Manuel d'utilisation / d'entretien du produit RSE8D du fabricant Samsung
Aller à la page of 38
Register your product at www .samsung.com/global/register DA68-01453B REV(0.1) O WENER’S MANU AL AND INST ALL A TION Built-in D epth Side b y Side R efrigerator ENGLISH Epel pjt IB-01453B-EN (0.
O WNER’S MANU AL AND INST ALLA TION CONTENTS SAFETY INSTRUCTIONS ................................................................2 OPERATING INSTRUCTIONS SETTING UP THE REFRIGERATOR ........................................................5 MAJOR FEATURES.
2 SAFETY INSTR UCTIONS CAUTION/WARNING SYMBOLS USED OTHER SYMBOLS USED Indicates that a danger of death or serious injury exists. Indicates that a risk of personal injury or material damage exists.
SAFETY INSTR UCTIONS SAFETY INSTR UCTIONS 3 WARNING DANGER! RISK OF CHILD ENTRAPMENT PROPER DISPOSAL OF THE REFRIGERA TOR Before you throw away your old refrigerator or freezer When disposing of this or other refrigerators, remove the door/door seals, door latch so that small children or animals cannot get trapped inside.
4 SAFETY INSTR UCTIONS FOOD KEEPING & TREA TMENT CAUTION Do not overfill the refrigerator with food. • When you open the door, an item may fall out and cause personal injury or material damage. Do not put bottles or glass containers in the freezer.
5 OPERA TING INSTRUCTIONS INITIAL OPERA TING CONDITION Place the refigerator in an appropriate location with reasonable clearance between the wall and the refigerator. (refer to installation instructions in this mannal) MAJOR FEA TURES Twin Cooling System • The refrigerator and the freezer have two evapora tors.
6 CONTR OL P ANEL Dispenser Without CoolSelect Zone Model (RSE8D Model) Dispenser With CoolSelect Zone Model (RSE8K/J/V/T Model) FRIDGE TEMP. BUTTON To set the fridge temperature, press this button repeatedly to change the set temperature in sequence between 7°C and 1°C.
7 TEMPERA TURE CONTROL OPERA TING INSTRUCTIONS T emperature setting • The temperature controls are in the factory at 3 °C for the refrigerator compartment and -18°C for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.
8 DIGIT AL P ANEL • Press the Ice Type button in sequence to choose water, cubed ice, crushed ice. • Bright icon indicates the ice state currently in operation. • When the Green light changes to Orange, it is time to replace the water filter. If indicator is red, quick replacement is strongly recommended.
9 OPERA TING INSTRUCTIONS ICE and COLD W A TER DISPENSER Press the Ice Type button to select the type of ice: • Cubed Ice • Crushed Ice • No Ice If the Ice remains in the Ice bucket, the cubed ice is obtained. Push the ice dispenser lever with a cup.
10 SHEL VES AND BINS REFRIGERA T OR FREEZER Ice Bucket Ice Chute Dairy bin Special bin Beverage Station (optional) Deli bin Deodorizer Foldable Shelf Cool Select Zone TM Drawer (optional) Guard Fre UPP Shelf Front leg cover Drawers Door Bins Vegetable & Fruit Drawer Door Bin Can Guide bin Egg Container Epel pjt IB-01453B-EN (0.
11 OPERA TING INSTRUCTIONS FOOD ST ORA GE GUIDE FR OZEN FOOD ST ORA GE IN FREEZER Tempered Glass Shelf • Can be used to store all types of frozen food. Door Bin • Can be used for small packages of frozen food. Plastic Drawer • Can be used to store meat and dry foods.
12 FOOD ST ORA GE GUIDE Tempered Spill Proof Glass Shelf • Can be used to store all types of chilled food. • Safe and hard to be broken. • Circular marks on the glass surface are a normal phenomenon. Foldable shelf • If you need more taller space for tall items.
13 OPERA TING INSTRUCTIONS CoolSelect Zone TM Dra wer GUIDE (Optional) Soft Freeze • When “Soft Freeze” is chosen, the temperature on the digtal panel displays -5 o C regardless of the set temperature of the refrigerator. • “Soft-Freeze” temperature helps keep meats and fishes fresh longer.
14 CoolSelect Zone TM Dra wer GUIDE (Optional) Thaw Time 4 hours 6hours 10 hours 12 hours Weight 400 g 600 g 800 g 1000g NOTE Depending on the size and thickness of meat and fish, the thawing time may vary. The above weight represents the total weight of food in the CoolSelect Zone TM Drawer.
15 OPERA TING INSTRUCTIONS Front Leg cover • Open the freezer and refrigerator doors, remove the three screws and detach the cover. • To reassemble the leg cover, put it back into position and tighten the three screws.
16 CLEANING THE A CCESSORIES Inside • Clean the accessories using a mild detergent. Then wipe with a dry cloth. • After washing the accessories, make sure that they are dry before using them again. Exterior • Wipe the front control panel with a clean cloth.
17 OPERA TING INSTRUCTIONS CLEANING THE A CCESSORIES INTERIOR LIGHT IN THE REFRIGERA T OR CHANGING THE INTERIOR LIGHT Before changing the interior light, unplug the appliance from the power supply. If you experience difficulty when changing the light, contact your service centre.
18 CHANGING THE INTERIOR LIGHT W A TER FIL TER The water “Filter Indicator” light • “ Filter Indicator ” light lets you know when it is time to change your water filter cartridge. The light will change from green to orange. This tells you that it is almost time to change the current cartridge.
19 INST ALLA TION OF THE REFRIGERA T OR • Check the dimensions of your entrance door to determine whether the refrigerator can pass through it. • Moving refrigerator through door if depth or width of refrigerator is bigger than door ’ s, removes refrigerator doors.
20 REMO VING THE FR ONT LEG CO VER 1) Remove the water tube by pressing the coupler ( ➁ ) and pulling the water tube ( ➀ ) away. Open the freezer and refrigerator doors, and then take off the front leg cover assembly by turning the three screws counter-clockwise.
21 INST ALLA TION INSTRUCTIONS REMO VING THE REFRIGERA T OR DOORS 1) With the door closed, remove the Top table ( ➀ ) using a screwdriver, and then disconnect the wires ( ➁ ). 2) Remove hinge screws ( ➂ ) and ground screw ( ➃ ) counter-clockwise, and take off the upper hinge ( ➄ ) along the arrow ( ➅ ).
22 REMO VING THE REFRIGERA T OR DOORS 1) Disconnect the wires ( ➀ ). 2) Remove hinge screws ( ➁ ) and ground screw ( ➂ ) counter-clockwise, and take off the upper hinge ( ➃ ) in the direction of the arrow ( ➄ ). Take care when removing the door to ensure that it does not fall on you.
23 INST ALLA TION INSTRUCTIONS REA TT A CHING THE REFRIGERA T OR DOORS Reattaching the Freezer Door 1) Reattach the freezer door by inserting the hose ( ➀ ) in the lower side of the door into the hole in the lower hinge ( ➁ ) and pull the hose down.
24 REA TT A CHING THE REFRIGERA T OR DOORS Reattaching the Refrigerator Door 1) Insert the lower hinge ( ➀ ) in the bracket lower hinge ( ➁ ). 2) Place the hole in the refrigerator door ( ➂ ) over the lower hinge ( ➃ ). 3) Insert the upper hinge shaft ( ➄ ) into the hole ( ➅ ).
25 INST ALLA TION INSTRUCTIONS REA TT A CHING THE REFRIGERA T OR DOORS FRONT LEG COVER SCREW 1) While pressing the front face of coupler ( ➁ ), insert the water line ( ➀ ) in the coupler. Put on the front leg cover by turning the three screws clockwise, as shown in the figure.
26 ADJUSTING THE CLEARANCE BETWEEN THE DOORS The doors will be uneven if the refrigerator is not level. Case 1) Freezer door is lower than that of the refrigerator Insert a straight screwdriver (-) ( ① ) into a slot of the control lever ( ➁ ), turn it clockwise and level the refrigerator.
27 INST ALLA TION INSTRUCTIONS ADJUST THE CLEARANCE BETWEEN THE DOORS Making small adjustments between doors . If the door of freezer is higher or lower than that of the refrigerator.
28 CHECKING THE W A TER DISPENSER LINE (OPTIONAL) INST ALLING OF THE W A TER DISPENSER LINE Chec king the P arts 1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm 2 (0.14 ~ 9.8Mpa, 19.9 ~ 142.2 psi, 1.37 ~ 9.8 bars) is required.
29 INST ALLA TION INSTRUCTIONS INST ALLING OF THE W A TER DISPENSER LINE WARRANTY INFORMATION This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage.
30 INST ALLING THE W A TER DISPENSER LINE - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator.
INST ALLA TION INSTRUCTIONS 31 INST ALLING THE W A TER DISPENSER LINE Remo ve an y residual matter inside the water supply line 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes).
32 BEFORE Y OU CALL FOR SER VICE... Prob lem The refrigerator does not work sufficiently or at all The food in the refrigera- tor is frozen Unusual noises or sounds are heard The front corners and sid.
33 BEFORE Y OU CALL FOR SER VICE... Prob lem Small or hollow cubes Slow ice cube freezing Orange glow in the freezer Cube dispenser does not work(on some models) Water has poor taste/odor (on some mod.
34 Ambient Room T emperature Limits This fridge/freezer is designed to operate in ambient temperatures specified by its tem- perature class marked on the rating plate. NOTE: Internal temperatures may be affected by such factors as the location of the fridge/freezer, ambient temperature and the frequency with which you open the door.
MEMO Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 35.
MEMO Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 36.
Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 38.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Samsung RSE8D c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Samsung RSE8D - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Samsung RSE8D, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Samsung RSE8D va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Samsung RSE8D, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Samsung RSE8D.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Samsung RSE8D. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Samsung RSE8D ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
