Manuel d'utilisation / d'entretien du produit VSS-113 du fabricant AstroStart
Aller à la page of 18
–– VSS-113 S ECURITY SYSTEM FEATURING K EYLESS ENTR Y O WNER ’ S M ANUAL ® 2006 A STROFLEX E LECTRONICS.
© 2006 Astroflex Electronics – All rights reserved Table of contents What is included ..................................................................................................................................................................
What is included One control module A pair of three-button transmitters A Stinger® Doubleguard® dual-stage shoc k sensor (on-board the control module) The Revenger® Soft Chirp® six.
Transmitter functions The system uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any transmitter button to any system function. The transmitter initially comes programmed with Standard Configuration, but may also be customized by an authorized dealer.
P ASSIVE ARMING The system also can be programmed to arm itself automatically (called passive arming). If the system is programmed for passive arming, it will auto matically arm 30 seco nds after the ignition is turned off and the system “sees” you leave the vehicle by opening and closing a door.
Press a fourth time within five seconds: The sir en chirps four times followed by a long chirp. Zones 2 and 4 are now bypassed. Press a fifth time within five seconds: The siren chirps five times followed by a long chirp. All input zones, except the ignition, are now bypassed.
D ISARMING WITHOUT A TRANSMITTER This feature allows you to disarm the security syst em without the remote tr ansmitter should it be lost or damaged. In order to disarm the system without a remote transmi tter, you must have the vehicle’s ignition key and know where the Valet button is located.
security system will not arm, even with the remo te transmitter, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Valet ® Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet ® switch within 10 seconds.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 7 Doors and ignition are covered by NPC ® differently; if the alarm is tr iggered by an open door or ignition on cycle for three full cycles, the doors will be bypassed until the trigger ceases.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 8 S YSTEM STATUS CHIRPS The siren will chirp when arming/disarming the syst em. The pattern of chirps will audibly report the system’s status as described below.
Code hopping Both the receiver and transmitters use mathematic al formulas called algorithms to change their codes each time the transmitter is used. This te chnology has been developed to increase the security of the unit. The control unit knows what the next codes sh ould be.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 10 Power saver mode Your system will automatically enter Power Save r Mode while armed or in Valet Mode, after a long period of time in which no operation has been performed. This lowers the current draw to the vehicle’s battery.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 11 been left ajar when leaving the vehicle. Fo rced passive arming ensures that the security system will be armed in every situation.
Installation options The system has many options that may require ex tra parts and labor. Some of the possibilities are listed here. Progressive unlocking : In most cars with electric powe r door locks, the system can be configured so that when the system is disarmed , only the driver’s door unlocks.
vehicle, the system will trigger as the door is open ed and closed. This is how the system works to combat intersection carjacking. To protect against parking lot carjacking, arm the VRS ® before leaving the vehicle. The system will now trigger au tomatically the next time you or anyone drives the vehicle.
If the system has entered the triggered sequence (siren has begun chirping), pressing the disarm button of the transmitter will not disarm VRS ® . To disarm the VRS ® during a VRS ® trigger sequence: 1. Turn the ignition on. 2. Press the Valet switch the pre-programmed number of times to disarm the VRS ® system.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED 15 Trigger or Triggered Sequence : This is what happens when the alarm “goes off” or “trips”. The triggered response of your system consists of the siren sounding and parking light flashing for the programmed duration.
REFERENCE GUIDE T O ARM AND LOCK (1) USING YOUR R EMOTE You can lock the doors, and arm the system by pressing the button on your transmitter for one second. When the system arms, you will hear a short siren s ound, or chirp, and the parking lights will fla sh once.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté AstroStart VSS-113 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du AstroStart VSS-113 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation AstroStart VSS-113, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le AstroStart VSS-113 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le AstroStart VSS-113, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du AstroStart VSS-113.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le AstroStart VSS-113. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei AstroStart VSS-113 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.