Manuel d'utilisation / d'entretien du produit ConceptL26 du fabricant Loewe
Aller à la page of 44
233 –32 506 .02 4 TV Concept L 32 Concept L 32 Basic Concept L 26 Concept L 26 Basic Operating instructions 32506024.
- 2 Operating modes – PIP 22 PIP picture as freeze pictur e 22 Selecting the station of the PIP picture 22 Select the station of the TV picture (main picture) 22 PIP scan in the PIP picture 22 Inter.
3 - Remote contr ol - TV functions P+ OK P– V– V+ TV D VD VCR DISC-MENU T -C SV SP/LP 000 M E N U T E X T END INFO abc def ghi jkl mno pqrs tuv wxyz EPG A V PIP RADIO P+ OK P– V– V+ P+ OK P–.
- 4 Contr ol Unit LO EWE. + – Open control panel Display: red = standby green = operation orange = operation without scr een display (radio mode, EPG data capture or timer r ecording) Mains switch Headphones connection S-VHS connection (A VS) (i.
5 - Connections to r ear panel (1 Set-specic equipment and retrotting options for CI- Slot, PIP and satellite tuners, see pages 41 and 42. 89374.
- 6 Welcome T r ansporting Only transport the unit in an upright position. Hold the set by the top and bot- tom edges of the housing. The LCD scr een is made of glass and/or plastic and may break if not handled carefully .
7 - W elcome Note on the L CD scr een The TV set with an LCD scr een you have purchased meets the highest quality requirements and has been tested for pixel err ors. Despite the utmost caution in production of the displays, it cannot be totally ruled out that some of the pixels might be defective for technological reasons.
- 8 For your safety For your safety and to avoid unnecessary damage to your TV set, please read and observe the following safety instructions: • This TV set is designed exclusively for reception and repr oduction of video and audio signals.
9 - Connection Power mains Connect the TV set to a 220-240V/50- 60 hertz power outlet. Plug the small plug of the mains cable into the mains socket on the rear of the TV set; plug the large mains plug into a mains socket. Antennas Plug the antenna plug of your antenna/cable system or the room antenna for DVB- T into the ANT -TV socket.
- 10 First installation If the reception conditions are good, then a r oom antenna may be used for DVB- T . P assive and active room antennas are available on the market.
11 - First installation Automatic pr ogr amming Automatic programming of the TV set is started the rst time you switch it on. Follow the menus. By pressing in one of the arrow dir ections, you can choose the settings ... ... and conrm your settings by pressing OK .
- 12 Switching on/off Y our TV is equipped with an eco-standby power supply unit. On standby , the power consumption drops to low power . If you want to save even more electric- ity , switch the set off with the mains switch.
13 - Changing stations ... with the P+/P- buttons on the remote contr ol Stations up/down When changing, the station display is visible for a few seconds. If additional languages are broadcast with DVB stations, then the set displays the language/sound selection under the station display .
- 14 Basics about the menu oper ation Menus are called via the MENU button or via the button for special menus and can be hidden by using these buttons or by using the END button. The menu is displayed in the bottom section of the screen. At the top, you can see additional information for the menu point selected.
15 - Daily oper ation For the info system ... For each menu point, an info text is displayed at the top of the picture to help you with the setting. This saves you from having to refer back to the oper ating instructions. We shall demonstrate this using the station sear ch option as an example: Call the TV menu.
- 16 Daily oper ation For the index ... Using the index, you can access many operational functions directly . Y ou can also nd a great deal of information on technical terms about television.
17 - Setting the sound Volume and other fr equently used sound settings Setting the volume by using 5 or OK , you can call other sound settings ... and select using 34 ... use 6 for the related selection/setting... ... and use 34 to make the selection/setting there.
- 18 Oper ating modes – TV TV In initial installation and daily operation, the TV set is in TV mode. This is also the case when none of the other modes of operation, such as EPG, T eletext, PIP or Radio, have been selected. Each of these operating modes has a separate menu with separ ate functions for the coloured keys.
19 - Oper ating modes – TV Call additional functions Select additional functions such as T eletext subtitles, Personal teletext pages, Headphone volume, Scan stations and to move the picture up and down. Call timer overview If timer recordings have been pr ogrammed, you will see when which station is recorded her e.
- 20 DVB character set • Western European • P olish • Standar d. DVB subtitles If the station provides DVB subtitles, then you can have the TV display them permanently or suppress their display . Y ou can also select between subtitles “for translation“ or “for the Hearing Impaired“.
21 - Oper ating modes – TV Removing the CA module (Only for sets with CI slot) 1. Switch the TV set off with the mains switch. 2. Remove the cover from the back of the set on the upper left. 3. Press the eject button at the module slot; the CA module is unlocked.
- 22 Pictur e in pictur e (PIP) Note: The coloured keys do not work as described below with DVB- T stations in GB, but they operate as described on page 27 (Digital T eletext). Picture in picture displays ar e possible if the set has an analogue PIP tuner or a digital satellite tuner in addition to the analogue TV cable tuner .
23 - Oper ating modes – PIP Functions in the PIP menu In the PIP menu, you can set the PIP type (small picture or split screen) and the position of the small picture. Call the PIP menu (PIP must be active, green bar/frame). Setting the PIP type Y ou can have the PIP picture displayed as a small PIP or split scr een.
- 24 Oper ating modes – EPG If programmes ar e displayed which have not yet started, you can mark these with the OK button. The TV set then switches automatically to this station at the given time.
25 - Oper ating modes – EPG In front of the progr amme’s title, the system places an ✓ . This station is switched later to this programme when the set is switched on. If the TV is off , it switches on again automatically at the beginning of the marked programme if this has been set in the EPG menu.
- 26 In Multiple pages scroll using 34 . Y ou can see which multiples pages can be called in the bottom menu line. Call contents page 100 Call the TOP table The TOP table is a gener al list of teletext. Y ou can only call the table for stations that use the TOP oper ating system.
27 - Oper ating modes – T eletext Progr amme timer r ecor dings A video and/or DVD recorder must be connected and logged in in the connec- tion wizard. Call the progr amme pages of the current station in teletext mode using the Direct recor ding button .
- 28 Radio menu Call radio menu In the radio menu, as in TV mode, you can set the sound, search for r adio stations and store them (automatically or manually – not with DVB- T mode in GB), delete stations from the list, rearr ange them or change names and set the switching off and alarm functions.
29 - Oper ating additional equipment Search for and store the station of the video r ecorder (if no Euro- A V cable is available) Switch on the test station on the VCR or insert a recor ded tape and start play- back. In some video recorders the station must be switched on by activating the modulator .
- 30 Oper ating additional equipment Timer r ecor ding with video or DVD r ecor der Y ou can progr amme timer recordings on the TV set. Pr ogramming can be done with the EPG programme guide (not with DVB- T in GB), teletext or manually . Call the “Timer list” menu with the button and press the red colour ed key for the “Recording wizard”.
31 - Oper ating additional equipment Audio output “ AUDIO DIGIT AL OUT“ The digital audio signal is applied at the “ AUDIO DIGIT AL OUT” socket of the TV . For example, you can connect an external digital audio amplier or the Loewe Auro system here.
- 32 Oper ating additional equipment Connecting Loewe D VD Pr eceiver Aur o 2216 PS and Individual Sound loudspeaker system Y ou can pl ay a udi o si gna ls f ro m th e T V or DV D pl aye r in ci nema qu alit y w ith the se com pone nts .
33 - Oper ating additional equipment Connecting other audio ampliers or active speakers In the connection wizard, select “ HiFi/A V amplier ” under “Equipment selec- tion: audio component”.
- 34 Oper ating additional equipment HDMI (DVI) connection The HDMI connection (High Denition Multimedia Interface) allows digital picture and sound transmission via a connecting cable, e.
35 - Oper ating additional equipment Sound from PC or Set T op Box Feed the analogue audio signal from the PC or the S TB to the sockets AUDIO IN L/R on the TV via a cinch cable.
- 36 Oper ating additional equipment When operating in the VCR or DVD mode, the indicator above the VCR or DVD button lights up. In DVD mode, the following DVD players can be operated: Xemix 6122DO, 8122DA and 6222PS.
37 - What to do, if ... Problem Possible cause Remedy The “Recording” menu point is not displayed in the TV menu. No video or DVD recorder logged in. Log in the video or DVD recor der in the connection wizard and connect the device. “Connections” cannot be called in the TV menu (deactivated).
- 38 Problem Possible cause Remedy Digital Link Plus does not function. a) Euro-A V cable is not fully wired (pin 10 not wired). b) Some recorders can only adopt stations during the initial installation of the TV set. c) All or some of the terrestrial and cable stations are stored on station stor age locations ≥ 99.
39 - Gener al data T ype Concept L 26 Basic Concept L 26 Concept L 32 Basic Concept L 32 Item no. 65433xxx 65421xxx 65434xxx 65442xxx Versions TV terr . (analogue) Versions DVB- T/C Versions DVB- T CI (MHEG-5) Versions DVB- T/C CI • – – – – – • • • – – – – • • – Set dimensions without stand (ca.
- 40 T echnical data Electrical data Chassis name L 2650 Power supply 220 V -240V/50- 60 Hz T uner VHF/UHF/ cable Hyperband 8 MHz 41 MHz to 860 MHz Station storage locations 430 / for DVB 1680 TV stan.
41 - Accessories Wall holders and stands Refer to the notes on the installations options on page 6. PIP tuner The PIP tuner enables picture in picture displays (PIP) for analogue terr estrial and cable reception. Y ou can retr ot either this PIP tuner or a digital satellite tuner .
- 42 Retr otting options The following table shows the equipment and retrotting options for the individual device versions. Device version / Equipment Item no.
43 Loewe Austria GmbH Parkring 10 1010 Wien, Österreich T el.: +43 - 810/0810-24 (zum Ortstarif) E-Mail loewe@loewe.co.at International Dynamics Australasia Pty Ltd. 129 Palmer S treet Richmond 3121, Victoria, Australia T el. +61 - 3 - 94 29 08 22 Fax +61 - 3 - 94 29 08 33 Email mail@internationaldynamics.
- 44.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Loewe ConceptL26 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Loewe ConceptL26 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Loewe ConceptL26, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Loewe ConceptL26 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Loewe ConceptL26, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Loewe ConceptL26.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Loewe ConceptL26. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Loewe ConceptL26 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
