Manuel d'utilisation / d'entretien du produit 795.7202 du fabricant Kenmore
Aller à la page of 44
Use & Care Guide Manual de Uso y Cuidado Guide d'Utilisation et d'Entretien English / Espafiol / Fran_ais Models/Modelos/Mod_les: 795.7202 _ Kenmore, ® P/N MFL62184420 Sears Brands Management CorporaHon Hoffman Estates, _L 60179 U.S.A. www.
Warranty ............................................................................. 3 Protection Agreements .............................................. 4 Important Safety Instructions ........................... 5-7 Electrical & Grounding Requirements .
REFRIGERATOR WARRANTY f Kenmore Limited Warranty When this appliance is installed, operated and maintained according to all supplied instructions, the following warranty coverage applies. To arrange for warranty service, call 1-800-4-MY-HOME® (1-800-469-4663).
Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmore Elite ® product is designed and manufactured for years of dependable operation. But like all products, it may require preventive maintenance or repair from time to time.
BASIC SAFETY PRECAUTIONS This guide contains many important safety messages. Always read and obey all safety messages. This is the safety alert symbol. It alerts you to safety messages that inform you of hazards that can kill or hurt you or others, or cause damage to the product.
Before replacing a burned-out or broken light bulb, unplug the refrigerator or turn off power at the circuit breaker or fuse box in order to avoid contact with a live wire filament. (A burned-out light bulb may break when being replaced exposing the wire filament.
Your old refrigerator may have a cooling system that used CFCs or HCFCs (chlorofluorocarbons or hydrochtorofluorocarbons). CFCs and HCFCs are believed to harm stratospheric ozone if released to the atmosphere. Other refrigerants may also cause harm to the environment if released to the atmosphere.
Use this page to become more familiar with the parts and features of your refrigerator. Page references are included for your convenience. NOTE: This guide covers several different models. The refrigerator you have purchased may have some or all of the items listed below.
Excessive Weight Hazard: Use two or more people to move and install the refrigeraton Failure to do so can result in back or other injury. UNPACKING YOUR REFRIGERATOR Remove tape and any temporary labels from your refrigerator before using.
BASE GRILLE INSTALLATION To remove the base grllle: 1) Open the Freezer Drawer. (Drawer not shown for clarity.) 2) Once the drawer is open, and there is sufflcient clearance, remove the screws on the top of the cover. To replace the base grllle: Place the cover into position and then insert and tighten the screws.
NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow opening, if it is necessary to remove the handles, follow the directions below. HOW TO REMOVE REFRIGERATOR DOOR HANDLE NOTE: Handle appearance may vary from illustrations on this page.
NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow opening, if it is necessary to remove the handles, follow the directions below. HOW TO REMOVE FREEZER DOOR HANDLE NOTE: Handle appearance may vary from illustrations on this page.
REMOVING AND REPLACING REFRIGERATOR DOORS Excessive Weight Hazard: Use two or more people to remove and install the refrigerator doors. Failure to do so can result in back or other injury. Electrical Shock Hazard Disconnect the electrical supply to the refrigerator before installing.
Relnstaiilng the Refrigerator Door Left Door 1. Lower the door onto middle hinge pin (10). 2. Fit top hinge (7) over hinge lever latch (8) and into place. Rotate lever (6) clockwise to secure hinge. 3. Install the grounding screw (5) and connect the two wire harnesses (4).
HOW TO REMOVE THE FREEZER DRAWER _kWARNING: Use two or more people to remove and install the freezer drawer. Failure to do so can result personal injury or product damage. _t_CAUTION: Do not hold the handle when removing or replacing the drawer. The handle may come off and it could cause personal injury.
HOW TO INSTALL THE FREEZER DRAWER With both hands, pull out each rail simultaneously until both rails are fully extended. Make sure that you have the correct rail cover for each side.
LEVELING AND DOOR ALIGNMENT Leveling After installing, plug the refrigerator's power cord into a 3-prong grounded outlet and push the refrigerator into the final position. Your refrigerator has two front leveling legs--one on the right and one on the left.
SETTING THE CONTROLS Temperature The Refrigerator Temp Control ranges from 33°F to 46°F (O°C to 8°C). Press the Refrigerator Temp button to cycle through the available temperature settings one increment at a time. The Freezer Temp Control range is from -6°F to 8°F (-21°C to -13°C).
Temperature Mode Switch Function (°F <=>°C) If you want to convert °F to °C or vice versa, press and hold the Freezer Temp and Refrigerator Temp buttons at the same time for approximately five seconds.
IN-DOOR iCE BiN ,A_ CAUTION Keep hands and tools out of the ice compartment door and dispenser chute. Damage or personal injury may result. The icemaker will stop producing ice when the ice bin is full. If you need more ice, empty the ice bin into the extra ice bin in the freezer compartment.
AUTOMATIC ICEMAKER The icemaker wilt produce 6 cubes per cycle-- approximately 100 cubes in a 24-hour period, depending on freezer compartment temperature, room temperature, number of door openings and other operating conditions. ® ® It takes about 12 to 24 hours for a newly installed refrigerator to make ice.
AUTOMATIC ICEMAKER (continued) ACAUTION * The first ice and water dispensed may include particles or odor from the water supply line or the water tank. * Throw away the first few batches of ice (about 24 cubes). This is also necessary if the refrigerator has not been used for a long time.
FOOD STORAGE GUIDE Wrap or store food in the refrigerator in airtight and moisture-proof material unless otherwise noted. This prevents food odor and taste transfer throughout the refrigerator. For dated products, check date code to ensure freshness. items How to Butter or margarine Keep opened butter in a covered dish or closed compartment.
REFRIGERATOR SECTION WATER DISPENSER To dispense cold water, push on the dispenser switch with a glass. WATER TRAY To remove the water tray, putt up on the front and putt it out. Note: There is no drain beneath the tray. You may need to empty the tray of any liquid that collects in it.
REFRIGERATOR SHELVES The shelves in your refrigerator are adjustable to meet your individual storage needs. Your model may have glass or wire shelves. Adjusting the shelves to fit different heights of items will make finding the exact item you want easier.
HUMiDiTY CONTROLLED CRISPER The crispers provide fresher tasting fruit and vegetables by letting you easily control humidity inside the drawer. You can control the amount of humidity in the moisture- sealed crispers by adjusting the control to any setting between HiGH and LOW.
FREEZER SECTION DURABASE 1. To remove the Durabase, push it to the back as much as possible. Tilt up the front of the Durabase and putt straight out. 2. To replace, insert the Durabase in rail assembly. PULLOUT DRAWER 1. To remove, putt the drawer out to full extension.
REPLACING THE WATER FILTER CHANGE FILTER o it is recommended that you replace the water filter: * Approximately every six months. * When the water filter indicator turns on. * When the water dispenser output decreases. * When the ice cubes are smaller than normal.
Performance Data Sheet Model: GENIIO42F-08 Use Replacement Cartridge GEN11042FR-08 The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI Standard 42.
State of California Department of Public Health Water Treatment Device Certificate Number 09- 2019 Date Issued: December 15, 2009 Manufacturer: Sears Roebuck and !Co.
Explosion Hazard Use non-flammable cleaner. Failure to do so can result in fire, explosion, or death. Both the refrigerator and freezer sections defrost automatically; however, clean both sections about once a month to prevent odors. Wipe up spills immediately.
LIGHT BULB REPLACEMENT Electrical Shock Hazard Before replacing a burned-out light bulb, either unplug the refrigerator or turn off power at the circuit breaker or fuse box. NOTE: The refrigerator compartment lights Have LED interior lighting, and service should be performed by a qualified technician.
BEFORE YOU BEGIN This water line installation is not covered by the refrigerator warranty. Follow these instructions carefully to minimize the risk of expensive water damage. Water hammer (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and can lead to water leakage or flooding.
iNSTALLATiON iNSTRUCTiONS Instatl the shutoff valve on the nearest frequently used drinking water line. 1. SHUT OFF THE MAIN WATER SUPPLY Turn on the nearest faucet to relieve the pressure on the line.
8. FLUSH OUT THE TUBING Turn the main water supply on and flush out the tubing until the water is clear. Shut the water off at the water valve after about one quart of water has been flushed through the tubing.
COOLI NG Before conducting troubleshooting, make sure that the following basic requirements are met: Service Flow 0.5 gpm (1.9 lpm) Water Supply Potable Water Water Pressure 20-125 psi (138 - 862 kPa) Operating Ambient 55°F to 110°F (13°C - 43°C) Temperature Limits 115 Volts, 60 Hz, AC only, and fused Electrical Ratings at 15 or 20 amperes.
COOLING Refrigerator or Refrigerator was recently installed, it may take up to 24 hours for each compartment to Freezer section is too reach the desired temperature. warm. Air vents are blocked. Rearrange items to allow air to flow throughout the compartment.
COOLING/ICE & WATER Food is freezing Food with high water content was in the refrigerator placed near an air vent. compartment. Refrigerator temperature control is set incorrectly. Refrigerator is installed in a cold location. Frost or ice crystals form on frozen food (outside of package).
iCE & WATER Icemaker is not making enough ice (continued). Doors are opened often or for long periods of time. Doors are not closed completely. The temperature setting for the freezer is too warm. Dispensing water slowly. Water filter has been exhausted.
iCE & WATER Icemaker is not Refrigerator was recently installed or It may take up to 24 hours for each compartment to making ice. icemaker recently connected, reach the desired temperature and for the icemaker to begin making ice. Icemaker not turned on.
iCE & WATER Ice has bad taste or odor. Water supply contains minerals such as sulfur. A water filter may need to be installed to eliminate taste and odor problems. NOTE: In some cases, a filter may not help. It may not be possible to remove all minerals / odor / taste in all water supplies.
NOISE Clicking !i i_ ___ ________ ______ ________________________ !ijiBj i!iiii!i!i!i! The defrost control will click when the automatic defrost cycle begins and ends. The thermostat control (or refrigerator control on some models) will also click when cycling on and ofF.
PARTS & FEATURES Doors will not close Food packages are blocking the door Rearrange food containers to clear the door and door correctly or pop open. shelves. open. Ice bin, crisper cover, pans, shelves, Push bins all the way in and put crisper cover, pans, door bins, or baskets are out of shelves and baskets into their correct positions.
Your Home For troubleshooting, product manuals and expert advice: www.managemylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Kenmore 795.7202 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Kenmore 795.7202 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Kenmore 795.7202, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Kenmore 795.7202 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Kenmore 795.7202, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Kenmore 795.7202.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Kenmore 795.7202. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Kenmore 795.7202 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
