Manuel d'utilisation / d'entretien du produit 153.33262 du fabricant Kenmore
Aller à la page of 44
Use & Care Guide Model No. 153.332620 40 Gallon Tall 153.332640 50 Gallon Tall LLC I<enmore E lite I= _I= ;{€_'di,'ll'd: L-oa of For potable water heating only. Not suitable for space heating. Not for use in mobile homes. INSTALLER: Affix these instructions to or near the water heater.
Your safety and the safety of others is extremely important in the installation, use and servicing of this water heater. Many safety-related messages and instructions have been provided in this manual and on your own water heater to warn you and others of a potential injury hazard.
Fire Hazard Read and understand instruction manual and safety messages For continued protection against before installing, operating or riskof fire: servicing this water heater. Failure to follow instructions and • Do not install water heater on safety messages could result in carpeted floor.
SAFE INSTALLATION, USE AND SERVICE ................................................................................................. 2 Important Definitions ..............................................................................................
ELECTRICAL ............................................................................................................................................... 24 Electrical Connections ......................................................................
12 - YEAR LIMITED WARRANTY ON WATER HEATER For twelve years from the date of purchase, if this water heater is installed and operated in a single-family home in accordance with the owner's manual instructions and all local applicable plumbing codes, Sears will: .
Thank You for purchasing a Kenmore water heater. Properly installed and maintained, it should give you years oftrouble free service. If you should decide that you want the new water heater professionally installed by Sears call 1-800-4-MY-HOME ®. They will arrange for prompt, quality installation by Sears authorized contractors.
MODEL TANK CAPACITY TYPE INPUT RECOVERY MINIMUM DIAMETER HEIGHT TO NUMBER IN GALS (LTRS) OF RATE RATE GALS. VENT PIPE INCHES JACKET TOP GAS (Btu/hr) PER HOUR DIA. INCHES (mm) INCHES (mm) @ 90°F RISE (mm) 153.332620 40 (151) Natural 40,000 42.6 3 (76)or4(102) 20 (508) 58 (1473) 153.
MATERIALS NEEDED To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials, depending on your type of installation. EXPANSION TANKS FOR THERMAL EXPANSION CONDITIONS AVAILABLE IN 2 GALLONS (7.
GET TO KNOW YOUR WATER HEATER - GAS MODELS A Vent Pipe B Draft hood C Anode (Not Shown) D Hot Water Outlet E Insulation F Gas Supply Piping G Manual Gas Shut-off Valve H Ground Joint Union I Drip Leg .
This gas water heater was manufactured to voluntary safety standards to reduce the likelihood of a flammable vapor ignition incident. The new technology used in meeting these standards makes this product more sensitive to installation errors. Please review the following checklist and make any required installation upgrades or changes.
Removing the Old Water Heater Q MANUALGAS JOINT UNION CHECK WITH LOCAL UTILITY FOR MINIMUM HEIGHT ® ® ® FIGURE 2. Q Turn "OFF" the to supply gas the water heater.
Location Requirements Carbon Monoxide Poisoning Hazard Do not install in a mobile home. Do ng so can resu t n carbon monox de po son ng and death. The FVIR System is designed to reduce the risk of flammable vapor-related fires.
Pmpe_y Damage Hazard • AJJ water heaters eventually Jeak • Do not install without adequate drainage, IMPORTANT: The water heater should be located in an area where leakage of the tank or connections wilt not result in damage to the area adjacent to the water heater or to lower floors of the structure.
Explosion Hazard • Use a new CSA approved gas supply line. • Install a shut-off valve. • Do not connect a natural gas water heater to an L.P. gas supply. • Do not connect an L.P. gas water heater to a natural gas supply. • Failure to follow these instructions can result in death, explosion, or carbon monoxide poisoning.
Gas Pipe Capacity Table Explosion Hazard • Use a new CSA approved gas supply line. • Install a shut-off valve. • Do not connect a natural gas water heater to an L.P. gas supply. • Do not connect an L.P. gas water heater to a natural gas supply.
Carbon Monoxide Warning Water heater must be vented to outdoors. Vent must be installed by a qualified technician using the installation instructions. Examples of a qualified technican include: gas technicians, authorized gas company personel, and authorized service persons.
Permanent openings to the outside or additional rooms within the building FIGURE 13. All Air from the Building When additional air is to be provided to the confined area from additional room(s) within.
Gable Vent ,/to o t%a,, 'nsulation Conflne l I.. Space ii Outlet Air to the Attic 1 sq. in. per 4000 BTUH Inlet Air from the Alternative Crawl Space Air inlet I 1 sq. in. per / Open 4000 BTUH Foundation___ Vent All Air From Outdoors: Inlet Air From Ventilated Crawl Space/Outlet Air To Ventilated Attic FIGURE 15.
40 Gal. Water Heater: Align the reducer flue over top of baffle as shown in Figure 19 (NOTE: reducer flue must be installed on 40 gal. water heater above elevation 5,400 Ft. (1,646 m) from sea level). 40 & 50 Gal. Water Heaters: Align the legs of the draft hood with the slots provided.
3 FT. Minimum Support Strap_ _ Maintain L i1_---_'_ ........... Clearance* f [] _1 Vent Connector Slope Up 1/4 Inch Per Foot Minimum 2 FT. Minimum Above IJ_L _ Any Object Within rizontally , _Type B Double Wall Vent Pipe **Maintain Specified Clearance Venting Gas Vent System With Type B Double Wall Vent Pipe, FIGURE 21.
In a closed system use a ,/thermal expansion tank _r Cold Water I]Pressure Reducing inlet Valve H Valve with Bypass Hot Water,.._ Outlet =:_ [_ _Cold Water Supply/_ H_H to Fixture SupplyMain_Water Metal Drain-.., Pan 1-3/4" Depth Max. Typical water piping installation FIGURE 23.
For protection against excessive pressures and temperatures, a temperature and pressure relief valve must be installed in the opening marked "T & P RELIEF VALVE" (see Figure 25).
Electrical Connections Before plugging in the water heater, always make sure: • The Voltage and frequency correspond to that specified on the water heater. • The electrical outlet has the proper overload fuse or breaker protection. • Unit is to connect to a 120VAC electrical supply outlet (extension cord is not allowed).
Operating Instructions Read and understand these directions thoroughly before attempting to operate the water heater. Make sure the view port is not missing or damaged (See Figure 36). Make sure the tank is completely filled with water before operating the water heater.
Water Heater Operation Checking the Draft Figure 29 below shows the water heater's sequence of operation when a call for heat is initiated. The ignition control module wilt attempt to light the burner three times.
Burner Flames Inspect the burner flames through the viewport and compare them to the drawings in Figure 31. A properly operating burner should produce a soft blue flame. Blue tips with yellow inner cones are satisfactory. The tips of the flame may have a slight yellow tint.
may satisfy your normal hot water needs. If hot water use is 3. expected to be more than normal, a higher thermostat setting may be required to meet the increased demand. When leaving your 4. home for extended periods (vacations, etc.) Set the electronic control display temperature "COOLER"(_)button to its lowest setting.
Draining and Flushing Temperature and Pressure Relief Valve V! I mT:W let =1 • Hotwater discharge burn hazard. • Keep clear of relief valve discharge unit. • Temperature limiting valves are available. • Read instruction manual for safe temperature setting.
Replacement Parts IMPORTANT: The following maintenance procedures are for the FVIR System components and should be performed by a qualified technician. Replacement parts may be ordered from Sears Parts and Service Centers or by calling 1-800-4-MY-HOME (1-800-469-4663).
6. Reposition the manifold component block in the mani-fold Replacing the Manifold/Burner Assembly door opening and secure it with the retainer clip. 7. See Replacing the Manifold/Burner Assembly. External Inspection & Cleaning of the Air Intake Chamber Screen 2.
10. Replace the outer door (see item K page 10). Door Gasket Burner i Slot Viewport Manifold Tab FIGURE 40. Removing and Replacing the Gas Control Valve/Thermostat IMPORTANT: Use only factory authorized replacement parts. Removing the Gas Control Valve/Thermostat: 1.
Start Up Conditions Thermal Expansion Property Damage Hazard • Avoid water heater damage. • Install thermal expansion tank or device if necessary. • Contact qualified installer or service agency. As water is heated, it expands (thermal expansion).
Condensation Whenever the water heater is filled with cold water, some condensate will form while the burner is on. A water heater may appear to be leaking when in fact the water is condensation. This usually happens when: • A new water heater is filled with cold water for the first time.
Leakage Checkpoints 6" (152.4 mm) MAXIMUM AIR GAP O FIGURE 42. B, C, D. E, F, G, H. *Condensation may be seen on pipes in humid weather or pipe connections may be leaking. *The anode rod fitting may be leaking. Small amounts of water from temperature-pressure relief valve may be due to thermal expansion or high water pressure in your area.
Pressurized Combustion Chamber System Operational Checklist 1. Manifold gasket properly sealed. 2. Viewport not damaged or cracked. 3. Combustion chamber free of debris and undamaged. 4. Manifold component block properly installed. 5. No leaks at manifold connection.
continued: PROBLEM POSSIBLE CAUSE(S) 1. WATER LEAKS LEAKING T&P HOT WATER ODORS WATER HEATER SOUNDS SIZZLING-RUMBLING SMOKING AND CARBON FORMATION (SOOTING) HIGH OPERATION COSTS THERMOSTAT FAILS TO SHUT-OFF DRIP FROM RELIEF VALVE 2, 3. 4. 5. 6. Improperly sealed, hot or cold supply connections, relief valve, drain valve or thermostat threads.
POWER IGN HEATING CLEAN VA¢ LOCK CHECK 8CI_EH FV-SENSE E¢O LDO_W THMSTR P-ANODE P-SW OPEN SHORT b ELECTRONIC CONTROL DISPLAY Please check guidelines below. For your safety, water heater service should be performed only by a qualified service person.
6. CONTROL DISPLAY STATUS "P-SW", "OPEN", and "CLEAN SCREEN" Flashing PROBLEM SOLUTION 1. The air pressure switch contacts remain open longer than 1 1 seconds after the combustion fan is energized.
9. 10. CONTROL DISPLAY STATUS "FV-SENSE" Flashing (Continued from previous page) PROBLEM The air pressure switch contacts remain open longer than 5 seconds after the combustion fan is energized. "LDO-SW", "OPEN", and "CLEAN SCREEN" Flashing 11.
SWITCH TO OPEN DISPLAY ERROR NUMBER 7 YES NUMBER 8 I 3 MINUTE I AUTOMATIC RESET TIME DELAY A ONE HOUR 1 AUTOMATIC RESTART TIME DELAY ' I COMBUSTION FAN OFF GAS VALVE OPENS ._YES I I YES _SE CTNR{_N:_ I ...... TINO .... I I wAI_F;L_YTP_s°_ENUMBER 6 NO N_ .
KENMORE ® ELITE HIGH EFFICIENCY PCC (Pressurized Combustion Chamber) NATURAL GAS WATER HEATERS 153.332620 153.332640 40 Gallon Tall (Natural) 50 Gallon Tall (Natural) _7, _ _3 _¸ Key Parts Description 153.
43.
Your Home For troubleshooting, product manuals and expert advice: managemylife www.managemylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Kenmore 153.33262 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Kenmore 153.33262 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Kenmore 153.33262, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Kenmore 153.33262 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Kenmore 153.33262, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Kenmore 153.33262.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Kenmore 153.33262. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Kenmore 153.33262 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
