Manuel d'utilisation / d'entretien du produit LT-23C50BJ du fabricant JVC
Aller à la page of 33
1004MKH-VT -VT ©2004 VICTOR COMP ANY OF JAP AN, LIMITED 50058107 1 L T -23C50BJ WIDE LCD P ANEL TV INSTRUCTIONS ENGLISH 2 D:TEMPRar$DI00.109JVC- LT-23C50BJ-COVER-50058107.
ENGLISH - 1 - For your safety This equipment has been designed and manufactured to meet international safety stan- dards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. So, please read the points below for your own safety .
ENGLISH - 2 - DO read the operating instructions before you attempt to use the equipment. DO ensure that all electrical connections (in- cluding the mains plug, extension leads and inter-connections between pieces of equip- ment) are properly made and in accordance with the manufacturers instructions.
ENGLISH - 3 - W ARNING Fingers may be trapped under the TV causing injuries. Hold the TV at the bottom in the middle, and do not allow it to tilt up or down. The TV may fall causing injuries. Hold the bottom of the stand with your hand and tilt the TV up and down.
ENGLISH - 4 - Import ant Information Please take note EXCLUSION CLAUSE JVC shall under no circumstances be liable for loss and/or damage to the product caused by: fire; earthquake; acciden.
ENGLISH - 5 - Remote Control Buttons / I = (St and By) button TV / VCR / DVD Switch Number buttons A V button (TV , EXT -1, EXT -2, EXT-2 S, EXT -3, EXT -4, EXT -4 S or PC) BLUE / PICTURE Mode button .
ENGLISH - 6 - Control Panel Buttons With certain combinations of connectors and leads the back cover may not be easily fitted. If the cover is left off, this in no way infringes safety requirements.
ENGLISH - 7 - Using the stand This TV comes with a T able T op St and already attached. This stand can be used to adjust the direction of the TV screen 5° up, 10° down, and 20° to the left or right.
ENGLISH - 8 - Remove the terminal Cover There are connection terminals behind the covers of the rear of the TV . Remove the cover before connecting an antenna, DVD or VCR. Remove the covers by removing the hooks. When replacing the covers, place the side or bottom of the covers against the TV and insert the hooks.
ENGLISH - 9 - Where to install Locate the TV away from direct sunlight and strong lights, soft, indirect lighting is recommended for comfortable viewing.
ENGLISH - 1 0 - Preparation Install Display on solid horizontal surface such as a table or desk. For ventilation, leave a space of at least 10 cm free all around the set. T o prevent any fault and unsafe situations, please do not place any objects on top of the set.
ENGLISH - 1 1 - Connections to the RF input socket Connect the aerial or cable TV plug to the RF input socket located at the back of the TV and connect the cable plug coming out from the TV out socket located at the devices (VCR, DVB etc.) to this socket as well.
ENGLISH - 1 2 - Operating the TV You can operate your TV both using the re- mote control handset and onset buttons. First A.P.S. (Automatic Programming System) APS, searches and sorts all channels and stores them automatically on your TV , accord- ing to the transmission of programme sys- tems in your area.
ENGLISH - 1 3 - download was not performed correctly . Before trying to download again, check that: The VCR power is turned on. The VCR is T-V Link compatible. The VCR is connected to the EXT -2 . The scart cable is fully wired. Direct REC: Y ou can easily record to VCR the images that you are watching on the TV .
ENGLISH - 1 4 - Programme Selection (Previous or next programme) Press button to select the previous programme. Press button to select the next programme. Programme Selection (direct access): Press digit buttons on the remote control hand- set to select programmes between 0 and 9.
ENGLISH - 1 5 - Setting Mode As you enter the picture menu, Mode will be the first item. By pressing or button you may choose one of these options: Soft , Standard and Bright . Setting Contrast Using or button select Contrast.
ENGLISH - 1 6 - Setting Noise Reduction Using or button select Noise Re- duction. Press or button to select Noise Reduction level Off or Minimum .
ENGLISH - 1 7 - screen when the TV S tatus button is pressed or programme is changed. T o Change Audio Out Settings Audio Out is a sub-menu of Sound menu. Use this settings to adjust volume for audio out terminal which is located at the right side of the TV .
ENGLISH - 1 8 - Blue Back (During No Signal) The Blue Back Feature can be set by or button to either On or Off. T o Store Settings In Feature menu all settings are stored auto- matically . Install Menu Press " MENU " button, now you are in main menu.
ENGLISH - 1 9 - If you want to watch a VCR source from one of these modes, then it will be better to set VCR mode On . For this, while the cursor is on this item press the or buttons to set it On .
ENGLISH - 2 0 - 4. Press the GREEN button to insert the chan- nel to the chosen programme number . Autostore: T o enter Autostore menu, press the BLUE but- ton.
ENGLISH - 2 1 - Picture Mode Picture mode OSD is displayed when BLUE button is pressed. Picture mode can be changed to standard, soft, and bright. Sleep Timer Sleep Timer mode OSD is displayed when YELLOW button is pressed. The Sleep Timer is used to turn the TV off after a defined period of time after selecting this item.
ENGLISH - 2 2 - Zoom Modes Zoom mode can be changed by pressing Red button. Y ou can change the screen size ac- cording to the picture aspect ratio. Select the optimum one from the following ZOOM modes.
ENGLISH - 2 3 - PC Mode Installation Power off both Computer and Display before making any connections. Set your PCs resolution correctly before con- necting to the TV . See the table in page 30 for supported modes. Use a D-SUB cable to connect the TV's PC input to the computer's RGB output terminal.
ENGLISH - 2 4 - PC Picture Menu In the Main menu, select PC Picture using or button, then enter the PC Picture menu pressing / or OK buttons. Contrast , Bright-1 and Colour T em p . adjust- ments in this menu are identical to adjust- ments defined in TV picture menu.
ENGLISH - 2 5 - T eletext T eletext is an information system that displays text on your TV screen. Using the T eletext in- formation system you can view a page of in- formation on a subject that is available in the list of contents (index). On screen display is not available in text mode.
ENGLISH - 2 6 - Press button to display the selected T eletext page. T o exit T eletext Press button. The screen will switch to TV mode.
ENGLISH - 2 7 - signal, connect it to the EXT -3 terminal with a component video cable. Via the ANT (aerial) socket If your equipment does not have an Eurocon- nector or RCA jacks, connect it to the TV with an aerial cable. For details, see the manual provided with the equipment.
ENGLISH - 2 8 - Peripheral Equipment Connections JVC- LT-23C50BJ-50058107.p65 15.02.2005, 13:55 28.
ENGLISH - 2 9 - Peripheral Equipment Connections DECODER FOR SA TELLITE RECEIVER VIDEO HEADPHONE AUDIO Antenna Connections JVC- LT-23C50BJ-50058107.p65 15.
ENGLISH - 3 0 - PC Input T ypical Display Modes The display has a maximum resolution of 1360 x 768, vertical sync. frequency range of 50-75 Hz and a horizontal sync. frequency range of 30-69 KHz. The following table is an illustration of some of the typical video display modes.
ENGLISH - 3 1 - Tips Care of the Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer Colors of image on screen are abn.
ENGLISH - 3 2 - Specifications Broadcasting Systems P AL SECAM BG , DK, I, L, Lp Channels and VHF (VL) 46,25 MHz - 168,25 MHz Frequencies VH F (V H) 175,25 MHz - 463,25 MHz U H F 471,25 MHz - 863,25 MHz Cable TV (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté JVC LT-23C50BJ c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du JVC LT-23C50BJ - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation JVC LT-23C50BJ, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le JVC LT-23C50BJ va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le JVC LT-23C50BJ, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du JVC LT-23C50BJ.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le JVC LT-23C50BJ. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei JVC LT-23C50BJ ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
