Manuel d'utilisation / d'entretien du produit UP/DN CONVERTER L-BAND du fabricant General Dynamics
Aller à la page of 26
CG-1309 REV C FEB 2006 OPERATION & MAINTE NANCE MANUAL UP/DN CONVERTER L-BAND LT-3600 SERIES 1915 Harrison Road Longview, Texas 75604 EXPORT CONTROL WARNING - Do not disclose this document or its contents to non-U.
Integrated L-Band Up/Dn Conve rter LT3600 CG-130 9 Page 2 WARRANTY VertexRSI warrants its products for a peri od of two (2) years from the date of shipment to be free from defects caused by faulty materials or poor workmanship.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 3 TABLE OF CONTENTS Section 1 General Information ................................................................................................ 6 1.0 Introduction .............................
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 4 Section 4 Serial Command Set .............................................................................................. 20 4.0 General ......................................................
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 5 APPENDICES A Technical Manual Revision History ....................................................................................... 26 B CCA Software Revision History .......................
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 6 SECTION 1 General Information 1.0 INTRODUCTION This manual contains installation, operation, and maintenance information for th e Integrated L-Band Up/Dn Converter manufactured by VertexRSI, Longview, Tx.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 7 1.4 SPECIFICATIONS The specifications for the Integrated L-Band Up/Dn Converter are listed in Table 1-1, along with the mechanical dimensions. 1.5 FRONT PANEL All the operating controls and indicators for the Integrated L-Band Up/Dn Converter are located on the front panel.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 8 1.8 Part Number Configuration The Part Number Selection Chart shows configurati on options that are set at the factory prior to shipment.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 9 Table 1-1 Integrated L-Band Specifications UPCONVERTER Input Frequency Range 50 to 90 MHz Input Impedance 50 Ohms Input Level Range -20 to -40.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 10 Table 1-1 Integrated L-Band Specifications OPTIONAL INTERNA L REFERENCE Reference Frequency 10.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 11 Table 1-1 Integrated L-Band Specifications INTERFACE AND CONNECT ORS Voltage (auto-ranging) 115/230 VAC + 15% Internal Electronics (Power) 25.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 12 SECTION 2 Installation 2.0 INTRODUCTION This section defines th e installation require- ments by which the Integrated L-Band Up/Dn Converter will meet the published specifications.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 13 2.4.6 External 10 MHz Input (J2) This connector is a BNC female. The male mate (not supplied) should be compatible with the 50-ohm coax used to connect to the system.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 14 SECTION 3 Operation 3.0 INTRODUCTION The Up/Down Converter can be controlled from the front panel or remotely via a serial bus located on the rear panel of the converter. Various menus are available for EDIT and DISPLAY purposes.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 15 Figure 3-2 Menu Listing RefOsc: OK Ofst:127 Slope Factor: 0 dB Unit Address: xx xx = 422 Mode Brd SN 1234 20/12/04 S/W:v7.70 Temp: 32 C Front Panel SW v 5.20 FP Alarm Tone: On UC 1200.000 +25.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 16 Figure 3-3 Satellite Memory UC 0950.000 +10.0 dB DC 1525.000 +30.0 dB HIT ANY KEY (0-9) Example (KEY 0) EDIT ENT ENTER KEY RECALLS MEMORY TO ACTIVE UC0 1200.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 17 3.1 StarSwitch Operation The LT3600 UP/DOWN Converter may be used in conjunction with the StarSwitch to provide redundancy switch over operations if configured as StarSwitch Ready. The following modes of operation may be selected.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 18 3.1.4 Backup Converter Operation The Backup Converter must be programmed to store all of the Converter Fre quencies and Gains in the system, in its Satellite Memory Locations, correspondi ng to the Converter Num ber (1 to 8) labeled on the StarSwitch Interface cables.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 19 3.2 Front Panel Alarm Settings Menu Page Acti ve Modes Mask (Default) Comment 1) Starswitch Auto ON STBY Auto Must select "Auto" Mode when Starswitch is not present. Forces summary alarm to OFF (see Stars witch operation).
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 20 SECTION 4 Serial Command Set 4.0 GENERAL The standard Up/Dn Converter is controlled via a rear panel seri al link (RS-422/485)(Reconfigurable to RS-232). With the front panel control, a user can operate the L-Band Up/Dn Converter from its front panel as well as from the serial link.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 21 4.3 COMMANDS 4.3.1 Set UP/Converter Frequency {aaC1xxxxx} Where xxxx(x) = First 4 numeric data characters Range: 0950 to 1525 (MHz) for Std. Band units Range: 0950 to 1950 (MHz) for Extended Band units Where (xxxx)x = Fifth character is fractional MHz as follows 0 = 0.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 22 4.3.7 DOWN/Converter (LNB) Spectrum Control {aaC7x} Where x = 0 for Non-Inverting spectrum and x = 1 for Inverting spectrum 4.3.8 UP/Converter Spectrum Control {aaC7TXz} Where z = 0 for Non-Inverting spectrum and z = 1 for Inverting spectrum 4.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 23 4.4 STATUS REQUESTS 4.4.1 Command Status {aaS1} Returns: {aaS1bbbbccccddddeeeefffUL} Where bbbb = Up/Converter Frequency (as above) cccc = Down/Converter Frequency (as above) dddd = Up/Converter Gain eeee = Down/Converter Gain fff = Ref.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 24 4.4.4 L-Band Status {aaS3} Returns: {S3bbCddTReeN} Where: bb = 2 Chars., LNB current Detection Range: 00 to 99 ( 0 - 990 mA) C = 1 Character,.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 25 4.4.9 Query Card Type {aaZ} Returns: {aaZxx} Where: xx = L-Band Card Type (1 – 8) 10 = 70 MHz IF, Std. Band Unit (SBU) 20 = 140 MHz IF, SBU 11 = 70 MHz IF, Ext Band Unit (EBU) 21 = 140 MHz IF, EBU 50 = 70 MHz IF, SBU with Inv.
Integrated L-Band Up/Dn Conve rter LT 3600 CG-1309 Page 26 Appendix A Manual Revision Hist ory C – Add Starsw menu M. Neely 2-03-05 D. Snyder 2-03-05 6323 B – Add Satellite Menu Info M. Neel y 10-14-05 D. Snyder 10-5-05 6129 A – Gain signs M. Neely 8-15-05 D.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté General Dynamics UP/DN CONVERTER L-BAND c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du General Dynamics UP/DN CONVERTER L-BAND - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation General Dynamics UP/DN CONVERTER L-BAND, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le General Dynamics UP/DN CONVERTER L-BAND va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le General Dynamics UP/DN CONVERTER L-BAND, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du General Dynamics UP/DN CONVERTER L-BAND.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le General Dynamics UP/DN CONVERTER L-BAND. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei General Dynamics UP/DN CONVERTER L-BAND ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
