Manuel d'utilisation / d'entretien du produit echoMAP 70s du fabricant Garmin
Aller à la page of 38
GPSMAP ® 500/700 Series and echoMAP ™ 50/70 Series Owner’s Manual February 2013 190-01556-00_0A Printed in Taiwan.
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements.
Table of Contents Introduction .................................................................... 1 Device Views ............................................................................ 1 echoMAP 70 Series and GPSMAP 700 Series .................
Viewing Tide Station, Current Station, or Celestial Information for a Different Date ........................................... 13 Viewing Information for a Different Tide or Current Station 13 Viewing Almanac Information from the Navigation Chart ..
Setting the Keel Offset ........................................................ 23 Calibrating a Water Speed Device ...................................... 23 Setting the Water Temperature Offset ................................ 24 Communications Settings .
.
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Device Views echoMAP 70 Series and GPSMAP 700 Serie.
2 Insert the memory card Á with the label facing to the right. 3 Press the card in until it clicks. 4 Close the door. Charts and 3D Chart Views The chartplotters have a basic imagery map. The charts and 3D chart views listed below are available on the chartplotter.
NOTE: Auto Guidance is available with premium charts, in some areas. 1 From the Navigation chart or Fishing chart, select a location. 2 If necessary, select Select . 3 Select Navigate To . 4 Select an option: • To navigate directly to the location, select Go To .
station indicator, the height of the tide at the station appears above the station indicator. Current direction indicators appear as arrows on the chart. The direction of each arrow indicates the direction of the current at a specific location on the chart.
When course over ground and heading information are provided by an activated AIS target, but rate of turn information is not provided, the projected course of the target is calculated based on the course over ground information.
Chart Setup : See page 6 . Overlay Numbers : See page 6 . This might appear in the Chart Setup menu. Chart Appearance : See page 6 . This might appear in the Chart Setup menu. Navigation and Fishing Chart Setup NOTE: Not all settings apply to all charts and 3D chart views.
Lane Width : Specifies the width of the navigation lane, which is the magenta line in some chart views that indicates the course to your destination. Other Vessels Settings on the Charts and Chart Views NOTE: These options require connected accessories, such as an AIS receiver or VHF radio.
You can select or to view additional information or to show the location on a chart. Courses CAUTION The Auto Guidance feature is based on electronic chart information.
and avoid any land, shallow water, or other obstacles that may be in your path. When using Go To, a direct course and a corrected course may pass over land or shallow water. Use visual sightings, and steer to avoid land, shallow water, and other dangerous objects.
• To navigate the route from the starting point used when the route was created, to the right of the original route, select Forward – Starboard . • To navigate the route from the destination point used when the route was created, to the left of the original route, select Backward – Port .
• To record the track plot based on a variance from your course, select Resolution > Change , and enter the maximum error allowed from the true course before recording a track point. Deleting All Saved Waypoints, Routes, and Tracks Select Nav Info > Manage Data > Clear User Data > All > OK .
You can display the total amount of fuel on-board either as a numeric display that shows the total fuel or as a graphic display that shows the level in each fuel tank.
Viewing Tide Station, Current Station, or Celestial Information for a Different Date 1 Select Nav Info > Tides & Currents . 2 Select Tides , Currents , or Celestial . 3 Select an option. • To view information for a different date, select Change Date > Manual , and enter a date.
• To show data from a 200 kHz sonar signal, select 200 kHz . This is useful mainly for more-shallow, inland waters. • To show data from an 77 kHz sonar signal, select 77 kHz . This is useful mainly for deeper waters and to see better fish arches in shallow water.
Radar Display Modes NOTE: Not all modes are available with all radar devices and all chartplotters. Select Radar , and select a mode. Cruising Mode : Shows a full-screen image of the gathered radar information. Harbor Mode : Intended for use in inland waters, this mode works best with short-range signals (2 nm or less).
Marking a Waypoint on the Radar Screen 1 From a Radar screen or the Radar overlay, select a location. 2 Select Create Waypoint . Viewing a List of AIS Threats From any Radar screen or the Radar overlay, you can view and customize the appearance of a list of AIS threats.
may differ from the automatic gain setting used for another mode. NOTE: Depending upon the radar in use, the gain setting configured for use in one radar mode may or may not be applied to other radar modes or to the Radar overlay. From a Radar screen or the Radar overlay, select Menu > Gain > Auto .
Rings : Shows the range rings that help you to visualize distances on the radar screen. Nav. Lines : Shows the navigation lines that indicate the course you have set using Route To, Guide To, or Go To.
2 Select a position-report call. 3 Select an option: • To switch to position report details, select . • To switch to a Navigation chart marking the location, select . Navigating to a Tracked Vessel 1 Select Nav Info > Other Vessels > DSC List .
chartplotter. The weather data for each feature comes from reputable weather data centers such as the National Weather Service and the Hydrometeorological Prediction Center.
• To view the weather forecast for the previous 12 hours, select Previous Forecast or , and to view previous forecasts, up to 48 hours ago, in 12-hour increments, select Previous Forecast or again. Viewing a Marine Forecast or an Offshore Forecast 1 Select Weather > Forecast .
screen. Variations in the visibility shading show the forecast change in surface visibility. Select Weather > Visibility . Viewing Forecast Visibility Information for Another Time Period 1 Select Weather > Visibility .
System Settings Select Settings > System . Display : Adjusts the backlight brightness and color scheme. Beeper : Turns on and off the tone that sounds for alarms and selections. Auto Power : Turns the device on automatically when power is applied ( page 22 ).
Setting the Water Temperature Offset Before you can set the water temperature offset, you must have a NMEA 0183 water-temperature sensor or a temperature- capable transducer to measure water temperature. The temperature offset compensates for the temperature reading from a temperature sensor.
Connecting a Wireless Device to the Chartplotter Before you can connect a wireless device to the chartplotter wireless network, you must configure the chartplotter wireless network ( page 24 ). You can connect a wireless device to the chartplotter to share data.
Adjusting the Distance from Shore CAUTION The Auto Guidance feature is based on electronic chart information. That data does not ensure obstacle and bottom clearance. Carefully compare the course to all visual sightings, and avoid any land, shallow water, or other obstacles that may be in your path.
3 Select an option: • To create a new file, select Add New File , and enter a name. • To add the information to an existing file, select the file from the list.
Type Sentence Description GPGGA GGA: Global positioning system fix data GPGLL GLL: Geographic position (latitude and longitude) GPGSA GSA: GNSS DOP and active satellites GPGSV GSV: GNSS satellites in .
Index A aerial photos 4 AIS 4, 5, 7 alarm 5 distress signal device 5 radar 16 SART 5 targeting 4, 5 threats 5, 16 turning on 26 vessels 5 alarms 25 anchor drag 25 a.
settings 22–25 radar display 17 system information 23, 26 shoreline distance 26 SiriusXM 20 SiriusXM Satellite Radio 22 software, updating 27 sonar 13 a-scope 14 alarms .
.
www.garmin.com/support 913-397-8200 1-800-800-1020 0808 238 0000 +44 870 850 1242 1-866-429-9296 +43 (0) 820 220 230 +32 2 672 52 54 +45 4810 5050 +358 9 6937 9758 + 331 55 69 33 99 +49 (0)1805-427646.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Garmin echoMAP 70s c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Garmin echoMAP 70s - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Garmin echoMAP 70s, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Garmin echoMAP 70s va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Garmin echoMAP 70s, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Garmin echoMAP 70s.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Garmin echoMAP 70s. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Garmin echoMAP 70s ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
