FR
DCS logo
Notice d'utilisation officielle

DCS BGS-3048

16 pages·911 KB·Cuisinière·PDF·ENDEITNLJA
DCS BGS-3048
Table des matières 19 sections BACKGUARD SYSTEM FOR RANGES Installation Guide · MODELS: BGS-3030 BGS-1230 BGS-3036 · BGS-1236 BGS-3048 BGS-1248 · A MESSAGE TO OUR CUSTOMERS · … AfficherMasquer
Page 1 of the DCS BGS-3048 user manual — MODELS: BGS-3030 BGS-1230 BGS-3036
Page 1 · cliquer pour agrandir
Page 1

BACKGUARD SYSTEM FOR RANGES Installation Guide

DCS BGS-3048 — BACKGUARD SYSTEM FOR RANGES Installation Guide diagram (page 1)
Fig. 1 · BACKGUARD SYSTEM FOR RANGES Installation Guide

MODELS: BGS-3030 BGS-1230 BGS-3036

BGS-1236 BGS-3048 BGS-1248

Page 2 of the DCS BGS-3048 user manual — BACKGUARD SYSTEM FOR RANGES Installation Guide
Page 2 · cliquer pour agrandir
Page 2
Page 2 of the DCS BGS-3048 user manual — BACKGUARD SYSTEM FOR RANGES Installation Guide
Page 3 of the DCS BGS-3048 user manual — A MESSAGE TO OUR CUSTOMERS
Page 3 · cliquer pour agrandir
Page 3

A MESSAGE TO OUR CUSTOMERS

Thank you for selecting this Backguard System. Because of the unique features of this accessory we have developed this Installation Guide. It contains valuable information on how to install your new Backguard System. Keep this guide handy, as it will help answer questions that may arise as you use your new accessory.

For your convenience, product questions can be answered by a DCS Customer Care Representative by phone: 1-888-281-5698, email: support@dcsappliances.com, or by mail:

Fisher & Paykel Appliances, Inc. Attention: DCS Customer Care 5900 Skylab Road Huntington Beach, CA 92647

www.dcsappliances.com

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

DANGER If You Smell Gas: 1. Do not try to light any appliance. 2. Do not touch any electrical switch; do not use any phone in your building. 3. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. 4. If you cannot reach your gas supplier, call the fire department. 5. Installation and service must be performed by a qualified installer, service agency or the gas supplier.

WARNING! To reduce the risk of injury to persons in the event of a cooktop grease fire, observe the following: Turn burner off first. Smother flames with a close-fitting lid, cookie sheet, metal tray, baking soda or use a dry chemical or foam- type fire extinguisher. Be careful to prevent burns. If the flames do not go out immediately evacuate and call the fire department. Never pick up a flaming pan - You may be burned. DO NOT USE WATER ON GREASE FIRES, including wet dishcloths or towels - a violent steam explosion will result. Use an extinguisher ONLY if: 1. You know you have a Class ABC extinguisher, and you already know how to operate it. 2. The fire is small and contained in the area where it started. 3. The fire department is being called. 4. You can fight the fire with your back to an exit. WARNING! Do not place items of interest to children on racks or appliance. Children could be seriously injured if they should climb onto or into the appliance to reach these items.

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.

Page 5 of the DCS BGS-3048 user manual — A
Page 5 · cliquer pour agrandir
Page 5

SPECIFICATIONS

B

MODEL A

B

RACK (13-5/8")

RACK (16-5/8")

QTY.

QTY.

BGS-123029-7/8"10-1/8"-- BGS-3030 BGS-123629-7/8" 35-7/8"28-1/8" 10-1/8"2 -- - BGS-303635-7/8"28-1/8"-2 BGS-124847-7/8"10-1/8"-- BGS-304847-7/8"28-1/8"21

A

B

A

WALL MOUNT LOW BACKGUARD INSTALLATION

1. Locate and level range per installation instructions.
2. After unpacking all backguard system parts, locate the Back Section 1/8” above and centered over the Island Trim attached to the range.* Secure Back Section to wall with the appropriate fasteners (not supplied)(fig. 01).

*After 1/8” is located, slots in back section may be used to adjust spacing between range island trim and backguard for a flush fit.

3. Secure Front Section of backguard to Back Section with #8 self-tapping sheet metal screws supplied (fig. 02).
DCS BGS-3048 — A diagram (page 5)
Fig. 2
DCS BGS-3048 — A diagram (page 5)
Fig. 3

Slots to choose desired spacing between Range Island Trim and Backguard.

16” for 30” 36” for 36/48”

# 8 Self-tapping sheet metal screws

Fig.01 Fig.02

Show 8 more labels / short text on this page
8-3/4 " · 12 " · 1-5/16 " · 1-5/16 " · Front Section · Back Section · Back Section · Island Trim
Page 6 of the DCS BGS-3048 user manual — RECOMMENDED INSTALLATION ORDER:
Page 6 · cliquer pour agrandir
Page 6

WALL MOUNT FULL BACKGUARD INSTALLATION

RECOMMENDED INSTALLATION ORDER:

1) VENT HOOD 2)BACKGUARD SYSTEM 3) RANGE

1. Locate and level range per installation instructions.
2. After unpacking all backguard system parts, locate the Back Section 1/8” (see fig. 03) above and centered over the Island Trim attached to the range.* Secure Back Section to wall with the appropriate fasteners (not supplied) to anchors or wood stud (fig. 03).

*After 1/8” is located, slots in back section may be used to adjust spacing between range island trim and backguard for a flush fit.

3. Attach rod, end caps and center stanchion to Front Section of backguard with #10 machine screws supplied (fig. 04).
4. Bend wedge-shaped tabs down on top of the front section approximately 3/16”. When mounting the front section, insure that these tabs engage the mating holes in the top of the rear section (see fig. 05, page 4).
5. Secure Front Section of backguard to Back Section with #8 self-tapping sheet metal screws supplied (fig. 05, page 4).
6. Attach racks to rod (fig. 06, page 4). The maximum weight placed on each rack should be 10 lbs.
DCS BGS-3048 — RECOMMENDED INSTALLATION ORDER: diagram (page 6)
Fig. 4

Bend down approx. 3/16”

Slots to choose desired spacing between Range Island Trim and Backguard.

16” for 30” 36” for 36/48”

Fig.03 Fig.04

Show 8 more labels / short text on this page
Back Section · Front Section · End Cap · Center Stanchion · #10 Machine Screws · Rod · End Cap · Island Trim
Page 7 of the DCS BGS-3048 user manual — WALL MOUNT FULL BACKGUARD INSTALLATION
Page 7 · cliquer pour agrandir
Page 7

WALL MOUNT FULL BACKGUARD INSTALLATION

DCS BGS-3048 — WALL MOUNT FULL BACKGUARD INSTALLATION diagram (page 7)
Fig. 5
DCS BGS-3048 — WALL MOUNT FULL BACKGUARD INSTALLATION diagram (page 7)
Fig. 6

#8 Self-tap- ping sheet metal screws

Fig.05 Fig.06

*Insure tabs and holes engage to secure top of backguard.

CARE AND MAINTENANCE This is made of stainless steel. Use the mildest cleaning procedure first. Hot soapy water, rinse and dry. If the panel has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple Green® or Formula 409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in the direction of the grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic®. If the rear top burners are used extensively on high it is possible for the vertical stainless steel panel to discolor from the burner heat. This discoloration can be removed by using Revere Ware Stainless Steel Cleaner.

Show 5 more labels / short text on this page
Front Section · Holes* · Back Section · Rack · Tabs*
Page 8 of the DCS BGS-3048 user manual — NOTES
Page 8 · cliquer pour agrandir
Page 8

NOTES

Page 9 of the DCS BGS-3048 user manual — MODÈLES : BGS-3030 BGS-1230 BGS-3036
Page 9 · cliquer pour agrandir
Page 9

DOSSERET POUR CUISINIÈRES Guide d'installation

MODÈLES : BGS-3030 BGS-1230 BGS-3036

BGS-1236 BGS-3048 BGS-1248

Sources

Références et liens

Pages mentionnées dans ce manuel — fabricant, assistance et téléchargements.

Poser une question sur : DCS BGS-3048

Les utilisateurs et notre équipe répondent généralement sous 24 h — et votre question servira aussi aux suivants.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Aucune question pour l'instant sur le DCS BGS-3048

Soyez le premier à poser une question — d'autres utilisateurs ou notre équipe y répondront.

Document d'origine

DCS BGS-3048 manuel PDF

16 pages·911 KB·Cuisinière·PDF
Cliquez sur une page ci-dessus pour l'ouvrir ici
Page 1 / …
100%
Chargement des pages…