Manuel d'utilisation / d'entretien du produit CANTFS-03-NG du fabricant Cannon
Aller à la page of 24
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS.
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteri.
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor .
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone.
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment.
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position.
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7.
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs.
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installatio.
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set.
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front.
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front.
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set.
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installatio.
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs.
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7.
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position.
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment.
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone.
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor .
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteri.
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Cannon CANTFS-03-NG c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Cannon CANTFS-03-NG - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Cannon CANTFS-03-NG, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Cannon CANTFS-03-NG va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Cannon CANTFS-03-NG, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Cannon CANTFS-03-NG.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Cannon CANTFS-03-NG. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Cannon CANTFS-03-NG ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
