Manuel d'utilisation / d'entretien du produit 10066250 du fabricant Windsor
Aller à la page of 24
86221970 PRV NO 980282 H AUTOMATIC SCRUBBER MODELS: SCC172 QSCC172 SCH172 10066320 10066300 10066350 SCHC172 HCC172 QSCC172IA 10066330 10066270 10066310 QSCC172IS AS17 AS17B 10066080 10066210 10066220.
MACHINE DATA LOG/OVERVIEW 86221970 17” SCRUBBER 01/03/07 2 OVERVIEW The Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution o nto a hard floor, scrubs the floor with a brush or pad, and then vacuums the soiled water back into the recovery tank.
TABLE OF CONTENTS 86221970 17” SCRUBBER 01/03/07 3 Machine Data Log/ Overview . ............................... 2 Table of Co ntents ................................................. 3 HOW TO USE THIS MANUAL How to use this Manual. .................
HOW TO USE THIS MANUAL 86221970 17” SCRUBBER 01/03/07 1-1 This manual contains the f ollowin g sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts.
86221970 17” SCRUBBER 01/03/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using a battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFO RE USING THIS MACHINE. To reduce the risk of fire, electric sho ck, or injury : Use only indoors.
HAZARD INTENSITY LEVEL 86221970 17” SCRUBBER 01/03/07 2-2 The following symbols are used throughout this guide as indicated in the ir descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY.
SAFETY LABEL LOCATION 86221970 17” SCRUBBER 01/24/07 2-3 NOTE: These drawings indicate the location of safet y labels on the machine . If at any time the labels become illegible, promptly replace them. OR FIRE. DO NOT USE OR MATERIALS CA N CAUSE EXPLOSI ON FLAMMABLE MATERI AL.
TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-1 ITEM DIMENSION/CAPACITY Rated Voltage 24 VDC Rated Amperage 30 Amps Batteries 2 x 12 Volt 105-130 AH Scrub Brush Motor 0.75hp (0.56 kw) Vacuum Motor 24 VDC 2 stage by pass Mass (GVW) 319 lbs (144.
TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-2 ITEM MEASURE Height 35 in (0.89 m) Length 42 in (1.07 m) Width without squeege e 20 in (0.51 m) Width of squeegee 31 in (0.79 m) Width of scrub path 17 in (0.43 m) SPECIAL NOTES: The A-weighted sound pressure level em itted by the appliance was measu red t o be 74.
HOW THIS MACHINE WORKS 86221970 17” SCRUBBER 01/03/07 3-3 This Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a clea ning solution onto a hard floor, scrubs the floor with a bru sh, and t hen vacuums the soiled water back into the recovery tank.
COMPONENTS 86221970 17” SCRUBBER 01/03/07 3-4 14 13 12 11 10 9 8 7 6 5 4 3 2 1 1. Control Panel 2. Control Handle 3. Recovery Tank 4. Recovery Tank Drain Hose 5. Recovery Tank Domel 6. Scrub Brush/Pad 7. Solution Tank 8. Solution Tank Cover 9. Solution Tank Drain Hose 10.
CONTROLS 86221970 17” SCRUBBER 01/03/07 3-5 1. Solution Control Lev er 2. Brush Switch 3. Brush Lift Pedal 4. Vacuum Switch 5. Squeegee Lift Lever 6.
CONTROLS 86221970 17” SCRUBBER 01/03/07 3-6 1. SOLUTION CONTROL LEVER Controls solution flow to scrub deck. To increase flow push the kno b forward to the desired flow. To decrease flow pull the knob back. 2. BRUSH SWITCH Controls the scrub brush motor.
MACHINE OPERATIONS 86221970 17” SCRUBBER 01/03/07 3-7 PRE-RUN MACH IN E INSPECTION Do a pre-run inspection to find possi ble problems that could cause poor perf ormance or lost time from breakdown. Follow the same pro cedure each time to avoid missing steps.
MACHINE OPERATION 86221970 17” SCRUBBER 01/03/07 3-8 TO BEGIN SCRUBBING When operating the machine around people, pay close attention for unexpecte d movement. Use extra caution around children. Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-1 BATTERIES (WET CELL BATTERIES ONLY) The batteries provide the power to ope rate the machine. The batteries require regul ar maintenance to keep them operating at peak efficiency.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-2 CHECKING BAT TERY SPECIFIC GRAVITY Use a hydrometer to chec k the battery specific gravity. CHECKING GRAVITY A. Hydrometer B. Battery NOTE: Do not take readings immediately after adding distilled water, if the water and acid are not thoroughly mixed, the readi ng m ay not be accurate.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-3 MACHINES WITHOUT ON BOARD CHARGER Use a 24 volt, 12 amp maximum output, DC charger which will automatically shut off when the batteries are fully charged to charge the two battery pack. 1. Stop the machine in a clean, well ventilated area next to the charger.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-4 SCRUB BRUSHES NOTE: All original equipment brushes a re equi pped with “Perform Alert © ”. This feature will tell the operator when it is time to replace the scrub brush. “Perform Alert © ” brush es have pre-trimm ed bright yellow tufts to indicate the length of a worn out brush.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-5 REPLACING OR REMOVING SCRUB BRUSHES 1. Turn the machine off. FOR SAFETY: Before leavi ng or serv icing the machine; stop on level surfac e, turn OFF machine. 2. Raise the scrub deck up by pushin g down on the pedal.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-6 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY ANNUALLY Check battery acid level * Check vac hose connections * Clean the squeegee blades * Inspect .
TROUBLESHOOTING 86221970 17” SCRUBBER 01/03/07 4-7 PROBLEM CAUSE SOLUTION Poor or no water pick-up Debris caught on sque egee Remove debris Worn squeegee blades Repl ace squeegee blade s Vacuum hose.
TROUBLESHOOTING 86221970 17” SCRUBBE R 01/03/07 4-8 PROBLEM CAUSE SOLUTION Little or no solution flow to the floor Solution tank empty Fill solution tank Solution flow turned off or set too low Turn.
NOTES: 86221970 17” SCRUBBER 01/03/07 4-9.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Windsor 10066250 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Windsor 10066250 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Windsor 10066250, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Windsor 10066250 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Windsor 10066250, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Windsor 10066250.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Windsor 10066250. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Windsor 10066250 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
