Manuel d'utilisation / d'entretien du produit 2477CE du fabricant Vermont Casting
Aller à la page of 28
DO NOT DISCARD THIS MANUAL: Retain for future use 30003849 8/08 Rev . 2 2278 Dutchwest noncat cover 5/04 Homeowner ’ s Installation and Operating Manual If this heater is not properly installed, operated, and maintained, a house fire may result. For safety , follow all installation, operation and maintenance directions.
2 Dutchwest Non-Catal ytic Con vection Heater 30003849 The Dutchwest Model 2477CE covered in this Owner ’ s Guide has been tested and listed to current standards. The test standards utilized were UL 1482 for the United States and EN13240:2001 + A2:2004 for Europe.
3 Dutchwest Non-Catal ytic Con vection Heater 30003849 Specifications Fig. 1 Dutchwest Convection Heater specifications. Model 2477CE A 610 mm (24”) B 622 mm (24 ¹⁄₂ ”) C 756 mm (29 ³⁄.
4 Dutchwest Non-Catal ytic Con vection Heater 30003849 Installation SAFETY NOTICE: IF YOUR DUTCHWEST CON- VECTION HEA TER IS NOT PROPERL Y INST ALLED, OPERA TED AND MAINT AINED, A HOUSE FIRE MA Y RESUL T . FOR SAFETY , FOLLOW ALL INST ALLA- TION, OPERA TION AND MAINTENANCE DIREC- TIONS.
5 Dutchwest Non-Catal ytic Con vection Heater 30003849 ST241 chimney types 12/13/99 djt Prefabricated Double-W all Insulated Chimney T ile Lined Masonry Chimney ST241 Fig. 2 If in sound condition and approved for use, either a masonry or a prefabricated chimney may be used.
6 Dutchwest Non-Catal ytic Con vection Heater 30003849 Single-W all Connector The single-wall chimney connector should be made of 24 gauge or heavier steel, and must have a minimum internal diameter of 152 mm (6”) for model 2477CE. Install single-wall chimney connector not less than 457 mm (18”) from the ceiling.
7 Dutchwest Non-Catal ytic Con vection Heater 30003849 Securing the Connector to a Masonry Chimney The Dutchwest Convection heater may be connected to either a freestanding masonry chimney or a masonry fireplace chimney .
8 Dutchwest Non-Catal ytic Con vection Heater 30003849 ST797 thru fireplace 5/04 Flue Liner Extend Chimney Con- nector to the First T ile of the Flue Liner Observe Miniumum Clearances Damper Plate is Removed or Locked in Open Position Close Off the Damper Opening with Sheet Metal and Sealant ST797 Fig.
9 Dutchwest Non-Catal ytic Con vection Heater 30003849 Fireplace Installations The Dutchwest Model 2477CE has a reversible flue col- lar to allow for either top exit or rear exit installations. Y ou may install your Dutchwest Model 2477CE in an existing fireplace as a fireplace insert with no legs, or with the standard legs attached.
10 Dutchwest Non-Catal ytic Con vection Heater 30003849 Clearances As with any solid fuel heating stove, extremely high surface temperatures can occur , particularly in the event of uncontrolled operation, e.g. if the doors are inadvertently left open.
1 1 Dutchwest Non-Catal ytic Con vection Heater 30003849 Y our convection heater requires some assembly . Follow the directions carefully and refer to the parts diagram at the back of this manual. Unpack the Parts Remove the bottom heat shield strapped to the top of the stove and all loose parts from the firebox and the ash pan.
12 Dutchwest Non-Catal ytic Con vection Heater 30003849 6. Reposition the stove so the other front corner over- hangs the pallet and remove the leg bolt from the bottom of the stove. Align the leg with the bolt hole in the bottom of the stove, and attach it with the bolt and washer .
13 Dutchwest Non-Catal ytic Con vection Heater 30003849 Heater Controls and Features Air Control The Dutchwest Convection Heater Model 2477CE has a control that regulates the amount of air drawn into the stove.
14 Dutchwest Non-Catal ytic Con vection Heater 30003849 Successful Wood Burning Woodburning is often said to be more of an art than a science. Y ou’ll easily master the art if you start by using good, dry fuel and by understanding how the stove’s air supply system operates.
15 Dutchwest Non-Catal ytic Con vection Heater 30003849 Use the Air Control Settings that Work Best for Y ou No single control setting will fit every situation. Each installation will differ depending on the quality of the fuel, the amount of heat desired, and how long you wish the fire to burn.
16 Dutchwest Non-Catal ytic Con vection Heater 30003849 Y ou’ll soon find that this stove is HOT WHILE IN OPER- A TION! KEEP CHILDREN, CLOTHING, AND FURNI- TURE A W A Y . CONT ACT MA Y CAUSE SKIN BURNS. DO NOT OVERFIRE THIS HEA TER. Overfiring may cause a house fire, or can result in permanent damage to the stove.
17 Dutchwest Non-Catal ytic Con vection Heater 30003849 Remove Ashes Frequently Wear heavy stove gloves when removing ashes. Check the ash compartment before reloading the stove. If the ash pan is nearly full, empty the pan. Before replacing the ash pan, clear away any ash that may have spilled over the sides and back of the pan.
18 Dutchwest Non-Catal ytic Con vection Heater 30003849 Below you will find important information on general care, inspection and maintenance of your Dutchwest stove. Should it become necessary , use only replace- ment parts recommended by your authorized dealer .
19 Dutchwest Non-Catal ytic Con vection Heater 30003849 3. Apply a thin bead of stove cement in the newly- cleaned groove. 4. Lay the gasket into the groove. Wait until you are a couple inches from the end before you cut it. 5. T est the gasket by closing the door on a slip of paper as described above.
20 Dutchwest Non-Catal ytic Con vection Heater 30003849 Cleaning the Chimney System The chimney system is composed of the chimney and the pipe that connects the stove to the chimney . Inspect the chimney and chimney connector at least twice monthly , and clean if necessary .
21 Dutchwest Non-Catal ytic Con vection Heater 30003849 • Inspect for and remove ash build-up behind the com- bustion package. This should be done in conjunction with annual cleaning of the chimney connector since this inspection is most conveniently done through the flue collar opening.
22 Dutchwest Non-Catal ytic Con vection Heater 30003849 if the chimney flue has a cross-sectional volume much larger than the stove outlet. Steel Chimney Most factory-made ‘Class A ’ steel chimneys have a layer of insulation around the inner flue.
23 Dutchwest Non-Catal ytic Con vection Heater 30003849 Creosote Creosote is a by-product of low-temperature stove operation, weak draft, or both. It is a tar that results when unburned gases condense inside the flue sys- tem at temperatures below 143° C (290˚ F).
24 Dutchwest Non-Catal ytic Con vection Heater 30003849 MHSC reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice.
25 Dutchwest Non-Catal ytic Con vection Heater 30003849 Dutchwest Convection Heater (continued) Model 2477CE Ref. Description 2477CE 6. Outside Air Bracket 30002205 7. Fountain Assembly 30002100 8. Brick Support Bracket 30000986 9. Shoe Refractory 30002101 Shoe Gasket 30002286 10.
26 Dutchwest Non-Catal ytic Con vection Heater 30003849.
27 Dutchwest Non-Catal ytic Con vection Heater 30003849 L I M I T E D L I F E T I M E W arranty For Dutchwest Non-Catalytic W ood Stove Limited Lifetime W arranty MHSC warrants that all refractory bri.
MHSC 149 Cleveland Drive • Paris, Kentucky 40361 www .mhsc.com.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Vermont Casting 2477CE c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Vermont Casting 2477CE - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Vermont Casting 2477CE, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Vermont Casting 2477CE va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Vermont Casting 2477CE, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Vermont Casting 2477CE.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Vermont Casting 2477CE. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Vermont Casting 2477CE ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
