Manuel d'utilisation / d'entretien du produit 270451 du fabricant Poulan Pro
Aller à la page of 48
II OWNER'S MANUAL MODEL NO. 270451 13.5 HP 38 INCH LAWNTRACTOR • Assembly • Operation Maintenance • Service and Adjustments • Troubleshooting • Repair Parts For Parts and Service, contact our authorized distributor: call 1-800-849-1297 For Technical Assistance: call 1-800-829-5886 174207 Rev.
Safety Rules ......................................... 2 Product Specifications .......................... 5 Assembly .............................................. 7 Operation ............................................ 10 Maintenance Schedule .....
DO NOT: • Do not turn on slopes unless neces- sary, and then, turn slowly and gradually downhill, if possible. • Do not mow near drop-offs, ditches, or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.
• Use slow speed. Choose a low gear so that you will not have to stop or shift while on the slope. • Avoid starting or stopping on a slope. If tires lose traction, disengage the blades and proceed slowly straight down the slope. • If machine stops while going uphill, disengage blades, shift into reverse and back down slowly.
PRODUCT SPECIFICATIONS GASOLINE 1.25 GALLONS CAPACITY UNLEADED AND TYPE: REGULAR OILTYPE SAE 30(ABOVE 32°F API-SF/SG/SH): SAE 5W-30 (Below 32°F) OILCAPACITY: 3 PTS _PARK PLUG: CHAMPION GAP: .030") RJ19LM OR J19LM VALVE INTAKE: .005"-.007" CLEARANCE: EXHAUST:.
Steering Wheel Insert (1) Hex Bolt 5/16-18 x 1-1/4 _L Steering Wheel Adapter Steering Wheel (1) Hex Bolt 3/8-16 x 1 (1) Locknut 5/16-18 _St_oeritg (1) Large Flat Washer (1) Lockwasher 3/8 Steering Ext.
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
Ba_e_ Box INSTALL SEAT Adjust seat before tightening adjustment knob. • Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. • Pivot seat upward and remove from the cardboard packing.
CHECK TIRE PRESSURE The tires on your tractor were overin- flated at the factory for shipping pur- poses. Correct tire pressure is important for best cutting performance. • Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" section of this manual.
These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. f BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING j @l k ENGINE ON ENGINE .
KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments, Save this manual for future reference.
The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses.
TO ADJUST MOWER cu'n'ING HEIGHT The position of the attachment lift lever determines the cutting height. • Grasp lift lever. • Press plunger with thumb and move lever to desired position. The cutting height range is approxi- mately 1-1/2 to 4".
BEFORE STARTING THE ENIGNE CHECK ENGINE OIL LEVEL • The engine in your tractor has been shipped, from the factory, already filled with summer weight oil. • Check engine oil with tractor on level ground. • Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level.
MOWING TIPS • Tire chains cannot be used when the mower housing is attached to tractor. • Mower should be properly leveled for best mowing performance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trimming.
Ch6ck Brake Operation _V r Check Tire Pressure Check Operator Presence and T Int_dock Systems If R Check for Loose Fasteners V # _7 If / Sharpen/Replace Mower Blades I_4 T Lubrication Chad _ If 0 Chec.
TRACTOR Always observe safety rules when performing any maintenance. BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual).
BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. • Keep battery and terminals clean. • Keep battery bolts tight. • Keep small vent holes open.
ENGINE COOLING FINS Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating. • Remove screws from blower housing and lift housing and dipstick tube assembly off engine. • Cover oil fill opening to prevent entry of dirt.
CLEANING • Clean engine, battery, seat, finish, etc. of all foreign matter. • Keep finished surfaces and wheels free of all _]asoline, oil, etc, • Protect painted surfaces with automo- tive type wax.
TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this manual). If tires are over or underinflated, you will not properly adjust your mower.
TO REPLACE MOWER BLADE DRIVE BELT The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL- • Remove mower from tractor (See '_'O REMOVE MOWER" in this section of this manual).
FRONT WHEEL TOE-IN/CAMBER The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department. TO REMOVE WHEEL FOR REPAIRS • Block up axle securely.
ENGINE seat Battery Box Positive Negative (Red) Cable (Black) Cable TO REPLACE HEADLIGHT BULB • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. wI_hCAUTION: Never store the tractor gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.
TROUBLESHOOTING CHART PROBLEM CAUSE CORRECTION Will not start • Out of fuel. • Engine not "CHOKED" properly. • Engine flooded. Hard to start Enginewill not turn over Bad spark plug. • Dirty airfilter. • Dirty fuel filter, • Water in fuel.
TROUBLESHOOTING CHART CAUSE • Weak or dead battery. • Corroded battery terminals. • Loose or damaged wiring. • Faulty solenoid or starter. PROBLEM Engine clicks but will not start Loss of power • Cutting too much grass/too fast. • Throttle in "CHOKE" position.
TROUBLESHOOTING CHART PROBLEM Poor cut - uneven Mower blades will not rotate Poor grass discharge Headlight(s) not working (if so equipped) Battery will not charge Engine "backfires" whenturnlng engine "OFF" CAUSE • Worn, bent or loose blade.
SCHEMATIC TRACTOR- MODEL NUMBER 270451 SA'FrERY AMMETER FUSE (OPTIONAL) p J BLACK RED SOLENOID n _G AI( IGNmON SWITCH IGNITION SWITCH PosmoN CIRCUIT "MAKE" OFF M+G+A1 NONE RUN/LIGH] B+A1 A2+L RUN B÷A1 NONE START B ÷ S + A1 NONE J (CLUTCH OFF) , .
TRACTOR- MODEL NUMBER 270451 ELECTRICAL 21 22 I I I 41 i_ I_p - - i I I _ L i i 26 I I 25 _ I I f I I I I I / I 48 i I i L 29 I , _ 28 I I I I / / / 3O.
ELECTRICAL TRACTOR- MODEL NUMBER 270451 KEY PART NO. NO. DESCRIPTION 1 144925 2 74760412 8 156417 16 1_ 21 166181 22 4152J 24 4799J 25 146147 26 166180 27 73510400 28 4207J 29 121305X 30 163968 33 140.
TRACTOR- MODEL NUMBER 270451 CHASSIS AND ENCLOSURES 208 3O 212 ? 12 28 53 29 / 55 54 26 33 10 3 0 35 34 26 208 32.
TRACTOR- MODEL NUMBER 270451 CHASSIS AND ENCLOSURES KEY PART NO. NO. DESCRIPTION 1 169831 Chassis 2 169061 Drawba_ 3 17060612 Screw 3/8-16 x 3/4 5 155272 Bumper Hood/Dash 6 155924X014 Saddle Slkscr Fi.
GROUND DRIVE TRACTOR- MODEL NUMBER 270451 29 /// /L J 26 27 34.
GROUND DRIVE TRACTOR- MODEL NUMBER 270451 KEY PART NO. NO. 1 ...... 2 146682 3 123666X 4 12000028 5 121520X 6 17060512 7 162240 8 131679 10 76020416 11 105701X 12 19151216 13 74550412 14 10040400 15 7.
STEERING TRACTOR- MODEL NUMBER 270451 _41 51 54 < 4O 25 68 67 67 67 43 36.
STEERING TRACTOR- MODEL NUMBER 270451 KEY PART NO. NO. DESCRIPTION 1 140044 SteeringWheel 2 154427 Axle Assembly STMP Dropped STL 3 156483 Spindle Assembly, LH.
ENGINE TRACTOR- MODEL NUMBER 270451 29 I OPTIONAL EQUIPMENT Spark Arrester 13 KEY PART NO. NO. DESCRIPTION 1 2 3 140310 17720410 4 137348 13 165291 14 13280324 15 13200300 16 11050600 23 169837 29 137.
TRACTOR- MODEL NUMBER 270451 SEAT ASSEMBLY 12 _5 6 21 KEY PART NO. NO. 1 127427 2 140551 3 71110616 4 19131610 5 145O06 6 738O06OO 7 124181X 8 17000616 9 19131614 10 155925 11 166369 12 121246X KEY PART DESCRIPTION NO.
DECALS TRACTOR- MODEL NUMBER 270451 4 6 3 10 5 13 15 I KEY PART NO. NO. 1 171831 2 172168 3 171828 4 171829 5 145005 6 174209 7 171830 8 156867 10 171833 12 KEY PART DESCRIPTION NO.
LIFT ASSEMBLY TRACTOR- MODEL NUMBER 270451 13 3 2 4 19 13 32 13 19 2O 15 KEY PART NO. NO. DESCRIPTION 1 159460 Wire Asm Inner W/plunger 2 159471 Shaft Asm Lift 3 105767X Pin Groove 1 500 Zinc 4 1200(3.
MOWER DECK TRACTOR- MODEL NUMBER 270451 21 2 14 29 42.
MOWER DECK TRACTOR- MODEL NUMBER 270451 KEY PART NO. NO. 1 170280 2 72140506 3 138017 4 169970 5 4939M 6 130832 8 85O857 9 1OO3O6OO 10 140296 11 134148 12 129895 13 137645 14 128774 15 110485X 16 1403.
LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materials and workmanship.
45.
46.
SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION SIGHTING GUIDE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL I /% Operate your Tractor up and down the face of slopes (not I i AJk greater than 15 ), never across the face. Make turns gradu- [ ally to prevent tipping or loss of control.
Poulan.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Poulan Pro 270451 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Poulan Pro 270451 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Poulan Pro 270451, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Poulan Pro 270451 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Poulan Pro 270451, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Poulan Pro 270451.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Poulan Pro 270451. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Poulan Pro 270451 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
