Manuel d'utilisation / d'entretien du produit PT1545R du fabricant Planar
Aller à la page of 30
PT1545R / PT1545P T ouch Screen Monitor USER’S GUIDE www .planar .com.
The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright.
T able of Contents Usage Notice Precautions ............................................................................................................................ 1 Introduction About PT1545R/PT1545P .............................................
Usage Notice ! W arning - T o prevent the risk of re or shock hazards, do not expose this product to rain or moisture. ! W arning - Please do not open or disassemble the product as this may cause electric shock. Precautions Follow all warnings, precautions and maintenance as recommended in this user ’s manual to maximize the life of your unit.
Introduction About PT1545R/PT1545P The PT1545R/PT1545P is a 15" at panel screen with an active matrix, thin-lm transistor (TFT) liquid crystal display (LCD).
T ouch Screen for PT1545R • 5-wire resistive touch screen for nger and stylus input • Surface: Anti-glare treatment • Interface: Dual RS-232 Serial/USB controller • T ransmittance: 82%±5% • HID: Windows® 7/8 • Driver: Windows® 7/8, VIST A, XP , 2000, ME, 98, NT 4.
4 Package Overview LCD Display Power Cord VGA Signal Cable RS-232 Cable (PT1545R only) USB Cable ( A to B) Audio-in Cable Landing Strip User ’s Guide xxxxxxxxx / xxxxxxxxx xxxxxxxxx USER’S GUIDE www.
Installation Product Overview • Front V iew • PT1545R Bottom V iew (Without Stand) • PT1545P Bottom View (W ithout Stand) 5 RS-232 VGA AC IN USB POWER SWITCH AUDIO AC IN USB POWER SWITCH VGA.
6 Start Y our Installation Please follow these instructions so that you can hookup the cables to associated connector . 1. Lay the display at on an even surface. 2. Move the stand into position as seen in the step 2 diagram. 3. Remove the cable cover as seen in the step 3 diagram.
Connecting the Display (Figure 8.1) T o setup this display , please refer to the following gure and procedures. 1. Be sure all equipment is turned off. 2. Connect the AC power cord to the power connector on the monitor and the other end into an electrical outlet (8.
(Figure 8.1) PT1545R PT1545P 8.
Kensington Security Slot The monitor can be secured to your desk or any other xed object with Kensington lock security products. The Kensington lock is not included.
VESA Mount Y our Monitor This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface standard which denes a physical mounting interface for at panel monitors, and corresponding with the standards of at panel monitor mounting devices, such as wall and table arms.
Remove the Deskstand Remove 4 screws and then remove hinge. 11.
User Controls Side Panel Controls Power Icon Key Name Menu Up Down Enter OSD Key Menu off status Menu on status Menu appear Menu disappear/ return to main item Brightness Main item select up/ Adjust u.
13 How to Use the OSD Menus Icon Key Name Menu Up Down Enter Power 1. Press the “MENU” button to pop up the “on-screen menu” and press “Up” or “Down” button to select among the six functions in the main menu. 2. Choose the adjustment items by pressing the “Enter ” button.
On-Screen Display Menus Main OSD Menu: ITEM CONTENT Contrast The monitor luminance level control. Brightness The monitor backlight level control. Auto Adjust Fine-tune the image to full screen automatically . Left/Right Moving screen image horizontal position to left or right.
Appendix T roubleshooting If you are experiencing trouble with the display , refer to the following. If the problem persists, please contact your local dealer or our service center .
16 W arning Signal If you see warning messages on your screen, this means that the display cannot receive a clean signal from the computer graphics card. Below are the three kinds of W arning Signal. Please check the cable connections or contact your local dealer or Planar for more information.
Product Dimensions PT1545R 17 202.0 mm 222.5 mm 350.8 mm 306.5 mm 275.9 mm 196.1 mm 67.0 mm ► Side View ► T op View ► Front View.
PT1545P ► Side View ► T op View ► Front View 350.8 mm 306.5 mm 275.9 mm 196.1 mm 62.5 mm 222.5 mm 202.0 mm 18.
Compatibility Modes Mode Resolution H-Frequency (KHz) V -Frequency (Hz) IBM VGA 720 x 400 31.47 70 IBM VGA 640 x 480 31.47 60 VESA VGA 640 x 480 37.86 72 VESA VGA 640 x 480 37.50 75 VESA SVGA 800 x 600 35.16 56 VESA SVGA 800 x 600 37.88 60 VESA SVGA 800 x 600 48.
T ouch Screen Driver Installation The PT1545R is available with both RS232 and USB connections. The touch driver is located at www .planar .com/support for these operating systems: Windows® 7/8, VIST A, XP , 2000, ME, 98, NT 4.0, CE, XP Embedded, Linux kernel 2.
PT1545P Optional Calibration T ool Install: Calibrating the touch screen in Windows 7/8: 1. T ap the Start button, Control Panel and then Hardware and Sound. 2. Under T ablet PC Settings, tap Calibrate the screen for pen or touch input. 3. On the Display tab, under Display options, tap Calibrate and then Y es to allow the program to make changes.
22.
PT1545R Install Instructions: If you are using a PC running Windows® 7/8, VIST A, XP , 2000, ME, 98, NT4.0, follow the instructions below: 1. Power on the PC. 2. Be sure the USB or the RS-232 Serial cable is connected from the PC to the display . 3. Visit www .
When changing the T ouch Interface (RS-232 or USB), please follow instructions below . 1. Uninstall the touch driver . 2. Re-start the computer . 3. Remove the original T ouch Interface (RS-232 or USB). 4. Connect the computer to the T ouch Interface (RS-232 or USB) that you would like to use.
PT1545P Install Instructions: If you are using a PC running, Windows® 7/8, VIST A, XP , 2000, follow the instructions below: 1. Power on the PC. 2. Make sure that the USB cable is connected to the computer . 3. Visit www .planar .com/support. 4. Follow the step-by-step instructions as shown on the pop-up windows.
T echnical Support Cables and Accessories T o nd cables and accessories for your Planar monitor , touch screen or other Planar products visit our online store at www .
Planar Systems, Inc. Customer Service 24x7 Online T echnical Support: http://www .planar .com/ support 1 195 NW Compton Drive Beaverton, OR 97006-1992 T el: 1-866-PLANAR1 (866-752-6271) or +1 503-748-5799 outside the United States. Hours: 24 hours a day , 7 days a week © 2013 Planar Systems, Inc.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Planar PT1545R c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Planar PT1545R - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Planar PT1545R, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Planar PT1545R va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Planar PT1545R, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Planar PT1545R.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Planar PT1545R. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Planar PT1545R ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
