Manuel d'utilisation / d'entretien du produit RCA-SM du fabricant Niles
Aller à la page of 24
REMO T E C ONTR OL ANYWHERE! ® KIT R C A - S M INST ALLA TION GUIDE.
II CONGRA TULA TIONS! Thank you for choosing the RC A-SM Remote Control Anywhere! Kit from Niles. With proper installation and opera tion, you should enjoy years of trouble-free use. Niles manufactures the industr y’ s most complete line of custom installation components and accessories for audio/video systems.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 1 INTRODUCTION The Niles RCA-SM Remote Control Anywhere! Kit enables you to opera te your remote controlled audio/video equipment from virtually any loca tion.
2 INST ALLA TION CONSIDERA TIONS WARNING – TO PREVENT POSSIBLE INJURY , THE FOLLOWING BASIC SAFETY PRECAUTIONS SHOULD BE OBSERVED IN THE INST ALLA TION AND USE OF YOUR REMOTE CONTROL ANYWHERE KIT . 1. Read through the entire manual – Before attempting any installation, read this manual thoroughly and keep it for future r eference .
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 3 Figure 1 Connection Hub Placement INST ALLA TION TOOLS REQUIRED • Pencil • Standard screwdriver • Phillips screwdriver • Wire strippers • Drill.
4 INST ALLA TION STEP 1 – PLACING THE CONNECTION HUB Place the Connection Hub so that the MicroFlasher wires will reach the components. Never place the connection hub closer than 1’ away from a television set ( Figure 1 ).
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 5 Figure 3: Removable Connector Plug Figure 4: Wiring Legend INST ALLA TION ( CONTINUED) STEP 2 – CONNECTING THE MICROSENSOR CABLE TO THE CONNECTION HUB F or your convenience, the Microsensor cable ends ha ve been stripped.
6 INST ALLA TION ( CONTINUED) STEP 3 – CONNECTING THE 12VDC IN-LINE POWER SUPPL Y AND MICROFLASHERS Plug the MicroFlashers into any of the sockets labeled FLASHER OUTPUTS on the connection hub ( Figure 5 ).
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 7 INST ALLA TION ( CONTINUED) STEP 4 – MOUNTING A MICROFLASHER TO A/V COMPONENTS Make sure all of your remote controls have ba tteries and that they are able to operate the A/V components.
8 INST ALLA TION ( CONTINUED) STEP 5 – MOUNTING THE CONNECTION HUB Make sure that your system tested OK before proceeding. Once you have decided on the ideal loca tion for the connection hub, unplug the 12VDC power supply from the electrical outlet and disconnect the Microsensor and the MicroFlasher cables from the connection hub ( Figure 8 ).
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 9 Figure 9A & B A : W all mounting B : If you desire to shelf mount the connection hub, stick the included adhesive backed feet on the bottom of the un.
10 INST ALLA TION ( CONTINUED) STEP 7 – RUNNING THE MICROSENSOR CABLE Reconnect the Microsensor plug, flashers and power supply as outlined in steps 2, 3 and 4 ( Figure 10 ). That’ s it! No w you are ready to control your audio/video equipment from the room you chose.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 11 Figure 11: System Operation INST ALLA TION ( CONTINUED) NORMAL OPERA TION T o control your audio/video components, simply aim your remote control a t the Microsensor .
12 REMOTE CONTROL ANYWHERE! KIT CONNECTION HUB INST ALLA TION ( CONTINUED) OPTIONAL ACCESSORIES ST A TUS FEEDBACK W ALL ADAPTER The MS210 Microsensor features a sta tus feedback LED that glows green whenever your system is on. This is a very useful fea ture when operating your equipment from a remote loca tion.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 13 INST ALLA TION ( CONTINUED) ADDITIONAL SENSORS The Remote Control Anywhere! Kit includes one surface mount Microsensor . The included MSU140 main system unit will accommodate a second IR Microsensor . Niles makes a variety of sensors for virtually any a pplication.
14 INST ALLA TION ( CONTINUED) SAFETY FIRST! W ear gloves, safety goggles and head protection when drilling. Avoid nails, they ruin bits and they can cause injur y . P ay particular attention when using “hole-hogs” and other po werful electric drills; the torque of the drill when suddenly stopped by a nail can break a strong person’ s wrist.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 15 INST ALLA TION ( CONTINUED) PULLING THE CABLE Whenever you run the cable farther than 4-1/2 feet from a hole in a stud or joist (open attic space, going up walls, etc.), fasten the cable to the joists or studs using cable c lamps or a ppropriately sized cable staples.
16 INST ALLA TION ( CONTINUED) Start by examining all the possible routes you might take to run the Microsensor cable from the sensor location to the A/V components to be controlled. Use a stud sensor or other device to loca te the internal structure of the wall.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 17 F i g u r e 1 4 : Routing Wire Around a Door INST ALLA TION ( CONTINUED) Sometimes, an under -the-carpet run is possible. As a last resort, heating and air conditioning vents can be used as cable raceways for plenum rated cable (check your local building codes, some municipalities require a conduit).
18 SPECIFICA TIONS MSU140 IR System Compatible with virtually all brands of remotes using carrier frequencies between 26kHz and 105 kHz Wiring Requirements Individual home-runs of CA T -5 cable from each sensor/keypad Unit Dimensions 4-3/4” wide x 1-1/4” high x 2” deep P ower Requirements 12 vDC power supply (included).
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 19 NOTES.
20 LIMITED W ARRANTY Ni les Aud io Cor por atio n (“ NIL ES” ) war ran ts its ac tiv e p rod uct s ( tho se req uir ing A C or batt ery pow er ) t o t he ori gin al pur cha ser to be fr ee of ma nuf act ur ing de fec ts in mat eri al and w ork man sh ip for a pe rio d o f t wo ye ars f rom dat e o f p urc ha se.
NILES AUDIO CORPORA TION – 1-800-BUY -HIFI 21 Det ach here a nd ret urn to: Ni les Au dio Co rpor ation Warr anty Regis tratio n De pt. P .O . Box 16 0818 M iami , Flo rida 33116 -0818 W ARRANTY REG.
B LENDING H IGH F IDELITY A N D A RCHITECTURE ® Niles Audio Corporation 12331 S.W . 130 Street Miami, Florida 33186 305-238-4373 1-800-BUY -HIFI – www.nilesaudio.com ©2007 Niles Audio Corporation. All rights reserved. Niles, the Niles logos and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Niles RCA-SM c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Niles RCA-SM - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Niles RCA-SM, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Niles RCA-SM va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Niles RCA-SM, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Niles RCA-SM.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Niles RCA-SM. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Niles RCA-SM ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
