Manuel d'utilisation / d'entretien du produit T 8822 C du fabricant Miele
Aller à la page of 56
Operating instructions for condenser tumble dryer T 8822 C To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children.
Caring for the environment ..........................................2 Warning and Safety instructions .....................................5 Operating the tumble dryer ..........................................9 Control panel ........................
Problem solving guide ............................................2 8 Check and fault messages ..........................................2 8 An unsatisfactory drying result .......................................3 1 Other problems ....................
~ It is essential to read these instructions. This tumble dryer conforms to current safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the tumble dryer, please read these instructions carefully before using it for the first time.
Technical safety ~ Before setting up the tumble dryer, check it for any externally visible damage. Do not install or use a damaged tumble dryer. ~ Before connecting the tumble dryer, ensure that the connection data on the data plate (voltage and connected load) match the mains electricity supply.
Correct use ~ To prevent the risk of fire, the following textiles must not be dried in this tumble dryer: – items which have not been washed. – items, such as workwear, which have not been thoroughly cleaned and which are still soiled with grease, oil or other deposits (such as cosmetics, lotions etc).
~ The dryer must not be used without the fluff filters in place or if the fluff filters are damaged in any way. ~ The fluff filters must be cleaned regularly. ~ The dryer must not be used without the condenser unit in place. ~ The fluff filters must be thoroughly dried after cleaning.
Control panel a Low temperature button Delicate fabrics are dried at a lower temperature. b Drying level button with indicator lights to show the drying level selected.
The display shows: – Programme duration – Programme stage Drying Cooling down Finish – Check and fault messages The following are also selected via the display: – Duration of the Warm air and Cool air programmes – Delay start You can select a programme and set it to start at a later time.
Garment care label symbols Drying q Normal/higher temperature r Reduced temperature: Select Low temperature (for delicate textiles) s Do not tumble dry Ironing I Very hot H Hot G Warm J Do not iron Tips on drying – Always observe the maximum recommended loads given in the "Programme chart".
Brief instructions The headings numbered ( A , B , C ...) show the operating sequence and can be used as a brief guide to using your dryer. A Sort the laundry To ensure an even drying result separate out the washed laundry and sort it according to: . .
D Select a programme ^ Select the programme you want. The indicator for the programme selected will light up. A drying level or extra option indicator may also light up and the duration may also be displayed.
F Start the programme The Start/Stop button will flash when a programme is being selected. The flashing indicates that a programme can be started. ^ Press the Start/Stop button. The Start/Stop button will now light up constantly. * Drying will appear in the display and the Perfect Dry indicator will flash.
Extra options Low temperature Delicate and minimum iron fabrics with the r symbol on the care label (e.g. acrylic garments) are dried at a lower temperature. The programme duration is longer. On some programmes Low temperature is permanently activated and so cannot be deselected.
Cottons Max. load 7 kg* Extra dry, Normal** Fabric type Single and multi-layered cotton fabrics such as towelling, T-shirts, underwear, flannelette bed linen. Notes – Select Extra dry for multi-layered and very thick fabrics. – Do not use Extra dry for loopknit fabrics (e.
Woollens handcare Max. load 2 kg* Fabric type Woollen fabrics Notes – This programme only fluffs up woollen garments. They are not dried completely by this programme. – Remove garments as soon as the programme has finished and leave to finish drying at room temperature.
Shirts Max. load 2 kg* Normal, Hand iron Fabric type Shirts and blouses. Low temperature Select the Low temperature option for delicate fabrics with the r symbol on the care label. Cool air Max. load 7 kg* Fabric type Any item which only needs airing.
Once a programme has started - changing the programme You cannot change to another programme once a programme has started (this prevents unintentional alterations). You will need to cancel the current programme before you can select a new one. - cancelling the programme and then selecting a different programme ^ Press the Start/Stop button.
The system lock prevents the dryer being used without your knowledge. It can be activated if wished. The dryer's electronics are then locked. The dryer can still be switched on but a programme cannot be started.
Emptying the condensed water container The condensed water will be collected in the condensed water container unless the dryer has been connected for external drainage (see "Installation"). Empty the condensed water container after every drying programme.
Cleaning the fluff filters The fluff which is created by the drying process is collected by the fluff filters in the door and the door opening. Clean the filters after each drying programme*. Cleaning them whilst dry Tip: You can also use a vacuum cleaner to remove the fluff.
Cleaning them with water If there is a great deal of compacted fluff on any of the filters, they can be removed and cleaned under hot running water. ^ Open the door and pull the fluff filter out of the door as described previously. The two filters in the door opening can also be removed if you need to clean them with water.
Cleaning the tumble dryer Disconnect the tumble dryer from the mains electricity supply. Miele branded cleaning and conditioning products are available to order from your Dealer, the Miele Spare Parts Department or via the internet on www.miele-shop.com.
Cleaning the condenser unit Detergent residue, hair and fine fluff from the dryer can get through the fluff filters and block the condenser unit. Dust from the room in which the dryer is installed can also get into the condenser unit and cause a blockage.
^ Pull the condenser unit out of its housing by the handle. Checking the condenser unit ^ Hold the condenser unit up to the light as shown . ^ Check to see if there is any fluff inside it. The arrows in the illustration above indicate where to look. If you cannot see any fluff: ^ Replace the condenser unit (see following page).
^ Then flush the unit through from the front. ^ Check the condenser unit again for any visible fluff and if necessary flush it through again until it has all gone. ^ Also make sure the rubber seals are clean. The rubber seals must not be removed and must be free of kinks.
With the help of the following notes, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department.
Problem Possible cause Remedy The Clean out airways indicator light comes on. This indicator light comes on to warn you that the dryer is not working efficiently. Possible cause: the fluff filters are clogged with fluff or with detergent residues. – Cleaning the fluff filters is usually all that is required.
Problem Possible cause Remedy The Denim, Shirts and Cool air programmes will not start and the indicators for these programmes do not light up. No obvious cause. – Switch the dryer off and then on again. – Select one of the programmes. – If the programme will still not start, there is a fault.
An unsatisfactory drying result Problem Possible cause Remedy The laundry is not sufficiently dry. The load consisted of different fabrics. – Finish drying using the Warm air programme. – Select a different programme next time *. Items made of synthetic fibres are charged with static electricity after drying.
Other problems Problem Possible cause Remedy The drying process goes on too long or even switches off. In some circumstances, the Clean out airways indicator light still comes on, even though the filters are clean. Please check all the possible causes and switch the dryer off and then back on again.
Problem Possible cause Remedy Water leaks from the dryer after the condenser unit has been cleaned. – The inner cover of the condenser unit has not been locked properly and/or the condenser unit has not been positioned correctly. – Fluff has collected in the condenser unit housing.
Changing the lamp Disconnect the tumble dryer from the mains electricity supply. ^ Open the door. You will find the interior lamp cover at the top of the drum aperture. ^ Insert a suitable tool, such as a wide bladed screwdriver, under the side edge of the lamp cover as illustrated.
Repairs In the event of any faults which you cannot remedy yourself, please contact – your Miele dealer or – the Miele Service Department (see back cover for contact details).
Front view a Mains connection cable b Condensed water container c Control panel d Door e Service panel for condenser unit f Four height-adjustable screw feet g External drainage options (e.
Rear view a Protruding lid for holding when moving the dryer (see arrows) b Air inlet vent for cooling the condenser unit c Mains connection cable d Hose for external drainage of condensed water e Accessories for connection to a sink drain outlet Installation site , Make sure the dryer door can be opened without hindrance after installation.
Levelling the appliance The dryer must be perfectly level to ensure safe and proper operation. ^ The screw feet can be adjusted to compensate for any unevenness in the floor. , The air inlet and outlet vents on the front of the dryer must not be covered as this would prevent sufficient ventilation for cooling the condenser unit.
External condensed water outlet General notes When drying is in progress, condensed water is pumped into the condensed water container through the drain hose at the back of the dryer. The condensed water can also be drained off directly if the tumble dryer is installed near a sink, drain outlet etc.
External drainage via a sink or gully ^ See "Front view" illustration. , If you want to drain the water off into a sink you will need to secure the hose carefully, e.g. by tying it to a tap to make sure it cannot slip during use. Otherwise there is a risk of overflowing water which could cause damage.
1 Adapter 2 Nut 3 Hose clip 4 End of the hose 5 Non-return valve 6 Tumble dryer drain hose ^ Fit adapter 1 to the sink drain outlet using nut 2 . If this nut has a flat disc in it you should take the disc out first. ^ Attach the end of hose 4 to adapter 1 .
Electrical connection U.K. All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with current national and local safety regulations (BS 7671 in the UK). Ensure power is not supplied to the appliance until after installation work has been carried out.
Load 1 Final spin speed in a domestic washing machine Residual moisture Energy Duration kg rpm % kWh Minutes Cottons Normal 2 7.0 1000 60 3.90 111 Cottons Normal 7.0 7.0 7.0 7.0 1200 1400 1600 1800 53 50 48 43 3.55 3.35 3.25 2.90 101 97 93 85 Cottons Normal + Low temperature 7.
Height 850 mm Width 595 mm Depth 587 mm Depth with door open 1060 mm Height for building under 820 mm Width for building under 600 mm Depth for building under 600 mm Suitable for pushing under a worktop yes Suitable for stacking yes Weight 51 kg Drum volume 111 l Maximum capacity 7 kg dry weight Capacity of condensed water container approx.
Extending the range of the drying levels You can extend the range of the drying levels for many of the programmes: Machine iron+ (drier than Machine iron). Hand iron+ (drier than Hand iron). Normal+ (drier than Normal). In addition the Extra dry drying level can be made available for the Delicates and Denim programmes.
Anti-crease setting Anti-crease helps prevent creasing, if laundry is not normally removed immediately after the end of a programme. After the programme has finished, the drum will continue to rotate at intervals for: – 2 hours (factory default setting).
Altering the volume of the buzzer The buzzer has two volumes. Follow steps A to F to programme and store in memory. Before you begin, first ensure that: – The tumble dryer is switched off. – The door is closed. A Press the Start/Stop button and keep it pressed in whilst carrying out steps B - C .
Memory function The electronics will memorise any extra options selected for a programme. The duration selected for the Warm air or Cool air timed drying programmes will also be stored in memory. These settings will be selected automatically the next time the programme is chosen.
Extending the cooling down time The cooling down phase which takes place before the end of a programme can be lengthened if required. This makes the garments easier to handle. The cooling down time – can be extended by 5 minutes or 10 minutes. – can only be extended for programmes with drying levels.
Clean out airways indicator Fluff should be removed after drying. The Clean out airways indicator will remind you to clean the filters when a certain amount of fluff has collected in the filters. You can decide at what level of fluff this reminder should be given.
Keypad tone An audible tone sounds each time a button is pressed. Follow steps A to F to programme and store in memory. Before you begin, first ensure that: – The tumble dryer is switched off. – The door is closed. A Press the Start/Stop button and keep it pressed in whilst carrying out steps B - C .
Adjusting the dryer's electronics for very soft water , In some areas of the UK, water is extremely soft which can affect the sensitivity of the control electronics. If the dryer is installed in an area of very soft water, you should contact your local water supplier for information and advice regarding water hardness and water conductivity.
53.
54.
55.
M.-Nr. 07 483 560 / 00 Alteration rights reserved/1409.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Miele T 8822 C c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Miele T 8822 C - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Miele T 8822 C, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Miele T 8822 C va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Miele T 8822 C, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Miele T 8822 C.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Miele T 8822 C. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Miele T 8822 C ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
