Manuel d'utilisation / d'entretien du produit 864TRV du fabricant Lopi
Aller à la page of 26
864T R V F ir ep lace • Operation • Maintenance Tested and Listed by OMNI-Test Laboratories, Inc. Beaverton, Oregon Report # 028-F-59-5 ANSI Z21.88b-2003 WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
2 Introduction Travis Industrie s 405081 2 100-011 6 8_001 Introduction We welcome you as a new owner of a 864TRV gas fireplace. This manual details operation and maintenance of this fireplace. Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference.
Introduction 3 © Travis Industries 4050812 100-01168_001 Table of Contents Introduction and Important Information Introduction ............................................................. 2 Important Information .....................................
4 Safety Precautions © Travis Industries 4050812 100-01168_001 IF YOU SMELL GAS: * Do not light any appliance * Extinguish any open flame * Do not touch any electrical switch or plug or unplug anythi.
Safety Precautions 5 © Travis Industries 4050812 100-01168_001 Do not place clothin g or other flammable items on or near the heater. Because this heater can be controlled by a thermostat there is a possibility of the heater turning on and igniting any items placed on or near it.
6 Operation © Travis Industries 4050812 100-01168_001 Before You Begin • Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Operation 7 © Travis Industries 4050812 100-01168_001 Starting The Pilot Flame The pilot flame is required to ignite the main burners (it also plays a safety role). It should be left on once lit. It will stay lit unless the gas control valve is turned to "OFF".
8 Operation © Travis Industries 4050812 100-01168_001 Starting the Fireplace for the First Time • Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur.
Operation 9 © Travis Industries 4050812 100-01168_001 Adjusting the Optional Blower Speed The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to temperature (approximately 10 minutes after starting).
10 Maintenance © Travis Industries 4050812 100-01168_001 Maintaining Your Fireplace's Appearance Fingerprints or other marks left on the optional plated surface may become etched in place if they are not wiped clean prior to turning the fireplace on.
Maintenance 11 © Travis Industries 4050812 100-01168_001 Grill Installation and Removal Some fireplaces have grills above and below the glass frame. These grills may be installed following the directions below (follow in reverse to remove).
12 Maintenance © Travis Industries 4050812 100-01168_001 Face Installation and Removal Some fireplaces have a face that fits over the glass frame. The face can be removed following the directions below. Phillips Screwdriver Four screws hold the face in place.
Maintenance 13 © Travis Industries 4050812 100-01168_001 Glass Frame Removal and Installation Warning: The appliance must be completely cool before removing the glass.
14 Maintenance © Travis Industries 4050812 100-01168_001 Glass Frame Removal and Installation (continued) The latch can come loose from the latch assembly. This occurs only when it is rotated. Follow the directions below to re-install the latch if it comes loose.
Maintenance 15 © Travis Industries 4050812 100-01168_001 Log Set Installation Rear Log Installation Place the rear log as shown below. Make sure it is pushed all the way back on the log shelf.
16 Maintenance © Travis Industries 4050812 100-01168_001 Right Log Installation Place the right log as shown below. The right log has a curved slot that fits over the right side gr a te. The left side of the log should be slid back against this led g e.
Maintenance 17 © Travis Industries 4050812 100-01168_001 Left Log Installation Place the left log as shown above. Note how the right side of the log comes up, but does not cover, the burner holes.
18 Maintenance © Travis Industries 4050812 100-01168_001 Center Log Installation Note how the center log rests on the center grate. The pin on the rear log inserts into the hole on the center log.
Maintenance 19 © Travis Industries 4050812 100-01168_001 Ember Installation Place the embers along the hearth plate and burner - make sure they do not cover any burner holes or air channels. Use the embers to cover any rivets and to make the firebox more realistic.
20 Maintenance © Travis Industries 4050812 100-01168 Glass Cleaning The glass may be cleaned with a non- abrasive cleaner. To clean the inside of the glass, simply remove the glass frame, place it on a non-scratching surface, and clean the inside surface.
Maintenance 21 © Travis Industries 4050812 100-01168_001 Troubleshooting Table Problem: Possible Cause: Don't Call for Service Until You: Pilot Will Not Light A gas shut off valve is turned off .
22 Maintenance © Travis Industries 4050812 100-01168_001 How this Fireplace Works This fireplace was designed with safety as the primary concern. Many of the components inside this fireplace are for safety purposes. Therefore, only certified gas service technicians should service this fireplace.
Maintenance 23 © Travis Industries 4050812 100-01168_001 Wiring Diagram Millivolt Wiring (stock configuration) Orange White Piezo Igniter Thermopile Red Thermocouple Copper Co-Axial Wire Red Optional.
24 Limited 7 Year Warranty © Travis Industries 4050812 100-01168_001 To register your TRAVIS INDUSTRIES, INC. 7 Year Warranty, complete the enclosed Warranty card and mail it within ten (10) days of the appliance purchase date to: TRAVIS INDUSTRIES, INC.
Optional Equipment 25 © Travis Industries 4050812 100-01168_001 Accessories The accessories listed below are available at your Travis dealer. To locate a dealer, visit: www.travisproducts.com Firebacks There are several styles of decorative ceramic firebacks that fit inside the firebox and enhance the area behind the flames.
26 Index © Travis Industries 4050812 100-01168_001 Index Accessories .......................................................2 5 Adjusting the Flame Height ..................................8 Adjusting the Optional Blower Speed ......................9 Before You Begin .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Lopi 864TRV c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Lopi 864TRV - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Lopi 864TRV, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Lopi 864TRV va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Lopi 864TRV, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Lopi 864TRV.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Lopi 864TRV. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Lopi 864TRV ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
