Manuel d'utilisation / d'entretien du produit POWER MISER 153.330401 du fabricant Kenmore
Aller à la page of 28
Owners Manual FOR POTABLE WATER HEATING ONLY NOT SUITABLE FOR SPACE HEATING NOT FOR USE IN MOBILE HONES Model No. 153.330401 40 Gal. High Altitude 153.330451 40 Gal. 153.330501 50 Gal. High Altitude 153.330551 50 Gal. 153.330701 75 Gal. High Altitude 153.
Safety Precautions • _W,.ARNING . Impro.per installation, adjustment , alteration, service or maintenance can cause DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE. Refer to this manu- I al for assistance or consult your local Sears Service [ Center for further information.
? Safety Precautions _,WARNING A gas water beater cannot operate properly without the correct amount of air for combustion. Do not install in a confined area such a closet, unless you provide air as shown in the "Facts to Consider About the Location" sec- tion.
Safety Precautions ._,WARNING I The water heater with draft hood installed must be prep. [ erly vented to a chimney which termm.ates outdoors. I Never operate the water heater unless it is vented to the outdoors and has adequate air supply.to avoid risks of improper operation, explosion or asphyxiation.
Table of Contents _c__oarety Precautions ............................................................................................................................................ 2_ Table of Contents ................................................
Customer Responsibilities Thank You for purchasinga Sears water heater. Properly installed and maintained, it should give you years of trouble free service. If you should decide that you want the new water heater professionally installed by Sears call the local Sears Service Center or any Sears store.
Materials and Basic Tools Needed Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materi- als, depending on your type of installation. i Water Heater Installation Kit VENT ELBOW _.
? Installation Instructions Removing the Old Water Heater Turn "OFF" the gas supply to the water heater. AWARNING o If the main gas line shutoff serving all _ appliances is used, also shut "OFF" the gas at each appliance. Leave all gas appliances shut "OFF" until the water heater installa- t on s comp ete.
Installation Instructions (cont'd) Facts to Consider About the Location You should carefully choose an indoor location for the new water heater, because the placement is a very important consid- eration for the safety of the occupants in the building and for the most economical use of the appliance.
Installation InStructions (cont'd) Combustion Air and Ventilation for Appliances Located in Unconfined Spaces Uncon_qned Space is a space whose volume is not less than 50 cubic feet per 1,000 Btu per hour of the aggregate input rating of all appliances installed in that space.
Installation Instructions (cont'd) Water Piping AWARNING HOTTERWATER CAN SCALD:. Water heaters am intended to produce hot water. Water _ to a temperaturewhich will sat_fy clothes washing, dish washing, andother sanitizing needs can scald and permanently injure you upon contact.
Installation InstruCtions (cont'd) Temperature-Pressure Relief Valve A WARNING At the time of manufacturethis water heater was provided with a combination temperature-pressures relief valve certi.
Installation Instructions (cont'd) Filling the Water Heater ACAUTION I Never use this water heat_' unless it mcompletelyfilledwith I wa_. To _ont dam_e to the tank, the tank must be elk_ I with water. Water must flow from the hot water faucet before turning "ON" gas to the water hea_.
Installation Instructions (cont'd) Venting (cont'd) All vent gases must be completdy vented to the outdoors of the structure (dwelling). InstaU only the draft hood provided with the new water heater and no other draft hood. Vent pipes must be secured at each joint with sheet metal screws.
Installation Instructions (cont'd) AWARNING • The appliance and its individual shutoff valve must be discon- nected from the gas supply piplng system during any pressure testing of the gas system at test pressures in excess of pound per square inch (3.
Installation Instructions (cont'd) Installation Checklist BEFORE LIGHTING THE PILOT: Check the gas lines for leaks. a. Use a soapy water solution. DO NOT test for gas leaks usinga match or open flame. b. Brush the soapy water solution on all gas pipes, joints and fittings.
Operating Instructions Lighting AWARNING BEFORE LIGHTING PROPANE (L.R) GAS WATER HEATERS: Propane (LR) gas is beevier than air. Should ti_re be a le_k in the system, the gas will settle near the ground.
Operating Instructions (cont'd) Lighting label on the water heater as it appears above the thermostat FOR YOUR SAFETY READ BEFORE LIGHTING A. B. WARNING If you do not follow these Instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
Operating Instructions (cont'd) Temperature Regulation Due to the nature of the typical gas water heater, the water tem- Foerature in certain situations may vary up to 30°F higher or wet at the point of use such as, bathtubs, showers, sink, etc.
Service and Adjustment Tank (Sediment) Cleaning Sediment build-up on the tank bottom may create varying amounts of noise, and if left in the tank will cause premature tank failure. In some water areas, you may not be able to drain all sediment deposits by simply draining the tank.
Service and Adjustment (cont'd) Draining The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary. Turn the gas control knob to the "OFF" position.
Troubleshooting Guide Start Up Conditions CONDENSATION Whenever the water heater is filled with cold water, a certain amount of condensation will form while the burner is on. A water heater may appear to be leakin_when in fact the water is condensation.
Troubleshooting Guide (cont'd) Operational Conditions HOT COLD WATE_ HEAT_ O) COLD WATER pRESSURE INLET FITTING REDUCING VALVE BY-PASS (t) EXPANSION TANK _) PRESSURE GAUGE INLET C WATER SHUTOFF R.
Troubleshooting Guide (cont'd) Operational Conditions (cont'd) HIGH TEMPERATURE SHUT OFF SYSTEM WATER IS TOO HOT This water heater is equipped with an automatic gas shut offsys- tem. The high temperature shut off is built into the gas control valve.
Troubleshooting Guide (cont'd) Leakage Checkpoints Use this guide to check a "Leaking" water heater. Many suspect- - ed "Leakers" are not leaking tanks.
Parts Order List POWER MISER TM 10 GAS WATER HEATERS MODEL NUMBERS: 153.330401 40 Gal. High Altitude 153.330451 40 Gal. 153.330501 50 Gal. High Altitude 153.
Parts Order List (cont'd) POWER MISER TM 10 GAS _rATER HEATERS MODEL NUMBERS: 153.330401 40 Gal. High Altitude 153.330451 40 Gal. 153.330501 50 Gal. High Altitude 153.330551 50 Gal. 153.330701 75 Gal. High Altitude 153.330751 75 Gal KEY NO. 1 2 3 4 5 153.
Warranty About Your Warranty THE PRICE OF YOUR WATER HEATER DOES NOT INCLUDE A FREE CHECKUP SERVICE CALL. On Water Heater Installations Arranged By Sears, Sears warrants the installation. ON INSTALLATIONS NOT MADE BY SEARS AUTHORIZED CONTRACTORS: 1. Your Sears warranty applies to the product only.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Kenmore POWER MISER 153.330401 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Kenmore POWER MISER 153.330401 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Kenmore POWER MISER 153.330401, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Kenmore POWER MISER 153.330401 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Kenmore POWER MISER 153.330401, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Kenmore POWER MISER 153.330401.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Kenmore POWER MISER 153.330401. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Kenmore POWER MISER 153.330401 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
