Manuel d'utilisation / d'entretien du produit POWER MISER 153.327164 du fabricant Kenmore
Aller à la page of 28
Owners Manual FOR POTABLE WATER HEATING ONLY NOT SUITABLE FOR SPACE HEATING Model No. 153.327164 30 GaL Short 153.327264 40 Gal. Short 153.327363 30 Gal. 153.327364 30 Gal. 153.327463 40 Gal. 153.327464 40 Gal. 153.327563 50 Gal. 153.327564 50 Gal. 153.
Safety Precautions AWARNING I improper installation, adjustment, alteration, service or maintenancecan cause DEATH, SERIOUS BODILY INJUR_, I OR PROPERTY DAMAGE. Refer to this manual for assis- tance or consultyour local Sears Service Center for further nformation.
Table of Contents Safety Precautions ............................................................................................................................................... 2 Table of Contents ..................................................
Introduction Thank You for purchasing a Sears water heater. Properly installed and maintained, it should give you years of trouble free service. If you should decide that you want the new water heater professionally installed, contact the local Sears Service Center or any Sears store.
Materials and Basic Tools Needed Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materi- als, depending on your type of installation.
Installation Instructions Removing the Old Water Heater QTurn "OFF" electrical supply to the water heater. Q Turn "OFF" the water supply to the water heater at the water shutoffvalve or water meter. QAttach a hose to the water heater drain valve and put the other end in a floor drain or outdoors.
Installation Instructions (cont'd) Facts to Consider About the Facts to Consider About The Location Convertible Lower Element You should carefully choose an indoor location for the new water heat.
Installation Instructions (cont'd) Water Piping WARNING HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a tem- plerature which will satisfy space heating, clothes washing, ish washing, and other sanitizing needs can scald and permanently injure you upon contact.
Installation Instructions (cont'd) Temperature-Pressure Relief Valve AWARNING At the time of manufacture this water heater was provided with a combination temperature-pressures relief valve cer- .
Installation Instructions (cont'd) Filling the Water Heater To fill the water heater with water: Close the water heater drain valve by turning the handle to the right (clockwise). The drain valve is on the lower front of the water heater. Open the cold water supply valve to the water heater.
Installation Instructions (cont'd) 2. The convertible element is located behind the lower access panel of the water heater. Remove the two screws securing the access panel, and remove panel. 5. Remove the screws from terminal 2 of the element, and move the looped end of the wire aside.
Installation Instructions (cont'd) Converting the Lower Element (cont'd) 9. Replace terminal cover on thermostat making sure that the locking tabs on the terminal cover are in place. 12. Complete wiring to the water heater, or if completed, turn "ON" electric power to the water heater after filling the tank with water.
Installation Instructions (cont'd) Wiring Diagrams STANDARD WIRING FOR 2 WIRE LEAD WATER HEATERS 240 VOLT SINGLE ELEMENT BLACK u @ FOR 3800 WATTS TO ELECTRIC POWER SUPPLY -- _ JUo_CTION LOWER HEA.
Installation Instructions (cont'd) Wiring _,CAUTION Never use this water heater unless it is completely full of J water. To prevent damage to the tank and heating ale- J ment, the tank must be filled with water. Water must ] flow from the hot water faucet before turning on power.
Installation Instructions (cont'd) Installation Checklist • Whether or not the element conversion is made, the model rating plate must be marked• Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel.
Service and Adjustment Temperature Regulation AWARNING HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a tem- perature which will satisfy space heating, clothes washing, dish washing, and other sanitizing needs can scald and _ermanently injure you upon contact.
Service and Adjustment (cont'd) Lower Thermostat Adjustment The lower thermostat is adjustable if a different water tempera- ture "s desired. Read all warnings in the 'Temperature- Regulation" section before proceeding. The slotted adjustment (using a screwdriver) can be turned clockwise (_.
Service and Adjustment (cont'd) Element Cleaning/ Replacement A IMPORTANT ELEMENT REPLACEMENT INFORMATION This water heater is equipped with a special element that has IJA '' threads. Make sure that the replace- ment element has I%" threads.
Service and Adjustment (cont'd) 6. Lifx out the tab as shown to unclip the terminal cover from the thermostat. The terminal cover can now be removed from the thermostat.
Service and Adjustment (cont'd) Element Cleaning/ Replacement (cont'd) 16. Replace terminal cover on thermostat making sure that the locking tabs on the terminal cover are in place. 17. Replace the insulation block so that it completely covers the thermostat and element.
Troubleshooting Guide Start Up Conditions THERMAL EXPANSION Water supply systems may, because of such events as high line pressure, frequent cut-offs, the effects of water hammer among others, have installed devices such as pressure reducing valves, check valves, back flow preventers, etc.
Troubleshooting Guide (cont'd) Operational Conditions RUMBLING NOISE In some water areas, scale or mineral deposits will build up on your heating elements. This buildup will cause a rumbling noise. Follow "Element Cleaning/Replacement" instructions to clean and replace the elements.
Troubleshooting Guide (cont'd) Leakage Checkpoints Use this guide to check a "Leaking" water heater. Many suspect- ed "Leakers" are not leaking tanks.
Parts Order List KENMORE POWER MISER TM 9+ ELECTRIC WATER HEATERS MODEL NUMBERS: 153.327164 30 Gal. Short 153.327264 40 Gal. Short NOTE: A LOWER ELEMENT: These water heaters are equipped with factory installed convertible elements, which can be operat- ed at 3800 watts or 5500 watts.
Parts Order List (cont'd) KENMORE POWER MISER TM 9+ ELECTRIC WATER HEATERS MODEL NUMBERS: 153.327164 30 Gal. Short 153.327264 40 Gal. Short KEY NO.
Parts Order List (cont'd) KENMORE POWER MISER m 9+ ELECTRIC WATER HEATERS MODEL NUMBERS: 153.327363 30 Gal. 153.327564 50 Gal. 153.327364 30 Gal. 153.327663 66 Gal. 153.327463 40 Gal. 153.327664 66 Gal. 153.327464 40 Gal. 153.327863 82 Gal. 153.327563 50 Gal.
Parts Order List (cont'd) KENMORE POWER MISER TM 9+ ELECTRIC WATER HEATERS MODEL NUMBERS: 153.327363 30 Gal. 153.327564 50 Gal. 153.327364 30 Gal. 153.327663 66 Gal. 153.327463 40 Gal. 153.327664 66 Gal. 153.327464 40 Gal. 153.327863 82 Gal. 153.
Warranty About Your Warranty THE PRICE OF YOUR WATER HEATER DOES NOT INCLUDE A FREE CHECKUP SERVICE CALL. On Water Heater Installations Arranged By Sears, Sears warrants the installation. ON INSTALLATIONS NOT MADE BY SEARS AUTHORIZED CONTRACTORS: I. Your Sears warranty applies to the product only.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Kenmore POWER MISER 153.327164 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Kenmore POWER MISER 153.327164 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Kenmore POWER MISER 153.327164, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Kenmore POWER MISER 153.327164 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Kenmore POWER MISER 153.327164, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Kenmore POWER MISER 153.327164.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Kenmore POWER MISER 153.327164. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Kenmore POWER MISER 153.327164 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
