Manuel d'utilisation / d'entretien du produit UX-J50 du fabricant JVC
Aller à la page of 32
GVT0102-008A [B] For Customer Use: Enter below the Model No . and Serial No. which are located either on the rear , bot- tom or side of the cabinet. Retain this inf or mation f or future reference .
G-1 10 cm 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm Front Vie w CA UTION: Proper V entilation T o av oid risk of electric shock and fire, and to pre vent damage , locate the apparatus as follo ws: 1 Front: No obstructions and open spacing. 2 Sides/ T op/ Back: No obstructions should be placed in the areas shown by the dimensions belo w .
G-2 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manuf actured to meet international safety standards, b ut lik e any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
1 Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons on the remote contr ol. Y ou can use the buttons both on the r emote control and on the main unit f or the same operations if they ha ve the same or similar names (or marks), unless mentioned otherwise.
2 Contents Location of the Buttons and Control ..................................... 3 Front Panel ........................................................................................... 3 Remote Control ...........................................
3 Front Panel UX-J60 1 2 3 4 8 9 p q e r y u i t w 5 6 7 MICRO COMPONENT SYSTEM FOR UX-J50: FOR UX-J50: Location of the Buttons and Control Become familiar with the b uttons and control on your unit.
4 Front Panel 1 Disc tray 2 Display windo w 3 REV .MODE (re verse mode) b utton (19 – 21) 4 A UX b utton (9) Pr essing this button also turns on the unit.
5 See the pages in parentheses for details. 1 Number buttons 2 B ASS button (10) 3 Multi operation buttons • UP , 4 (rev erse skip), 7 (stop), ¢ (forward skip), and DO WN 4 SET button (17) 5 Source buttons • CD 3 / 8 , T APE 2 3 , FM/AM, and A UX Pr essing one of these buttons also turns on the unit.
6 Getting Started Supplied Accessories Make sure that y ou have all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) • Speaker cords (ONL Y FOR UX-J60) (4) If anything is missing, consult your dealer immediately .
7 INPUT INPUT INPUT INPUT RIGHT LEFT MAIN SPEAKERS CAUTION: SPEAKER IMPEDANCE 6 -16 SUBWOOFERS RIGHT LEFT 1 If the cords are co ver ed with insulation, r emove a short section of insulation at the end of each cord by twisting and pulling it off. 2 Connect the AM loop antenna to the AM LOOP terminals as illustrated.
8 RL AUX L R L R Speaker grille T o remo ve the speaker grille, insert your f ingers at the top of the speaker grille, pull to wards you. Then pull the bottom tow ards you. T o attach the speaker grille, put the projections of the speaker grille into the holes of the speaker .
9 Common Operations Setting the Clock Before operating the unit any further , f irst set the unit ’ s clock. When you plug the A C power cord into the wall outlet, “ 0:00 ” starts flashing on the display . Y ou can set the clock whether the unit is on or of f.
10 Adjusting the Volume Y ou can adjust the volume le vel only while the unit is turned on. The v olume le vel can be adjusted between “V OL MIN” and “V OLUME 1” – “V OLUME 40 (V OL MAX). ” On the remote contr ol: Press V OLUME + to increase the v olume or press V OLUME – to decrease it.
11 Selecting the Display Color (ONL Y FOR UX-J60) Y ou can select the display color (COLOR 1 – COLOR 5 and A UT O mode). • A UT O mode changes the color (COLOR 1 to COLOR 5) gradually .
12 Listening to FM and AM (MW) Broadcasts T uning in to a Station 1 Press FM/AM to select the band . The unit automatically turns on and tunes in to the pre viously receiv ed station — either FM or AM (MW). • Each time you press the button, the band alter nates between FM and AM (MW).
13 T uning in to a Preset Station On the remote contr ol ONL Y : 1 Press FM/AM to select the band . The unit automatically turns on and tunes in to the pre viously receiv ed station — either FM or AM (MW). • Each time you press the button, the band alter nates between FM and AM (MW).
14 Changing the RDS Information Y ou can see RDS information on the display while listening to an FM station. On the remote contr ol ONL Y : Press DISPLA Y (orange-color ed).
15 How the Enhanced Other Networks function actually works: CASE 1 If there is no station br oadcasting the prog ram you hav e selected The unit continues tuning in to the current station. « When a station starts broadcasting the program you hav e selected, the unit automatically switches to the station.
16 Playing Back Discs This unit has been designed to play back the follo wing discs — CD, CD-R, and CD-R W . When playing a CD-R or CD-RW User-edited CD-Rs (CD-Recor dable) and CD-R Ws (CD-ReWritable) can be played only if they are alr eady “ finalized .
17 Basic Disc Operations While playing a disc, you can do the follo wing operations. T o stop playing for a moment During play , press CD 3 / 8 . While pausing, the elapsed playing time flashes on the display . T o resume playing, press CD 3 / 8 again.
18 Repeating T racks — Repeat Play Y ou can hav e all the tracks, the program or individual track currently playing, repeat as many times as you lik e.
19 Playing Back T apes Y ou can play back type I tapes. Playing Back a T ape 1 Press PUSH OPEN 0 on the unit. 2 Put a cassette in with the exposed part of the tape down. 3 Press PUSH OPEN 0 again to close the cassette holder . 4 Press T APE 2 3 . The unit automatically turns on and the tape starts playing.
20 Recording Recording on a T ape On the unit ONL Y : 1 Put a recordable cassette in with the exposed part of the tape down. 2 Close the cassette holder gently and check the recording dir ection f or the tape. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction.
21 Disc Direct Recording Everything on the disc goes onto the tape in the order it is on the disc, or according to the order you ha ve set in Program Play . On the unit ONL Y : 1 Put a r ecordable cassette in with the exposed part of the tape down. 2 Load a disc.
22 Using the T imers There are three timers av ailable — Daily T imer , Recording T imer , and Sleep Timer . Before using the timers, you need to set the unit ’ s clock (see page 9). Using Daily Timer and Recor ding Timer Y ou can set the timer whether the unit is on or of f.
23 5 Press UP or DO WN to set the volume le vel, then press CLOCK/TIMER. • Y ou can select the volume le vel ( “ V OLUME – –” and “ V OLUME 0 ” to “ V OLUME 40 ” ). If you select “ V OLUME – – , ” the volume is set to the previous le vel when the unit w as turned off.
24 Maintenance T roubleshooting If you are ha ving a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been ph ysically damaged, call a qualified person, such as your dealer , for service.
25 Classification of the PTY codes for some FM stations may be different fr om the abo ve list on this page. Alarm function If an “ ALARM ” (Emergenc y) signal is receiv ed from a station while li.
26 Specifications Design and specifications ar e subject to c hange without notice. UX-J60 (CA-UXJ60 and SP-UXJ60) Amplifier Output Po wer: SUBWOOFERS: 90 W (45 W + 45 W) at 6 Ω (10% THD) MAIN SPEAK.
MEMO MEMO_UX-J60&50[B]f.pm6 02.12.23, 4:14 PM 1.
MEMO MEMO_UX-J60&50[B]f.pm6 02.12.23, 4:14 PM 2.
VICT OR COMP ANY OF JA P AN, LIMITED EN 0103MWMMDWJEM © 2003 VICTOR COMPANY OF JAPAN, LIMITED Cover_UX-J60&50[B]f.pm6 02.12.23, 9:30 AM 2.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté JVC UX-J50 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du JVC UX-J50 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation JVC UX-J50, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le JVC UX-J50 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le JVC UX-J50, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du JVC UX-J50.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le JVC UX-J50. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei JVC UX-J50 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
