Manuel d'utilisation / d'entretien du produit JSD2789HEB du fabricant Jenn-Air
Aller à la page of 38
T ABL E OF C O NTE NTS F orm No. C/11/04 Part No. 1284210 8 www.jennair .com Printed in U.S.A. ©2004 Mayt ag Appliances Sale s Co. Import ant Safety Instructions ........................................1-2 Installation ...............................
1 I MP O R T ANT S AF ET Y I NS T R UC T IONS WAR N I N G – Hazards or unsafe practice s which COULD result in severe personal injury or death. W ARNING DAN G E R – Immediate hazards which WILL result in severe personal injury or death.
2 I MP O R T ANT S AF ET Y I NS T R UC T IONS To reduce risk of fire, electric shock, serious injury or death when using your refrigerator , follow the se basic precautions, including the following: 1. Read all instructions before using the refrigerator .
3 I NS T ALL A TI O N Location • Do not install refrigerator near oven, radiator or other heat source. If not possible, shield refrigerator with c abinet material. • Do not install where temperature falls below 55° F (13° C) or rises above 110° F (43° C).
To Disconnect the W ater Line: •P ush in white collar (A) and hold. •P ull the door-side tube from the connector (B). To Reconnect the W ater Line: • Firmly push tube 5 ⁄ 8 ” into the connector . Use lines on the tube as a guide for full inser tion.
I NS T ALL A TI O N 5 1. Create service loop with copper tubing (minimum 2' diameter). A void kinks in the copper tubing when bending the service loop. Do not use plastic tubing. 2. Remove plastic cap from water valve inlet port. 3. Place brass nut (A) and sleeve (B) on copper tube end as illustrated.
I NS T ALL A TI O N 6 Handle Installation If not installed, the handle is loc ated in the interior or attached to the back of your refrigerator. Remove and discard handle packaging and t ape. Handle design varie s from refrigerator to refrigerator . Please reference the appropriate instructions for your model.
I NS T ALL A TI O N 2. Align notches on back of handle with retaining clips on doors. Insert clips into notche s and slide handle down until it contact s bottom trim. 3. Replace top door trim and Phillips screws. 4. Repeat instructions 1-3 to install other handle.
I NS T ALL A TI O N Installing F ront-Mounted Handles f or Stainless Steel 1. Loosen lower door clip on door with 1 ⁄ 4 " hex nut driver . 2. Locate predrilled hole at base of handle, and fit hollow end of handle over lower door clip. 3. Fit other end of handle over upper door clip and slide up as far as possible.
9 I NS T ALL A TI O N Lev eling To protect personal property and refrigerator from damage, observe the following: •P rotect vinyl or other flooring with c ardboard, rugs, or other protective material. • Do not use power tools when performing leveling procedure.
10 T EMP ER A T URE C O NTR O L S T ouch T emper atur e Contr ols T he controls are located at the top front of the refrigerator compartment. Control Initial Contr ol Settings After plugging the refrigerator in, set the controls. •P re ssing the or pads adjusts the controls to the desired setting.
11 T EMP ER A T URE C O NTR O L S T riple Cool Climate Contr ol (select models) T he control is located at the top front of the fresh food compartment. Control Initial T emperatur e Setting T emperatures are pre set at the factory at 3 8° F (3° C) in the fresh food compar tment and 0° F (-18° C) in the freezer compartment.
12 T EMP ER A T URE C O NTR O L S Pre ss the T emp Alarm pad once to stop the audible alarm. The T emp Alarm light will continue to flash and the temperatures will alternate until the temperature s have stabilized. To turn off T emp Alarm, press and hold the T emp Alarm pad for three seconds.
13 F R ESH F OOD F EA T URE S Shelv es Y our refrigerator has either Spill-Catcher™ or non- sealed shelves. Spill-Catcher™ shelve s have a spill retainer edge which allows for easier clean up and some are equipped with a slide out feature. T o slide out (select models), grasp the front of the shelf and pull forward.
14 To Remov e Dairy Door: •P re ss in side s of dairy door and pull out. To Install Dairy Door: • Slide sides of dairy door inside dairy center until hinge points snap into place. Door Buckets Door Buckets c an be moved to meet individual storage needs.
15 F R ESH F OOD F EA T URE S T emperatur e-Contr olled Dr awer T his drawer can be used for storage of meats, deli or other miscellaneous items. T he drawer features a control that adjusts the amount of cold air allowed into the drawer. Set the control to Cheese to provide a normal refrigerator temperature.
16 To Install: • Slide bin into railing below ice maker until bin locks into place. Drop ice maker arm to activate ice maker . IM PO RT ANT: Ice bin must be locked in place for proper ice dispensing. T urn auger driver behind bin counterclockwise (as shown) to properly align ice bin with auger driver .
17 I CE A N D W AT E R Automatic Ice Maker (select models) Note • Energy rating guides that are posted on the refrigerator at the time of purchase do not include optional ice maker energy usage.
18 Dispenser Light (select models) A light activates within the dispenser area at full power when dispensing ice or water with the main dispenser pad. Dispenser P ad The Dispenser Pad is located on the back wall of the dispensing area. When the dispenser pad is pressed, the selection chosen on the dispenser control panel will dispense.
19 Dispenser Lock (select models) T he Dispenser Lock prevents ice or water from being dispensed. To Lock Dispenser: •P re ss and hold the Lock button for three seconds. A green indicator light above button will illuminate when the dispenser is locked.
20 W AT E R F IL T ER W ater Filter Remov al and Installation (select models) To avoid serious illness or death, do not use refrigerator where water is unsafe or of unknown quality without adequate disinfection before or after use of filter .
21 W AT E R F IL T ER System Specification and P erformance Data Sheet Refriger ator W ater Filter Cartridge Model U K F8 001AXX Specifications Service Flow Rate (Maximum) .............................................0.78 G PM (2.9 L /min) R ated Service Life UK F8 001AXX-75 0 (Maximum) .
22 W AT E R F IL T ER State of California Department of Health Services W ater T reatment Device Certificate Number 03 - 1583 Date Issued: September 16, 2003 Date Revised: April 22, 2004 T rademar k /Model Designation Replacement Elements UKF8001AXX750 UKF8001AXX 469006-750 46 9006 67003523-750 67003523 Manufacturer: PentaPure Inc.
23 F OOD S TO R A G E T IP S Fr esh F ood Stor age •T he fre sh food compar tment of a refrigerator should be kept between 34°- 4 0° F (1°- 4° C) with an optimum temperature of 37° F (3° C). T o check the temperature, place an appliance thermometer in a glass of water and place in the center of the refrigerator .
24 F OOD S TO R A G E T IP S F ood Stor age Chart Storage times are approximate and may vary depending on type of packaging, storage temperature, and the quality of the food when purchased.
25 F OOD S TO R A G E T IP S Sources: United State s Depar tment of Agriculture; F ood Marketing Institute; Cooperative Extension Service, Iowa State University FOODS VEGET AB LE S Asparagus Brussels .
26 C AR E AN D C LEAN I N G P ART T extured Doors and Exterior (select models) Cabinet Interior Stainless Steel Doors and Exterior (select models) IM PO RT ANT: Damage to stainless steel finish due to improper use of cleaning products or non-recommended products is not covered under this product’s warranty .
27 C AR E AN D C LEAN I N G Removing Odors F r om Refriger ator Energy Saving T ips •A void overcrowding refrigerator shelve s. This reduces air circulation around food and cause s refrigerator to run longer . •A void adding too much warm food to refrigerator at one time.
28 Low er Fr eezer Section 1. Pinch both sides of light cover to remove. 2. Remove light bulb. Replace with appliance bulb no greater than 40 watts. 3. Pinch both sides of the light cover to snap into place. Ice and W ater Dispenser 1. L oc ate light bulb inside top edge of dispenser frame.
29 C AR E AN D C LEAN I N G Upon Y our Return: After a Short V acation or Absence: F or models with automatic ice makers or dispensers: • Reconnect the water supply and turn on supply valve (see page 4-5). • Monitor water connection for 24 hours and correct leaks if necess ary .
30 O PE RA T I NG S OU N DS Improvements in refrigeration de sign may produce sounds in your new refrigerator that are different or were not present in an older model. These improvement s were made to create a refrigerator that is better at pre serving food, is more energy efficient, and is quieter overall.
31 PROBL EM Fr eezer control and lights are on, but compressor is not operating T emperature- controlled dr aw ers are too w arm Refrigerator does not operate Refrigerator still w on’t oper ate F ood temper atur e is too cold F ood temper atur e is too warm Refrigerator has an odor POSSIB LE C AUSES Refrigerator is in defrost mode.
32 continued… PROBL EM Wa ter droplets f orm on outside of refriger ator Wa ter droplets f orm on inside of r efriger ator Refrigerator or ice maker makes unfamiliar sounds or seems too loud T emper.
33 No indicator lights are lit on dispenser control Ice or water ar e not dispensed when pads are pressed Ice maker is not producing enough ice or ice is malformed V erify that freezer door is closed. Power is removed from the control when freezer door is opened.
Ice maker is not producing ice W ater filter indicator light is red Ice forms in inlet tube to ice maker Refrigerator is leaking water 34 Confirm ice maker arm is down. See Automatic Ice Maker page 1 7 . See Connecting the W ater Supply pages 4 and 5.
35 PROBL EM W ater flow is slower than normal Dispenser water is not cold Wa ter appears cloudy P articles in w ater and/or ice cubes. POSSIB LE C AUSES W ater pressure is too low. Saddle valve not open completely . Improper saddle valve was inst alled.
36 N OT E S.
37 W AR R ANT Y & S ER VICE W hat is Not Cov er ed By T hese W arr anties: 1. Conditions and damages re sulting from any of the following: a. Improper inst allation, delivery , or maintenance. b. Any repair , modification, alteration, or adjustment not authorized by the manufacturer or an authorized servicer .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Jenn-Air JSD2789HEB c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Jenn-Air JSD2789HEB - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Jenn-Air JSD2789HEB, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Jenn-Air JSD2789HEB va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Jenn-Air JSD2789HEB, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Jenn-Air JSD2789HEB.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Jenn-Air JSD2789HEB. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Jenn-Air JSD2789HEB ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
