Manuel d'utilisation / d'entretien du produit EG74 du fabricant Hotpoint
Aller à la page of 32
Instructions f or Installation and Use 60cm Dual Fuel Cooker EG7 4 T o the Installer: Bef ore installation, fill in the product details on the back cov er of this book.
PA G E Introduction 3 For Y our Saf ety 4 Oven Timer Operation 6 Hotplate 12 Grill 14 Ovens 15 Oven Cooking Charts 16 The "Slow Cook" Setting 18 Care and Cleaning 19 Something Wrong with you.
T o help you make the best use of your cooker , PLEASE READ THIS BOOKLET CAREFULL Y . Y our new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions.
Please read the precautions below bef ore using your cook er . A L W A Y S . . . AL WA YS make sure you understand the controls bef ore using the co oker . AL WA YS check that all controls on the cooker are turned off afte r use. AL WA YS stand back when opening an oven door to allow heat to dis perse.
NEVER . . . NEVER leave children unsuper vised where the cooker is installed as all surf aces will get hot during and after use. NEVER allow anyone to sit or stand on any part of the cooker . NEVER store items that children may attempt to reach above the cooker .
The oven timer off ers you the f ollowing f eatures: 1. Time of Day 2. Automatic Cooking 3. Minute Minder AUT OMA TIC COOKING The main oven can be controlled automatically . GUIDANCE ON AUT OMA TIC COOKING 1. Select f oods which will take the same time to cook.
CLOCKF ACE The timer incorporates a 24 hour clock. Ensure the correct time of day is always set, bef ore using your cooker . S YMBOLS A ‘bell’ symbol will light up when you select a Minute Minder Period and will remain lit f or the period set.
SETTING THE TIME OF DA Y Step 1 Make sure all oven controls are turned Off . Step 2 Check the electricity supply to the cooker is turned on. Step 3 When switched on the display will show 0.00 and the Auto symbol , flashing intermittently . Step 4 Press and hold in both the Cook Period & End Time buttons together.
Step 3 Press and hold in the Cook Period button. The display will read 0.00 with the ‘cookpot’ symbol lit. Step 4 With the Cook Period button still held in, set the required Coo k Period using the “+” and “–” buttons.
Step 4 Press and hold in the Cook Period button, the display will read 0.00 and the ‘cookpot’ symbol will light up. With the Cook Period button still held in set the required Cook Period using the “+” and “–” buttons. Example: 1hr 30 minutes (as shown).
OTHER NOTES ON TIMER OPERA TION 1. When cooking Automatically the Cook Period can be checked at any time simply by pressing the Cook Period button. 2. When cooking Automatically the End Time can be checked at any time by simply pressing the End Time button.
The hotplate lid is fitted with a saf ety device which cuts off the gas supply to the hotplate burners unless the lid is f ully open. Do not use t he saf ety device as a means of controlling the hotplate burners.
SAFETY REQUIREMENTS FOR DEEP F A T FRYING 1. Never fill chip pans more than one third full with oil or f at . 2. Ne ver leave oil or f at unattended during the heating or cooling period. 3. Ne ver heat f at or fry with a lid on the pan. 4 . Always dr y f ood thoroughly bef ore frying, and lower it slowly into the hot oil or f at.
14 Grill TO USE THE GRILL 1. Open the grill/top oven door and place the shelf in the required position. 2. T urn the grill control knob clock wise to 4 (max) f or f ull width grilling or anticlockwise f or the half grill. 3. Slide the grill pan toward the back of the grill compartment until it stops.
15 Ovens Both ovens have a thermostat light that will illuminate until the oven has reached the set temperature . It will then switch of f and on during cooking as the thermostat maintains the temperature. Each shelf has a saf ety stop to prevent it from being pulled out too f ar when attending to f ood.
16 Note: If soft margarine is used f or cake making, temperatures recommended by the manuf acturers should be f ollowed. T emperatures recommended in this chart ref er to cakes made with block margarine only . Oven Cooking Char ts Scones Food Pre- heat Ye s 210/220 10-15 Runner 2 from bottom of oven.
17 Oven Cooking Char ts Beef / Lamb (slow roasting) Meat 170/180 35 mins per 450g (1lb) + 35 mins over . Runner 1 f rom bottom of oven. 35-40 mins per 450g (1lb) 40 mins per 450g (1lb) + 40 mins over .
The ‘S’ setting on the main oven thermostat is used f or slow cooking, keeping f ood warm and warming plates f or short periods. USING THE ‘S’ SETTING FOR SLO W COOKING 1. All dishes cooked by the ‘S’ setting should be cooked f or a minimum 6 hours.
Switch off the electricity supply and allow to cool bef ore cleaning the cook er . Clean the cooker regularly and wipe up spills soon after they occur to prevent them from becoming burnt on.
COOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate, pan supports, burner caps, roasting dish, grill pan, main oven base, inside of grill compartment Cloth wrung out in warm soapy water . Stubborn stains can be removed with a cream paste, liquid cleaner or by rubbing with fine steel wool soap pads.
PROBLEM Bef ore contacting your Service Centre or Installer , check the p roblem guide below , there may be nothing wrong with your cook er . CHECK Burner will not light: Burner ports Ignitor Hotplate burner If all burners f ail to ignite: Check that sparks appear at the burners; a clicking noise should be heard.
Cannot set an “ Auto Cook” programme or cannot get the timer to turn the oven on or off at the required times. Read the Timer instructions in this book carefully remembering that the Cook period is the length of time that the timer will switch the oven(s) on as part of an Auto Cooking Programme.
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions f or this appliance are stated on the data badge which is fitted on the back panel.
TECHNICAL DA T A Gas connection Rp 1 / 2 ( 1 / 2 " BSP f emale) Pressure test point Front left hotplate injector Gas rate adjustment None Aeration adjustment None Electrical connection 4mm 2 twin and earth 230/240V a.c. 50Hz. 13A f use. HEA T INPUT G20 at 20mbar G30 at 28-30mbar G31 at 37mbar BURNER INJECT OR 2.
65 mm Min 840 mm Min 400 mm Min 600 mm Min SP ACE FOR FIXING The cooker can be close fitted below hotplate level. This requires a minimum distance of 600mm between cupboard units of hotplate height.
UNP ACKING THE COOKER Unpack the components from inside the grill and oven: Check tha t the f ollowing parts are present. Grill pan and grid Aluminium burner bodies( 4) Pan supports Main oven shelves .
CONNEC TING TO GAS SUPPL Y Connection to the cooker should be made with an approved appliance flexible connection to BS 669. A length of 0.9 to 1.25m is recommended. The length of hose chosen should be such that when the cooker is in situ, the hose does not touch the floor .
28 Electrical Connection W arning - THIS APPLIANCE MUST BE EARTHED The cooker must be connected by a qualified electrician to a suitable double - pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm, which should be fitted adjacent to (but not above) the cooker , in accordance with IEE regulations.
OPERA TIONAL CHECKS Aft er installation, check f or gas soundness. The supply pressure can be checked at one of the hotplate burner injectors. Check that the hotplate burners ignite correctly and burn with a steady flame. Check f or a steady flame at the low setting.
.
.
PRINTED BY SIMLEX . FOUR ASHES, WOL VERHAMPTON. 07/2006 Part no. 195057560.00 Indesit Company UK Limited, Morley W ay , Peterborough, PE2 9JB K e y Contacts After Sales Service Over 1100 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we off e r .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Hotpoint EG74 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Hotpoint EG74 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Hotpoint EG74, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Hotpoint EG74 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Hotpoint EG74, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Hotpoint EG74.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Hotpoint EG74. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Hotpoint EG74 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
