Manuel d'utilisation / d'entretien du produit P1225LGRL 527.25155 du fabricant ESCALADE
Aller à la page of 16
OWNER'S MANUAL CHAMPION 8 FT. DROP POCKET POOL TABLE MODEL NO. P]225LGRL 527.25155 MODEL NO. P]227LGRLA 527.25165 1. READ THIS MANUAL CAREFULLY BEFORE STARTING ASSEMBLY. Read each step completely before beginning each step. 2. SOME SMALLER PARTSMAY BE SHIPPED INSIDE LARGER PARTS.
CAUTION THE SPRAY ADHESIVE USED FOR APPLYING PLAYFIELD CLOTH IS EXTREMELY FLAMMABLE AND UNDER PRESSURE! CAREFULLY READ CAUTIONS ON SPRAY ADHESIVE CONTAINER! KEEP OUT OF THE REACH OF CHILDREN! DO NOT USE OR STORE NEAR HEAT SOURCE ! FLAMES ! SPARKS OR WHEN SMOKING! WORK AREA MUST BE WELL VENTILATED.
ASSEMBLE TWO LEG PEDESTALS AS FOLLOWS: 1. Begin by opening hardware kits and sod hardware. Remove the mounting plate from one leveler #22 and attach it to bottom of left leg # 19 using two screws #27 and two dowel connectors #26. Cover holes with adhesive hole covers #28.
40 5O 15 WARNING Holes marked by arrows MUST be on the TOP when attached to leg pedestals. 4O 5o 5. Attach beam # 15 by using four bolts #40, eight washers #50, and four tocknuts #49 for each of the leg mounting location. Place one washer between the bolts and beam and one between leg posts and tocknuts.
NOTE: Screwheads should be flush with or below the top of the slats #16 and #17. 15 16 Detail A ,8 H 36 Slot should be straight up and down Hole for dowel connector #36 is closer to the top of beam. 9. Place long slats #16 (50 inches long) and short slats # 17 (36 inches long) across table from beam to beam as shown in figure 6.
LEVELING BASE FRAME 11. Using a carpenter's level, level table as well as possible. It is easier to do it now rather than after the slate is on frame.
¢AUTION: Be sure that the side of the play surface with the _oles faces up. 16 17 DETERMINE THE TOP SIDE OF THE PLAY SURFACE! IMPORTANT: Be sure countersunk holes in all three 17. table top sections #9 and # 10 face up: See Figure 10. NOTE: Slatron tables have "match" Iine markings like those shown above (letters A, B, C).
SHIMMING INSTRUCTIONS General Rules • Accomplish the leveling of slate with as few shims as possible. • Slate is brittle. Do not tap with a hammer or tiqhten screws unreasonable tight. You will not be abqe to compress the slate. You must shim up the slate to level.
WARNING: Applying the cloth First Glue ] Application 22. Make sure slate/slatron is dry and free of dust. NOTE: Before spraying adhesive, cut a podion of the shipping cation to use as a shield to prevent cement overspray. 23. Place cloth over slate/slatron with equal overhang on all sides.
Slate Look along the front edge of the side rails to be sure they align. Side rails must be in a straight line with each other, 4 --_-lb- I This view is shown without side and corner caps installed to help I | identify the rails. Side caps must be installed before the rails are attached I to slate.
38. 39. AlCach end aprons # 12 to recessed area on the underneath side of the end rails (#4). CENTER THE APRONS WITHIN THE LENGTH OF THE RAILS. Hold apron in place and spot the location of the mounting holes on the rails. Punch pilot holes in rail using an awl (or 8d nail) and hammer.
41. Before attaching the drop pockets to the rails you will need to tri m two of them to fit into the side pockets. (See figure 25) Inserhhe corner and side drop pockets (the two that you have trimmed) into the drop pocket openings on the table. THE LIP ON THE POCKETS GO INTO THE RECESSED AREA ALONG THE INSIDE RIM OF THE CORNERAND SIDE CAPS.
ONE YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE ® SPORTS Product (hereinafter referred as the "Producf_). WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of one (1) year from the original purchase.
! I_q_ 1 2 3 4 5 6 7 8 9 lO 822-3 2A-4049-57 2A-4050-57 2A-4051-57 5A-6827-00 3M-6522-00 3M-6523-00 3M-6546-00 809-551 2W-6029-00 809-552 2W-6030-00 1 I 2A-6508-07 12 2A-6509-07 13 3A-6007-00 14 Q-600.
18 17. 36 NOTE: Not all parts are shown. Also see page 16. 10 17 3 _9 o ...... 50 50 49.
8_ r_ i C>. oo C_ Q Q 45 NOTE: Not all parts are shown. Also see page 15. 26 21 20 45.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté ESCALADE P1225LGRL 527.25155 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du ESCALADE P1225LGRL 527.25155 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation ESCALADE P1225LGRL 527.25155, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le ESCALADE P1225LGRL 527.25155 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le ESCALADE P1225LGRL 527.25155, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du ESCALADE P1225LGRL 527.25155.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le ESCALADE P1225LGRL 527.25155. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei ESCALADE P1225LGRL 527.25155 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
