Manuel d'utilisation / d'entretien du produit 42 du fabricant Electrolux
Aller à la page of 44
www .ElectroluxUSA.com R efr igerators Electr olux ICON ™ Built-In Side by Side D A99-00689C REV(0.0) La section française commence à la page 45 Réfrigérateurs Electrolux Icon Côte à Côte Mod.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions 2 IMPORT ANT SAFETY INFORMA TION. READ ALL INSTRUCTIONS BEFORE USING. W ARNING! Use this appliance only for its intended purpose as described in this Owner’ s Manual.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions ElectroluxUSA.com PROPER DISPOSAL OF THE REFRIGERA TOR Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous…even if they will sit for “just a few days.
4 Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions IMPORT ANT SAFETY INFORMA TION. READ ALL INSTRUCTIONS BEFORE USING. W ARNING! HOW TO CONNECT ELECTRICITY Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions About the temperature controls. ElectroluxUSA.com The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer compartment.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions About the water filter . (on some models) 6 Water Filter Cartridge The water filter is located in the fresh food compartment in the upper right side.
7 About the shelves and bins. ElectroluxUSA.com Refrigerator Door Bins and Freezer Door Bins All door bins, except for the deep gallon door bin and freezer bins, are adjustable and can be moved up and down to meet your storage needs. The deep gallon door bin and the freezer bins can be removed for cleaning.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions 8 About the refrigerator doors. Refrigerator Doors The refrigerator doors may feel different than the ones you are used to. The special door opening/closing feature makes sure the doors close all the way and are securely sealed.
About the drawers and baskets. ElectroluxUSA.com 9 Not all features are on all models. Fruit and V egetable Drawers Excess water that may accumulate in the bottom of the drawers should be wiped dry . Adjustable Humidity Drawers Slide the control all the way to the HI setting to provide high humidity recommended for most vegetables.
About the ice and water dispenser and automatic icemaker . Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions 10 Ice Storage Bin T o remove: Lift up the access door to reach the icemaker . Set the icemaker power switch to the O (off) position.
11 About the ice and water dispenser . ElectroluxUSA.com T o Use the Dispenser Select Cubed Ice , Crushed Ice , or Water . Press the glass gently against the middle of the dispenser pad. The spill shelf is not self-draining. T o reduce water spotting, the shelf and its grille should be cleaned regularly .
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions 12 Cleaning the Outside The spill shelf and the area beneath it should be cleaned periodically with a mild liquid dish detergent. Dispenser pad.
13 For long vacations or absences, remove food and unplug the refrigerator . Clean the interior with a baking soda solution of one tablespoon (15 ml) of baking soda to one quart (1 liter) of water . Leave the doors open. Set the icemaker power switch to the O (off) position and shut off the water supply to the refrigerator .
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions 14 Replacing the light bulbs. Setting the controls to OFF does not remove power to the light circuit. Refrigerator Compartment—Upper Light Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool.
Installation Instructions Built-In Side-By-Side Refrigerators If you have questions, call 1-877-4ELECTROLUX 877-435-3287 or visit our website at: BEFORE YOU BEGIN Read these instructions completely and carefully . • IMPOR T ANT — Observe all governing codes and ordinances.
Installation Instructions 16 HARDW ARE SUPPLIED • Anti-T ip brackets Anti-T ip Brackets MA TERIALS REQUIRED • 36 ″ long, 2 ″ x 4 ″ wood block for Anti-T ip bracket installation • #12 or #14 wood screws for Anti-T ip bracket • Screws to secure refrigerator to cabinets • 1/4 ″ O.
THE INST ALLA TION SP ACE Water and Electrical Locations The opening must be prepared with the electrical and water supply located as shown. The cutout depth must be 24 ″ The refrigerator will project forward, slightly beyond adjacent cabinets, depending on your installation.
1/2" 1" 3/4" Custom Panel (Nominal Size) 1/4" 1/2" 3/4" 2" 1-1/4" 1-1/2" 1-3/4" 3" 2-1/4" 2-1/2" 2-3/4" 1/4" 1/2" 3/4&qu.
1/2" 1/4" 1/2" 3/4" 1" 1-1/4" 1-1/2" 23-7/8" From Rear of Refrigerator 3/4" Custom Panel (Nominal Size) Case T rim Refrigerator Fresh Food Door Backer Pane.
CUSTOMIZA TION BASICS: Stainless Steel Wrapped Models Stainless Steel Wrapped Refrigerators Stainless Steel wrapped refrigerators have wrapped doors and grille panels, and beveled edges.
1/4 ″ FRAMED P ANEL DIMENSIONS If you choose to install framed panels, they must be cut to the dimensions shown. The panels will slide into the frame on the door and grille. IMPORT ANT NOTE: Maximum weight for Fresh Food panel is 70 pounds and 30 pounds total for Freezer panels.
3/4 ″ FRAMED CUSTOM P ANEL OPTION For a more custom appearance, 3/4 ″ framed custom panels may be installed on trimmed models. The overlay panel is secured to a 1/4 ″ finished backer panel. The assembled custom panel then slides into the trim with the same procedure described on page 33.
3/8" 3-1/8" 5/16" 1" Thick Max. or 3/4" Plus 1/4" Backer B 2-1/2" 3-1/8" Min. 1/4" Max. A 5/16" Required for Optimal Handle Clearance 3/4 ″ FRAMED CUSTOM WOOD P ANELS Secured to a 1/4 ″ finished backer panel.
2-1/2" 3-1/8" Min. 1/4" Max. Required for Optimal Handle Clearance 3/8" 3-1/8" 1" Thick Max. or 3/4" Plus 1/4" Backer 5/16" A 5/16" B 3/8" 1" Thick Max. or 3/4" Plus 1/4" Backer 5/16" 5/16" 3-1/8" A B 1" Thick Max.
1/4" Max. Required for Optimal Handle Clearance 3-1/8" 2-1/2" 3-1/8" Min. B A 3/4 ″ FULL-WIDTH OVERLA Y CUSTOM P ANELS This panel design provides a nearly trimless appearance. Assemble the spacer panel onto the finished backer panel.
3-1/8" Min. 1/4" Max. Required for Optimal Handle Clearance 3-1/8" 3-1/8" 5/16" 5/16" A B A B A B 2-1/2" 3/4 ″ FULL-WIDTH OVERLA Y CUSTOM P ANELS This panel design provides a nearly trimless appearance. Assemble the spacer panel onto the backer panel.
GROUNDING THE REFRIGERA TOR IMPORT ANT — Please read carefully FOR PERSONAL SAFETY , THIS APPLIANCE MUST BE PROPERL Y GROUNDED. The power supply cord of this appliance is equipped with a three-prong.
1 REMOVE P ACKAGING CAUTION: Refrigerator is T op-Heavy —be careful when moving. When using an appliance dolly , handle from Freezer side only . • Carefully cut banding at the top and bottom; remove outer carton. • Slide out rear corner posts (2).
2 INST ALL W A TER LINE • A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120 psi. • Route 1/4 ″ O.D. copper tubing between cold water line and the water connection location. • T ubing should be long enough to extend to the front of the refrigerator .
3 INST ALL SIDE P ANELS SKIP THIS STEP WHEN NOT USING SIDE P ANELS If you are using 1/4" side panels, they should be inserted into the case trim. Fasten the panels to the refrigerator with the 3M Dual Lock adhesive strips before setting refrigerator in place.
7 LEVEL REFRIGERA TOR All models have 4-point leveling. The front and back are supported by leveling legs. Both are accessible from the front of the refrigerator . • T o level the back of the refrigerator , turn the 1/2 ″ hex nut located above the front wheels.
10 INST ALL GRILLE P ANEL • Raise the grille panel to the stop position. • Remove 4 screws on bottom trim; retain all screws. • Remove bottom trim. • NOTE: Stainless steel and acrylic panels are covered with a protective film. Remove the film before installing the panel.
11A Install 1/4 ″ Decorative Panels: • Remove Handles Open door to 90°. Remove 5 Phillips head screws from the Fresh Food and Freezer door handles; retain all screws. Lift off door handles. • Install Door Panels NOTE: Stainless steel and acrylic panels are covered with a protective film.
11B 1. Remove handles from cartoning and any other protective packaging. 2. Place handle over pre-installed shoulder bolts (A) that are fastened into door in four locations. 3. While supporting handle and looking at upper end cap, fasten top-most allen set screw (B) with supplied allen wrench, then fasten bottom allen set screw (C).
13 TURN ON THE POWER • Set the Master Power switch to the I (ON) position. • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. • The temperature controls are preset at 37° for the Fresh Food section and 0° for the Freezer section.
16 DOOR ALIGNMENT • Stand back from the refrigerator to inspect the door alignment. • Shipping or the addition of heavy door panels may have caused the doors to move slightly out of alignment. • If necessary , the Fresh Food door may be adjusted up or down to align with the Freezer door .
37 Normal operating sounds. Newer refrigerators sound different from older refrigerators. Modern refrigerators have more features and use newer technology . HUMMM... WHOOSH... ■ The new high efficiency compressor may run faster and longer than your old refrigerator and you may hear a high-pitched hum or pulsating sound while it is operating.
Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions T roubleshooting tips… ElectroluxUSA.com T roubleshooting T ips Save time and money! Review the charts on the following pages first and you may not need to call for service.
T roubleshooting tips… Problem Possible Causes What T o Do Frequent “buzzing” sound Icemaker power switch is in the • Set the power switch to the O (off) position. Keeping it I (on) position, but the water supply in the I (on) position will damage the water valve.
ElectroluxUSA.com 40 Problem Possible Causes What T o Do Orange glow in Defrost heater is on. • This is normal. the freezer Refrigerator has odor Foods transmitting • Foods with strong odors should be tightly wrapped. odor to refrigerator . • Keep an open box of baking soda in the refrigerator; replace every three months.
40 TERMS AND CONDITIONS: This warranty applies only for single family domestic use in Canada when the Refrigerator has been properly installed according to the instructions supplied by Camco and is connected to an adequate and proper utility service.
42 W arranty Information ElectroluxUSA.com Consumer Support T roubleshooting T ips Operating Instructions Safety Instructions Installation Instructions.
43.
State of California Department of H ealth Services Water Treatment Device Certificate Number 01 - 1474 Date Issued: April 25, 2001 Replacement Elements Frigidaire PureSource 2 NGFC-2000 FC-100 Gibson .
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Electrolux 42 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Electrolux 42 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Electrolux 42, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Electrolux 42 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Electrolux 42, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Electrolux 42.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Electrolux 42. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Electrolux 42 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
