Manuel d'utilisation / d'entretien du produit KDW 3 du fabricant AEG
Aller à la page of 40
KDW 3 Dishwasher User Instructions.
2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions ! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance.
Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . .
Contents 4 Installation and Connection Instructions . . . . . . . . . . . . . . . . 30 Installing the Dishwasher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Dishwashers That Can Be Integrated . . . . . . . . . . . .
Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accept ed technical standards and the German Appliance Sa fety Law.
Operating Instructions 6 • Never place the dishwasher in operation if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible.
Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly.
Operating Instructions 8 Appliance Features and Control Panel Spray Arms Container for Salt Rating Plate Container for Rinse Aid Detergent Dispenser Filters Top Spray Nozzle Rubber Seal fo r Connectin.
Operating Instructions 9 Control panel The Control Field comprises the ON/OFF switch M and the prog ramme buttons with LED indicators. Softener and Functi on Button: in addition to the wash program marked, it is also possible to adjust the dishwasher's water softener using the combination of these buttons.
Operating Instructions 10 Adjust the Water Softener To avoid the scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content, water. The dish- washer therefore has a built-in water softener, in which tap water from a hardn ess of 4 ° d (German degree) is softened with the aid of special salt.
Operating Instructions 11 5. Pressing the water sof tener button increases the hardness setting by 1. (Exception: hardness setting 0 follows hardness setting 9). 6. When the hardness setting is correct, press the ON/OFF switch M . The hardness setting is then saved.
Operating Instructions 12 7. If you are not going to wash your dishes immediately, you should run the Pre Wash programme A . This will wash away salt water that has run out of the container and any grains of salt that have been spilt.
Operating Instructions 13 3. Fill with rinse aid, up to the broken line (maximum); this line corresponds to a quantity of approx. 150 ml 4. Replace the lid and tighten by turn- ing clockwise. 5. If rinse aid has been spilt, wipe up with a cloth. Otherwise there will be foaming during the washing.
Operating Instructions 14 In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable .
Operating Instructions 15 – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery 1 Long bladed knives stored in an upright position are a potential haz- ard. 1 Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper bas- ket.
Operating Instructions 16 L o a d i n g Pa n s, F r y i n g Pa n s and Lar ge Plates Load lar ge and heavily soiled dishes in the lower r ack. 3 To ease the loading of large items at some dish washer-m odels the two rows of prongs for the right-hand plate insert can be folded down: 0 1.
Operating Instructions 17 Loading Cups , Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arr ange items of crockery on the folding cups ra cks so that they ar e offset from each other and water can reach all items.
Operating Instructions 18 Adjusting the Height of the Upper Rack 3 The height of the rack can also be adjusted when the rack is loaded. Lowering the Upper Rack: 0 1. Pull out the upper rack to the stop. 2. Lift the upper rack at the rear right and lower.
Operating Instructions 19 Filling with Detergent 1 Use only dishwasher detergent. Fill with Detergent: – Prior to the start of a wash programme (not for the Pre Wash pro- gramme).
Operating Instructions 20 Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes.
Operating Instructions 21 Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: 1) During BIO progra mmes the wash water is briefly heated to 60 ° C, so that the active oxygen can become effective.
Operating Instructions 22 Start the Wash Programme 0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the On/Off button M . The On/Off button M indicator illumi- nates.
Operating Instructions 23 Interrupting the wash programme by opening the door of the dishwasher 1 Hot steam may escape from the appliance when opening the door. Open the door carefully. 0 1. Open the door of the dishwasher. The wash programme stops. 2.
Operating Instructions 24 Switching Off the Dishwasher Switch off the dishwasher when L is illuminated on the programme progress display. 0 1. Press the ON/OFF button M . The ON/OFF button M indicator extin- guishes. 1 Hot steam may escape from the appliance when opening the door immediately after the end of the programme.
Operating Instructions 25 Cleaning the Filter 3 The filters should be checked and cleaned regularly. Blocked filters will give poor wash results. 0 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter.
Operating Instructions 26 What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
Operating Instructions 27 ...there are problems with the operation of the dish- washer. ...the wash results are n ot satisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were loaded is such a way that the wash waster did not reach all items.
Operating Instructions 28 There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosi ng. – The detergent may be the cause. Contact the detergent manufac- turer ’ s customer advisor.
Operating Instructions 29 Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test.
Installation and Conn ection Instructio ns 30 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level.
Installation and Connectio n Instructions 31 • Depending on type, the dishwasher is to be installed as follows: Dishwashers That Can Be Integrated (see installation template supplied) 3 The door of .
Installation and Conn ection Instructio ns 32 • If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows: – Unscrew the screws (1) from the elbows on the back side.
Installation and Connectio n Instructions 33 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the return of wash water into the drinking water system and comply with the appli- cable plumbing regulations.
Installation and Conn ection Instructio ns 34 Water drain Drain hose 1 The drain hose must not be kinked, crushed or ent angled. • Connecting th e drain hose: – Maximum permit ted height: 1 metre. – Minimum required height 30 cm above the lower edg e of the machine.
Installation and Connectio n Instructions 35 Leak Pr evention System For protection fr om damage due to water leaks, the dishwasher is equipped with a leak pr evention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on.
Installation and Conn ection Instructio ns 36 • The wire coloured green and yellow must be connected to the termi- nal marked with the letter “ E “ or by the earth symbol or coloured green and yellow. • The wire coloured blue must be connected to the terminal “ N “ or col- oured black.
Installation and Connectio n Instructions 37 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation.
Guarantee Conditions 38 GUARANTEE CONDITIONS Guarantee Conditions AEG offer the follow ing guar antee to the fir st purchaser of this a ppliance. 1. The guar antee is valid for 12 months commencing when the appliance is handed over to the first r etail purchaser , which must be verified by purchase inv oice or similar docu- mentation.
Service & Spare parts 39 SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area.
AEG Hausger ä te Gm bH P ostfach 1 036 D-90327 N ü rnber g http://www .aeg.hausger aete.de © Copyright by AEG 822 945 7 13 - 00 - 0600.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté AEG KDW 3 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du AEG KDW 3 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation AEG KDW 3, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le AEG KDW 3 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le AEG KDW 3, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du AEG KDW 3.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le AEG KDW 3. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei AEG KDW 3 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
