Manuel d'utilisation / d'entretien du produit HE60R du fabricant Chamberlain
Aller à la page of 16
Installation and operating instructions for HomEntry garage door opener Model HE60R Chamberlain Australia Pty Ltd Phone toll free 1800 638 234 Fax toll free 1800 888 121 Chamberlain New Zealand Ltd Phone toll free 0800 637 546 Fax toll free: 0800 653 663 www .
.
The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door .
T ools Required 2 1. Ladder (or similar device to safely support door weight) 2. Adjustable wrench for U-bolts already installed on the door 3. 8mm socket, 10mm socket and 13mm extended socket and socket wrench 4. 30mm socket extension (for minimum sideroom installations) 5.
3 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required.
T esting the door Disable all locks and remove any ropes connected to the garage door . Complete the following test to ensure your door is well balanced, and not sticking or binding: • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring.
5 Preparing the Opener 7 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. • Pull the release cord down and across to engage the ball into the cup. The drive forks should now be able to be moved manually .
6 Installation steps 8 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 7, page 5) • Ensure that the opener position jumper (wire connector) is installed (refer Section 7, page 5). • Place the opener in manual release mode (refer Section 7, page 5). • Open the roller door fully .
Pinning the Door 11 Use two metal self tapping metal screws provided to hold the curtain to the door drum. Note: A ballooning may delay the safety response and can compromise your garage door security . • Pull the release cord down Firmly to disengage the motor .
Setting the Limits The T ravel Limits regulate the points at which the door will stop when moving UP or DOWN. During the SetUp procedure, the motor will run and operate the door . The Opener must be fully installed on the door and all installation steps completed before proceeding.
Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed. See Section 16. The force setting regulates the amount of power required to open and close the door .
10 Install the Protector System™ (Safety Beams) Install this accessory for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). After opener has been installed and adjusted, The Protector System™ accessory can be installed.
CARE OF YOUR OPENER When properly installed, your opener will provide high performance with minimal maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed.
12 Troubleshooting 1. The opener doesn't operate from either the GREEN start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1.
13 OPERA TION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door starts to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories).
Liability – Australia only Under no circumstances shall the Seller be liable for consequential, incidental or special damages arising in connection with the use, or inability to use, the Unit.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Chamberlain HE60R c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Chamberlain HE60R - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Chamberlain HE60R, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Chamberlain HE60R va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Chamberlain HE60R, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Chamberlain HE60R.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Chamberlain HE60R. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Chamberlain HE60R ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
