Manuel d'utilisation / d'entretien du produit CI560 du fabricant CDA
Aller à la page of 24
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .
2 User Information The room must be adequately ventilated to avoid the back - flow of gases into the room from appliances burning gas or any other fuels.
3 cleaning fluid, petrol, cooking oil, fat, hair lacquer or other flammable substances in the tumble dryer . • Attempt to dry dripping wet articles. • Dry unwashed items in the tumble dryer . • Dry wool or wool mixture articles unless the article is labelled as suitable.
4 Important This appliance must only be used for the purpose for which it is intended, i.e. domestic use . Any other use could be dangerous and may lead to premature failure of the appliance. The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product.
5 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directives 2006/95/ EEC, 2014/35/EU (L ow voltage) and requirements of EMC Directives 2004/108/EEC, 2014/30/EU .
6 Before First Use Open the control panel door , remove the water bottle and then replace it in position ensuring that it is pushed in firmly . Open the dryer door and push the filter into its operating position. R emove any dust by wiping the drum and door with a damp cloth.
7 C Display The display shows the programme number or drying time when programme 9 is selected. D Plus button The plus button increases the programme number or programme time. E Start button The start button starts the programme. F Activate button The activate button should be pressed to power on the dryer .
8 Programme Chart Programmes “1”-”7” and “9” can be operated on either full heat or half heat setting and include a 12 minute cool-down period at the end of the cycle. Programme “8” operates without the heater (regardless of the heat switch setting), circulating air through the dryer at the ambient temperature.
9 Delay start The dryer is equipped with a variable delay start timer of up to 9 hours duration at hourly intervals. T o set the delay timer , first select the programme, heat setting and required duration (if applicable) and then press the “Delay Timer” button.
10 T o Run a Programme For energy labelling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and set the timer to the recommended drying time for cotton dry as specified on the control panel. The standard cotton programme is suitable to dry normal wet cotton laundry .
11 • Press the “ Activate” button. The display will illuminate. The dryer will automatically remember the programme and heat setting last used. T o change the programme use the “-” or “+” buttons on either side of the display window .
12 Should the clothes dry before the cycle has finished the thermostat will automatically switch o the heater to prevent over drying and save energy , although the drum will still rotate. When drying large items such as sheets, we suggest you stop the dryer to redistribute the load.
13 Emptying the W ater Bottle When the dryer is configured to drain to the internal water bottle, it must be emptied periodically . The warning light on the control panel will illuminate when the bottle is full. T o empty the water bottle: • Open the control panel door , remove the water bottle and empty it into a suitable drain.
14 • Firmly pull the condenser using the handle to remove it from the dryer . • Rinse between the plates under a tap or with running water to remove any lint or flu .
15 Care and Maintenance Cleaning The Filter The filter is found by opening the door (fig.3.) and must always be in position when drying items in the appliance. T o allow the dryer to operate eciently the filter should be cleaned after each drying cycle.
16 T roubleshooting If the clothes are not dry after the normal drying time: - Check that the filter is clean. A blocked filter will restrict the airflow . - Check that you used the correct heat setting and did not overload the dryer . - Check that the condenser unit and associated duct work are clean.
17 Installation This appliance is fully compatible with any 600mm deep kitchen units and complies with stringent EEC regulations. The illustration shows the minimum space required by the dryer and the position of the waste-pipe within this space and behind the dryer .
18 PLEASE NO TE: The air vent at the front of the appliance must never be covered or blocked in any way as this will impair the functioning of the appliance and could cause it to overheat.
19 Drainage Options This condenser dryer is fitted with an internal drain pump, which gives you the option of being able to drain condensed water into the water bottle, or to the household waste pipe. Connecting your dryer to the household waste pipe will remove the periodic need to empty the water bottle.
20 How to R everse the Door Open the door . 1. T urn the red switch strike 90⁰ anticlockwise and then remove it. 2. R emove the four screws on the opposite side from the door hinge. 3. Holding the door in position to prevent damage, remove the four hinge screws.
21 Electrical Information W arning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. T o change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse .
22 As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- • The wire which is coloured GREEN and YELL OW must be connected to the terminal which is marked with the letter (E) or by the Earth symbol or coloured GREEN and YELL OW .
23 E & O E. All instructions, dimensions and illustrations are provided for guidance only . CD A reserve the right to change specifications without prior notice.
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .care@cda.eu W : www .cda.eu www .cda.eu 4213 194 11983 Please contact our Customer Care Department for Service on the details below Customer Care Department The Group Ltd.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté CDA CI560 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du CDA CI560 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation CDA CI560, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le CDA CI560 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le CDA CI560, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du CDA CI560.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le CDA CI560. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei CDA CI560 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
