Manuel d'utilisation / d'entretien du produit WKD 28540 du fabricant Bosch
Aller à la page of 32
Washer-dryer en Installation and op erating instruction s.
2 Contents Keep all documents in a safe place for future reference, or to pass on to the next owner. For further information and a selection of our products, visit our website : www.bosch-h ome.com Operating instructions General safety information ...
3 General safety information Intended use The washer-dryer is designed for: – domestic use only. – machine-washable fabri cs in dete rgent solution and drying these fabri cs. – operation with cold drinking water and commercia lly available detergents and care products that are suitable for use in washing machines.
4 En vironmental protection/econom y tips – Separate out the variou s waste materials of the packaging and take them to th e neares t colle ction po int. – Always fill the washer-dryer with the maximum load for the relevant programme. – Wash normally soiled laun dry without a prewash.
5 Y our new w asher -dr y er Description of the washer -dr yer The washer-dryer can be used in 3 ways –> page 15: – washing only – drying only – successive washing and drying. The successive wash-dry programme au tomatically shifts from the wash cycle to the dry cycle without further intervention.
6 Control panel Indicator lamp Indicates the setti ngs that have been selected fo r: – Temperature: Ž - 90°C. – Spin speed: $ - 1400 rpm. – Options/signal. Display panel Shows the settings that have been selected (e.g. spin spee d, drying time), the progress of the current pr ogramme and the programme status.
7 Bef ore washing f or the first time Preparing and sor ting the laundr y The washer-dryer was tested before leav ing the factory. To remove any wate r that may be left over from the test, d o not load any laundry the firs t time that you run a wash programme.
8 Sorting laundr y for dr ying Only dry laundry that is l abelled "suitable for tumble -drying" or which has the following care symbols: Do not wash the following fabrics i n the washer-dryer : –D o n o t m a c h i n e d r y laundry with the b care symbol.
9 Detergents and Care Products Detergent dr awer The detergent drawer is d ivided into three compartments Compartment I : detergent for pre-wash. Compartment II : detergent for main wash, Compartment i : Liquid additives, such as starch or fabric softener .
10 Normally soiled laundry Set the programme. Do not select ! (Pre-wash) –> page 13. Add all the detergent, according to the manufacturer's instru ctions, to compartment II of the dete rgent drawer. Heavily soiled laundry Set the programme.
11 Programmes Programme selector The programme selector is used to set the washing and drying programmes. The time remaining until the end of the progr amme and the Beladungsmenge (Load) are sh own on the display panel. W ashing programmes* *depends on the model Resistentes/Algod.
12 W ashing programmes* * depends on the model Clinic Wash ; For washing fabric s with increas ed hygiene req uirements or those that will be used by aller gy sufferers. The temperature re mains constant during th e washing proce ss. More in tensive rinsing with incr eased water level.
13 W ashing and dr ying options °C (T emperature) button The temperature can be a djusted individually for each programme. To adjust it, press the °C (Temperatu re) button repeatedly until th e required temperature is displayed. B (Spin speed) button The spin speed can be individually adjusted for each progr amme.
14 Secar (Drying) button The drying prog rammes –> page 12 can be individua lly adapted by selecting the drying options. – Press the Secar (Drying) button repeatedly until the required drying option is shown on the dis play pa nel. – To deactivate, press th e Secar (Drying) bu tton repeatedly until is shown on the display.
15 W ashing and dr ying W ashing only Turn the programme selector to the desired programme, e.g. Resistentes/Algod. (Cottons /Coloureds) 60°C . – The display panel alternately shows 2 (Remaining time) and the recommended load in kg . The % symbol fla shes.
16 End of the programme The washing and dr ying programme s are ended automati cally. appears on the disp lay panel. Turn the programme selector to Stop . Remove the washing from the dr um. Leave the door open to allow the inside o f the washer-dryer to dr y out.
17 Cleaning and care Safety information Risk of electric shock You must disconnect the appliance fr om the mains first. Never clean the washer-dryer with a water jet. Risk of explosion. Never clean the washer-d ryer with solvents. Risk of scalding Hot washing water must be cooled before Draining.
18 Drain pump Take the Drain hose out of the retainer. Remove the plug from the Drain hose and release the was hing water. – The container for the Drained water may have to be empti ed several times. – When no more water runs out, replace the plug.
19 What t o do if... Risk of electric shock. Repairs must only be carried out by customer services or autho rised technicians. If repairs are needed, or if you cannot rectify a fault yourself wi th the help of the fo llowing table: Set the programme selector to Stop .
20 Water is not flowing in. The mains plug is not correctly plugged in. Plug in the mains plug correctly. The door is not prop erly closed. Close the door. The tap is not turned on. Turn on the tap. The filter in the wa ter supply hose is blocked. Clean the filt er in th e water supply hose –> page 18.
21 Programme terminated unexpected ly. The A ( Start/ Pause) button was selected accidentally. Press the button again to restart the programme. Spinning during drying No fault "Thermo spin", which is for energy-effi- cient drying, starts after a drying time of approx.
22 Af ter -sales ser v ice Before you call the a fter-sales service, please check whether you can cor- rect the fault yourself –> page 19. You will be charged if a techni cian is called out, even during the warranty period.
23 Installation instructions Safety information The washer-dryer is very heavy. Take care when lifting it. Do not operate the washer-dryer if it has any visible damage. If you are in any doubt, please consult our afte r-sales service or your retailer.
24 Remo ving the transpor t safety bolts Unscrew all four screws using the spanner supplied. Remove all 4 transp ort safety bolts completely and take the mains cable out of the retainers.
25 Lev elling Intense noise, vibrations and “wandering” may be the result of incorrect levelling. – All four appliance feet must stand firmly on the ground. – The washer-dryer must not wobble. – Check the levelness of the washer-dry er with a spirit level and correct if necessary.
26 W ater connection To prevent leaks or water damage, you must observe the instructions in this section. If in doubt, have a technician connect the appliance. The water supply and Dr ain hoses can be routed to the left of ri ght, depending on installation conditions.
27 Electrical connection The washer-dryer must o nly be connected to an alternati ng current supply via a properly insta lled earthed socket. If a residual current circuit breaker is used, only use a type which displays this symbol: ‚ . Only this symbol guarant ees compliance with th e cu rrently appl icable regulations.
28 T able of programmes Observe the information on care labels, fabric type and load quan tity . In order to select the most suitable programme for the l aundry, observe the information on the labels that are atta ched to most items.
29 Consumption rates W ashing Programme Load Power*** Water*** P rogramme duration* ** Resistentes/Algod. (Cottons/Coloureds) 40 °C 6 kg 0,8 kWh 60 l 1:52 h Resistentes/Algod.
30 C Care information -Drying .................................8 -Washing ..............................7 Care product ...............................9 Childproof lock ........................16 -Display panel ......................6 Cleaning -Control panel 17 -Detergent drawer .
31 H Hazard information ....................3 Hazard warnings -Detergent ............................9 Housing -Cleaning ............................17 I Included with the appliance .....23 Installation surface ...................23 Iron-damp -Drying options .
Robert Bosch Hausgerät e GmbH Carl-Wery-Straße 34 81739 München DEUTSCHLAND wkd28540ee 10.2011 9000493030.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Bosch WKD 28540 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Bosch WKD 28540 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Bosch WKD 28540, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Bosch WKD 28540 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Bosch WKD 28540, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Bosch WKD 28540.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Bosch WKD 28540. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Bosch WKD 28540 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
