Manuel d'utilisation / d'entretien du produit KR2812 du fabricant Krown Manufacturing
Aller à la page of 40
1 N E Amplified Cordless Phone Model: KR2812 USER MANUAL.
2 N E TABLE OF CONTENTS Table of Contents ........................................................................................2 Important Safety Instructions .............................. .............................. ......... 5 Safety and Care .
3 N E Call W aiting ............................................................................................... 17 Using the Phonebook .......... .............................. .............................. ..........1 8 Ad ding a Phon ebook E ntry .
4 EN Declaration of Conformity ........................................................................37 Lightning ..................... .............................. .............................. ...................38 Consumer Information ........
5 N E IMPORT ANT SAFETY INSTRUCTIONS Some of the following information may not apply to your particular product. Howeve r , when using telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1.
6 EN 13.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. 14.Never install or modify telephone wiring during a lightning storm. 15.Never install telephone jacks in wet locations unless the jack is specically designed for wet locations.
7 N E SAFETY AND CARE Observe the following safety precautions and warnings when setting up and using this product. • LCD panel – The LCD panel is made of glass, and may break if the unit is dropped.
8 N E the base unit from the phone line and the A/C power when there are storms in your area. • Do not install the base unit near a sink, bath or showe r , or anywhere it could get wet. Electrical equipment can cause serious injury if used while you are wet or standing in wate r .
9 N E • 3.6V rechargeable battery pack provides long-lasting cordless use • Up to 3 additional handsets (not supplied) can be used with the same base unit • Bright handset LCD can display inform.
10 N E PRODUCT OVERVIEW HANDSET AND BASE UNIT - FRONT VIEW 2 1 3 4 16 14 15 13 17 18 19 20 21 22 23 5 6 7 8 9 10 1 1 12 1. Visual ringer alert 2. Receiver 3. Emergency number memory Fire / Police / Ambulance 4. T alk: answer and end calls 5. Redial / Pause 6.
1 1 EN HANDSET AND BASE UNIT - BACK VIEW 1. Detachable belt clip 2. Battery compartment 3. Jacks for telephone and auxiliary lines 4. Ringer On / Off 5.
12 N E INST ALLING HANDSET BA TTERIES GETTING ST ARTED CONNECTING A/C ADAPTOR / PHONE LINE Plug one end of the telephone line cord into the T el. Line jack on the back of the base and the other end into a phone jack. Plug the adaptor into the jack on the back of the base and the other end of the adaptor into the electrical outlet.
13 N E • Rechargeable Nickel-Cadmium batteries must be recycled or disposed of properly . • Keep batteries out of the reach of children. • Remove batteries if storing over 30 days.
14 EN W ALL-MOUNT THE BASE UNIT INITIALIZA TION AND ST ANDBY MODE After inserting the battery (handset) and A/C power (base unit), both go to standby mode directly . All previously saved settings are kept. During normal operation, the handset’s display shows handset name / time and the base unit LED is off.
15 N E USING HANDSET KEYS Characters are entered by pressing the 0…9, * and # keys. A consecutive press of the same key will enter a different character according to the table below: Key Character versus key press numbers 1 2 3 4 5 6 1 space 1 , .
16 EN RECEIVING / ENDING CALLS When the base unit receives a call, the handset rings immediately . If there is no Caller ID available, the LCD displays “EXTERNAL CALL”.
17 N E ADJUSTING TONE Adjusting the tone can help make a conversation be heard more clearly . During a call, press T one to toggle between low , normal, medium and high tone levels.
18 N E Flash again. If another handset is engaged in a call, the message, “EX T IN USE” will be displayed . The phonebook can store up to 99 phone numbers up to 24 digits each and names (up to 14 characters). 1. T o enter the phonebook and view stored numbers, press PHBK .
19 EN Pre ss 0…9 and *,# to enter a phonebook name, repeatedly pressing the keys until the desired character appears. W ait for 1 second or press a different key to input a new character . Repeat until the name is entered. 3. Press MENU to conrm the name entry .
20 EN 1. While viewing the phonebook, press / to alphabetically search and select the entry you wish to call. OR, press 2…9 corresponding to the rst letter of the entry and use / to select the name you are seeking, e.g., for names beginning with “R” press 7 three times.
21 EN 2. Press / to review other entries in the following order: , , , M1, M2. 3. Press T alk to dial the selected stored number . 4. Press DEL to return to standby mode. If there is no key pressed after a few seconds, the unit automatically returns to standby mode.
22 EN Private name (“P”): Out of area name (“O”): When the call is accepted, the display changes depending on the type of call. If the unit times out before a new Caller ID is received during a call conversation, the display returns to talk mode.
23 N E NOTE: The number on the right side of the display’s first line shows the call log number – “ 1” is the last received call . The firs t (o ldes t) call is the cal l lo g nu mber 1. Incoming calls are sorted by the order of arrival; the oldest is shown first.
24 EN It is possible to change the number format in the call log before storing the name / number . While viewing the Caller ID list, press Format to change the number format . The available number formats depend on the received number . The table below shows the possible selections and the order in which they appear .
25 N E 1. When reviewing a call log, press MENU to enter the call log menu and select the sub-menu item “DELETE ALL?” to delete all Caller ID entries. 2. “DELETE?” appears onscreen. Use MENU to confirm deletion of all Caller ID records OR press any other key to cancel the operation and return to call log review .
26 EN 3. Once the second handset answers the call, press T alk on the rst handset to end its connection. The second handset will be engaged in the external call. NOTE: When transferring a call, the rst handset must wait for the other handset to answer before pressing T alk to complete the transfer .
27 EN 1. In standby mode, press MENU to enter the handset menu. 2. Use / to select the menu. > appears beside a menu to indicate that it is being selected. 3. Press MENU to enter the selected menu option and use / to navigate the menu options, then press MENU again to conrm and exit to the previous menu.
28 N E T o adjust ring volume: There are 5 di fferent ring volume levels available, with “ 1” being the lowest and “5” the highest ring volume. The selected ring volume is played once . TIP: Y ou may control whether the ringer is on / off by adjusting the handset Ringer On / Off or base unit Ringer Hi-Low-Off switch.
29 N E T o adjust clock: 1. On the numeric keypad, press 0...9 to enter the clock time sequentially from left (hours) to right (minutes) using / . 2. Press # to toggle between AM / PM if the time format is 12-hour format. T o set the alarm: 1. Use / to select between alarm On / Off.
30 N E T o set the area code: An area code generally identifies a geographic area and appears onscreen when the Caller ID number is displayed during call reception and Caller ID list vie w . If no area code is set, the display will show “—-”. Press 0…9 to enter the 3-digit area code sequentiall y .
31 N E on the numeric keypad to select between key tone On / Off. T o set auto answer: When auto answer is activated, the unit connects to internal / exter nal calls automatically once the handset is picked up from the base unit. There is no need to press T alk .
32 N E SECU RITY SETT ING / RE GIS TERI NG ADDI TION AL HAND SETS T o set programmable handset name: Programming a name into your handset allows you to identify and di fferentiate it from other handsets. Similar to keying in phonebook name characters, use any numeric key to change the handset name.
33 EN T o de-register the handset: 1. Use / to select handset number for de- registeration. 2. Press MENU to conrm. If de-registration is successful “SUCCESS” appears on the LCD screen, otherwise “RETRY” appears. Press MENU to retry or DEL to return to the previous menu.
34 EN Set Default No Y es The phone can be reset to its factory default settings at any time. The default settings are: DEF AUL T SETTINGS SET TIN G DEF AUL T V ALUE Language English Internal / extern.
35 N E See below for some common problems and their remedies. Whatever the problem, you should first check: • The base unit is connected to the power supply and phone line. • The main power is switched on at the A/C outlet. • The handset battery is installed and has not run out of power .
36 EN SPECIFICA TIONS TYPE DESCRIPTION Handset dimensions 41.5 mm (W) x 184.7 mm (L) x 54.2 mm (D) Handset weight 0.171 kg (without battery) Base unit dimensions 126.6 mm (W) x 122 mm (L) x 73 mm (D) Base unit weight 0.186 kg Standard W orldwide Digital Cordless T elecommunications (WDCT) Communication range Up to 300 meters (approx.
37 EN Privacy of communications may not be ensured when using the phone. W ARNING: Changes or modications to this unit not expressly approved by the party responsible for compliance void the user warranty . NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
38 EN following two conditions: 1. This device may not cause harmful interference. 2. This devi ce mus t acce pt any inter ferenc e rece ived, includ ing in terfer ence that may cause undesired operation. Y our telephone has built-in lightning protection to reduce the risk of damage from surges in telephone line and power line current.
39 N E by N/A are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.] If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required.
40 EN all other warranties, expressed or implied, including any implied warranty of merchantability or tness and of any obligation on the part of Krown Manufacturing, Inc.
Un point important après l'achat de l'appareil (ou même avant l'achat) est de lire le manuel d'utilisation. Nous devons le faire pour quelques raisons simples:
Si vous n'avez pas encore acheté Krown Manufacturing KR2812 c'est un bon moment pour vous familiariser avec les données de base sur le produit. Consulter d'abord les pages initiales du manuel d'utilisation, que vous trouverez ci-dessus. Vous devriez y trouver les données techniques les plus importants du Krown Manufacturing KR2812 - de cette manière, vous pouvez vérifier si l'équipement répond à vos besoins. Explorant les pages suivantes du manuel d'utilisation Krown Manufacturing KR2812, vous apprendrez toutes les caractéristiques du produit et des informations sur son fonctionnement. Les informations sur le Krown Manufacturing KR2812 va certainement vous aider à prendre une décision concernant l'achat.
Dans une situation où vous avez déjà le Krown Manufacturing KR2812, mais vous avez pas encore lu le manuel d'utilisation, vous devez le faire pour les raisons décrites ci-dessus,. Vous saurez alors si vous avez correctement utilisé les fonctions disponibles, et si vous avez commis des erreurs qui peuvent réduire la durée de vie du Krown Manufacturing KR2812.
Cependant, l'un des rôles les plus importants pour l'utilisateur joués par les manuels d'utilisateur est d'aider à résoudre les problèmes concernant le Krown Manufacturing KR2812. Presque toujours, vous y trouverez Troubleshooting, soit les pannes et les défaillances les plus fréquentes de l'apparei Krown Manufacturing KR2812 ainsi que les instructions sur la façon de les résoudre. Même si vous ne parvenez pas à résoudre le problème, le manuel d‘utilisation va vous montrer le chemin d'une nouvelle procédure – le contact avec le centre de service à la clientèle ou le service le plus proche.
